ROULE ELECTRONICS RL-0313B PIR MOTION LIGHT & Alarm User Manual

User Manual

PIR Motion Light & Alarm User Manual

1. Open the back cover, Insert four pcs AA Battery, then

close the back cover

2. Switch the switch on the offside to Alarm+Light or Light,

then fix the device in the place where need guard against

theft or need lighting. Note the height which is less than 1.8m

and adjust it to the proper angle.

3. When it is in the status of guarding against theft: Switch

the switch to Alarm+Light, press ON the remote control, you

can hear one prompt tone, at this time, the device is in the

garrison status, if someone enter into this zone after 60

seconds, the device will make alarm and shine the red light

after 10 seconds;

When it is in the status of lighting, it will be not controlled

by the remote control, if the light is below the set value,

someone enter into this zone, the device will emit bright

light.

4. Press off the remote control, you can hear two prompt

tone, the device will be in the status of removing the alarm.

FCC ID: YI6RL-0313B

IMPORTANT REGULATORY INFORMATION

This device complies with Part 15 of the FCC Rules:

Operation is subject to the following two conditions: 1. This

device may not cause harmful interference and 2. This

device must accept any interference that is received,

including any interference that may cause undesired

operation.

WARNING: Changes or modifications to this unit not

expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipments.