RSI VIDEOTECHNOLOGIES DC00 Door and Window Contact User Manual

RSI VIDEOTECHNOLOGIES Door and Window Contact

Contents

User Manual

(EN) Security notes / (FR) Notes de sécurité / (DE) Hinweise zur Sicherheit
English
Français
Deutsch
Remove battery before any
maintenance!
WARNING, there is a risk of
explosion if a battery is replaced by
an incorrect type!
Observe polarity when setting up
the batteries!
Do not throw used batteries! Bring
them to your installer or a collection
point.
Retirez les piles avant toute
opération de maintenance !
Attention ! Il y a un risque
d'explosion si l'une des piles
utilisées est remplacée par une pile
de type incorrect !
Respectez la polarité lors de la mise
en place des piles !
Ne jetez pas les piles usagées !
Ramenez-les à votre installateur ou
à un point de collecte spécialisé.
Batterien vor jeglichen
Wartungsarbeiten entfernen!
Vorsicht, es besteht
Explosionsgefahr, wenn eine
Batterie durch eine Batterie falschen
Typs ersetzt wird!
Achten Sie beim Einsetzen der
Batterien auf die Polung!
Entsorgen Sie Batterien nicht im
normalen Haushaltsmüll! Bringen
Sie Ihre verbrauchten Batterien zu
den öffentlichen Sammelstellen.
FCC Regulatory Information for USA and CANADA
FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI VideoTechnologies may void the
FCC authorization to operate this equipment.
FCC Part 15.105 Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radio frequency radiation exposure information according 2.1091 / 2.1093 / OET bulletin 65
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la Partie 15 des règlementations de la FCC et avec la norme RSS-210 de l'Industrie Canadienne.
Son fonctionnement est soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences nuisibles et
(2) Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner un fonctionnement
indésirable.

Navigation menu