User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 4153902 |
| Application ID | xv3KO7wzeoYmmyIlAVyNgQ== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 90.71kB (1133890 bits) |
| Date Submitted | 2019-01-30 00:00:00 |
| Date Available | 2019-01-30 00:00:00 |
| Creation Date | 2019-01-03 10:26:32 |
| Producing Software | Microsoft® Word 2016 |
| Document Lastmod | 2019-01-30 17:27:01 |
| Document Title | User Manual |
| Document Creator | Microsoft® Word 2016 |
| Document Author: | Eveline van der Leer |
G277/G577/G577h DECT Quick Reference Guide G577 G577h Front View Package Contents: - G277/577(h) DECT Handset - Battery - Belt Clip - This Reference Guide - Additional Information Sheet G277 Side Views To use the G277/577(h) for the first time: - Open the battery lid; - Remove the plastic strip from the battery contacts - Close the battery lid; - Place the G277/577(h) on the charger to fully charge the battery G277/577 DECT Handset Quick Reference Guide Top Line Icons Main Menu Items Contacts Signal Strength Central Directory Battery Status Calls Ringer Off Settings Microphone Muted Calendar Keypad Locked Accessories Missed Call Messaging (G577(h)) Voice Mail Present Indication GETTING STARTED Turning the G277/577(h) on and off Press and hold for a few seconds. Activating your phone When the display of your phone is dark, press any key to activate your phone (phone in Idle mode). Lock/Unlock your phone Press and then (toggle function). Make a call 1. 2. 3. 4. Press and then type the number you want to reach. Press an then type the number you want to reach (speakerphone call) Type the number you want to reach and then or Use a speed dial key ( … or 5. Press soft key , or or , select the required contact and press soft key OR OR OR OR Answering an incoming call Press or, for speakerphone call, End a call Press Make an enquiry call During a call, press and dial the number of the party you want to consult. Press toggle between the two parties. Press to transfer the call. to Change the volume During a call, press “Volume Up” or “Volume Down” on the side of the phone. The default volume level is 4. Use the Speaker phone During a call, press ; to de-activate: press again. Mute the microphone during a call Press the soft key . To turn the microphone on again, press the soft key G277/577 DECT Handset Quick Reference Guide Write and send a text message (G577(h)) In Idle mode, press , use the navigation keys to select and press the soft key 1. Press soft key , then enter the text of your message. OR 2. Use the navigation keys to select a stored draft message and press soft key Then press soft key , select the type of the message (normal or urgent) and choose the required destination(s). When “message sent” is given in the display your message has been sent successfully. Assigning a contact to a speed dialling key In Idle mode, press soft key and press soft key , select the contact you want to assign a speed dialling key . Choose and press soft key to scroll to the appropriate number (2..9) and press soft key . Use the navigation keys Register the handset In Idle mode, press , use the navigation keys to select and press soft key . Use the navigation keys to select (connectivity) and press soft key . Use the navigation keys to select (Register) and press soft key Enter the requested registration information (contact your System Administrator for this). Wait for the registration to be completed. Using the menu In Idle mode, press to access the main menu. Use the navigation keys to go to the required menu, menu tab and menu item. Use soft key ( or press ) to select the chosen menu or menu item/tab. Other soft keys may provide additional options. To go back one step in the menu or leave altogether, press G277/577 DECT Handset Quick Reference Guide Menu list 1. Contacts • List of contacts 2. Central Directory • Select required contact by name 3. Calls • All Calls • Answered Calls • Dialled Calls • Missed Calls 4. Settings • General Settings Silent Time & Date Language (Supported: English, Spanish, German, French, Italian, Dutch, Danish, Swedish, Turkish, Polish, Norwegian, Greek & Russian) Shortcuts (for the navigation keys) LED Signal Red LED Green LED Yellow LED Blue LED Security Phone Lock Automatic Key Lock Change PIN Proxy Password Handset Name Reset Settings Status • Sounds Normal & Sounds Silent Incoming Call Ring Volume Ring External/Internal/Unkn own Group Ring Intercom Ring Emergency Ring Arb. Ring Increasing Ring Vibrator Message Notifications (G577(h)) Notification Volume Notification Normal/Urgent/Emerg ency Increasing Notification Vibrator Alerts Alert Volume Alert Melody Increasing Alert Vibrator Feedback Key Sound Confirmation Sound Coverage Warning Charger Warning Noise Reduction • Display Wallpaper Startup Screen Power Save Charger Backlight • Calls Units Answer Mode Caller Filter Emergency Call Number Message SOS Key (G577(h)) Voicemail Number Silent Charging Missed Call Time • Connectivity Register Deregister Select Network Bluetooth (G577(h)) Enabled/Disabled Search for Devices Paired Devices 5. Calendar • Manage your appointments 6. Accessories • Alarms • Calculator • Stopwatch 7. Messaging (G577(h)) • Drafts • Inbox • Sent Messages • Settings G277/577 DECT Handset Quick Reference Guide tests for each device are performed in positions and location FCC Warning： (e.g. at the ear and worn on the body)as This device complies with part 15 of the FCC Rules. Operation is required by the FCC. For body worn operation, this subject to the following two conditions: model device has been tested and meets the FCC RF (1) This device may not cause harmful interference, and (2) this exposure guidelines when used with an accessory device must accept any interference designated for this product or when used with an received, including interference that may cause undesired accessory that contains no metal. operation. Any Changes or modifications not expressly approved by the party responsible for compliance This device complies with ISEDC licence-exempt RSS could void the user's authority to operate the standard(s). Operation is subject to the following two equipment. conditions: Note: This equipment has been tested and found to comply (1) this device may not cause interference, and with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed (2) this device must accept any interference, including interference that may cause undesired operation of to provide reasonable protection against the device. harmful interference in a residential installation. This Le présent appareil est conforme aux CNR d'ISEDC equipment generates, uses and can radiate radio applicables aux appareils radio exempts de frequency energy and, if not installed and used in accordance licence.L'exploitation est autorisée aux deux conditions with the instructions, may cause harmful suivantes : interference to radio communications. However, there is no (1) l'appareil nedoit pas produire de brouillage, et guarantee that interference will not occur in a (2) l'utilisateur de l'appareil doit accepter tout brouillage particular installation. If this equipment does cause harmful radioélectrique subi, même si le brouillage est interference to radio or television reception, susceptible d'en compromettre le fonctionnement. which can be determined by turning the equipment off and on, The device has been tested and compliance with SAR limits, users can obtain Canadian information on RF the user is encouraged to try to correct the exposure and compliance interference by one or more of the following measures: Le présent appareil est conforme Après examen de ce —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. matériel aux conformité aux limites DAS et/ou aux —Connect the equipment into an outlet on a circuit different limites d’intensité de champ RF, les utilisateurs peuvent sur l’exposition aux radiofréquences et la from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for conformité and compliance d’acquérir help. ISEDC Specific Absorption Rate (SAR) information For Handset FCC Exposure to Radio Frequency (RF) Signals SAR tests are conducted using standard operating For Handset This is a radio transmitter and receiver. It is designed and positions accepted by the ISEDC with device transmitting at its highest certified power level in all tested frequency manufactured not to exceed the emission limitsfor bands, although the SAR is determined at the exposure to radio frequency (RF) energy set by the highest certified power level, the actual SAR level of the Federal Communications Commission (FCC) of the U.S.Government. These limits are part of comprehensive device while operating can be well below the maximum value. Before a new model device is a available guidelines and establish permitted levels of RF for sale to the public, it must be tested and energy for the general population. The guidelines are certified to the ISEDC that it does not exceed the exposure based on the safety standards previously set by both U.S. and international standards bodies. These standards limit established by the ISEDC, tests for each device are performed in positions and locations as include a substantial safety margin designed to required by the ISEDC. For body worn operation, this assure the safety of all persons,regardless of age and health. This device and its antenna must not be colocated model device has been tested and meets the ISEDC RF exposure guidelines when used with an accessory or operating in conjunction with any other antenna or designated for this product or when used with an transmitter. This product has been shown to be capable of compliance for localized specific absorption rate accessory that contains no metal. (SAR) for uncontrolled environment/general population exposure limits specified in ANSI/IEEE Std. ISEDC Radiation Exposure Statement: For Handset C95.1-1992 and had been tested in accordance with SAR l’utilisation des règles sma l’emplacement Le matériel the measurement procedures specified in FCC/OET de transmission et fonctionnant dans tous les Bulletin 65 Supplement C (2001) and IEEE 1528. essais à la certification, même si la puissance suprême a décidé le niveau, utilisation spécifique peut être FCC Specific Absorption Rate (SAR) information très en deçà de la valeur de référence maximale.Types de For Handset matériel sont vendus au public un ancien, d’essai SAR tests are conducted using standard operating et de certification de l’exposition, limite maximum sma, positions accepted by the FCC with device transmitting chaque document et l’emplacement du matériel at its highest certified power level in all tested frequency d’essai et conformément au document.Le modèle en bands, although the SAR is determined at the physique, matériel d’essai et conforme aux directives highest certified power level, the actual SAR level of the d’exposition des radiofréquences sma quand une annexe device while operating can be well below the maximum value. in general,the closer you are to a wireless désigné pour ce produit lors de leur utilisation ou des pièces de rechange ne contiennent pas de métal. base station antenna,the lower the power output. ISEDC Warning: Before a new model device is a available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC G277/577 DECT Handset Quick Reference Guide CS03 Warning This product meets the applicable ISEDC technical specifications. / Le present matériel est conforme aux specifications techniques applicables d’ISEDC. The REN is an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. / L’indice d’équivalence de la sonnerie (IES) sert à indiquer le nombre maximal de terminaux qui peuvent être raccordés à une interface téléphonique. La terminaison d’une interface peut consister en une combinaison quelconque de dispositifs, à la seule condition que la somme d’indices d’équivalence de la sonnerie de tous les dispositifs n’excède pas cinq. REN: NAN
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.7 Linearized : No Author : Eveline van der Leer Create Date : 2019:01:03 10:26:32+08:00 Modify Date : 2019:01:30 17:27:01-08:00 Language : en-US Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Producer : Microsoft® Word 2016 Format : application/pdf Creator : Eveline van der Leer Creator Tool : Microsoft® Word 2016 Metadata Date : 2019:01:30 17:27:01-08:00 Document ID : uuid:3306F6FF-11BD-4B61-98DC-3468C040AE4C Instance ID : uuid:f4318cbb-3c95-4962-9cd8-9cc737269fce Page Count : 6EXIF Metadata provided by EXIF.tools