RadarFind T11A011 RF Location Tag User Manual Radarfind Status Tag Installation manual

Download:
Mirror Download [FCC.gov]
Document ID	742718
Application ID	h58mN0eCK1ZVrG9iw7Uu+A==
Document Description	user manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	73.42kB (917708 bits)
Date Submitted	2006-12-28 00:00:00
Date Available	2006-12-31 00:00:00
Creation Date	2006-12-28 11:49:10
Producing Software	Acrobat Distiller 7.0.5 (Windows)
Document Lastmod	2006-12-28 11:49:51
Document Title	Radarfind Status Tag Installation manual
Document Creator	Acrobat PDFMaker 7.0.5 for Publisher
Document Author:	SMF

Installation Instructions
Radarfind Corporation ™
A-Status Tag - Model T11-A011
12/28/2006
Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com
Warnings:
It is important to follow all instructions shipped with this product.
Failure to follow all safety precautions and instructions may result in property damage, serious injury, or death to you or others.
UNPACKING: After unpacking the unit, examine it for damage that may have occurred in transit.
If the equipment has been damaged, do not attempt to install or operate it. File a claim immediately
with the carrier stating the extent of the damage, or contact RadarFind customer service for repair
or replacement.
Read and understand all instructions before installing or operating this equipment.
The selection of the mounting location for the device is to be accomplished under the direction of the
director of Clinical Engineering and conform to all company policies, and must be in accordance
with specifications in the sub-chapter for each device type.
CAUTION: Risk of malfunction. Install these devices only in areas with an ambient temperature
between 0° and 50°C.
[15.19] This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
[15.21] Information to user: Changes or modifications not expressly approved by the RadarFind
Corporation could void the user's authority to operate the equipment
[15.105] NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
[15.249] This equipment operates under Section 15.249 of the Title 47 FCC Rules.
12/28/2006
Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com
Contents of standard package:
(1) - T22-A011 – A-Status Tag
(1) TBA-3160 – Mounting Base
(1) A12-1A0B – Adhesive Pad
(2) A12-1T0B – Plastic mounting strap
12/28/2006
Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com
Accessories
A12-3T00 (2) Stainless steel mounting straps
(for application of Radarfind tag mounting base (Part# TBA-3160) to tubular structures)
Note: For best performance the steel straps require a special tool to tighten and cut the strap.
12/28/2006
Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com
General Guidelines:
All tags on an asset type should be the same type, e.g. all infusion pumps should have an A-Status Type tag.
Select a standard location on each asset type for the tag. For A-Status tags select a location where the status
indicator is plainly visible and can be easily accessed by the user when switching the status switch. Be sure to
choose a place where the tag is protected from physical impacts when the device is being used or transported.
The tag location should not interfere with normal use of the asset, and have sufficient clearance on the open
end of the base to insert the locking base key and insert and remove the tag.
For best performance do not place the tag in a location covered with metal, such as inside of a control box or
enclosed area under a bed frame.
Using adhesive pad – Clean the area on the asset with alcohol to ensure a good bond. Remove white side of
the adhesive covering and place on tag base, aligning the hole in the center of the adhesive over the base
locking mechanism. Remove red backing and apply to asset. (Be sure to leave sufficient clearance at the
open end of the base to insert and remove the tag from the base)
Adhesive Orientation
Apply adhesive to base 1st
Adhesive mounting tips for curved surfaces:
If the target location is not completely flat you may need to add strips under the ends of the adhesive pad
(cut the strips from a spare pad)
Building up adhesive to conform to curves
12/28/2006
Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com
Using the supplied plastic strap:
Use the supplied plastic “Tie-Rap” to attach the tag base to permanently mounted cords or handles of assets
where there is no convenient flat mounting spot.
Use tie-rap to attach tag to oddly shaped assets
Mounting to tubular fixtures:
Use stainless steel straps to attach tag to tubes or poles.
For best results mounting to tubular fixtures, such as IV poles or wheelchair frames, the locking base is
equipped with strapping holes. These holes are designed to be used with thin stainless steel straps, available
from Radarfind ( Part # A12-3T00 ) or Panduit:
http://www.panduit.com/search/search_results.asp?Ne=1&recName=MLT1S%2DCP&N=5000001+336+3000858+®ion=USA
Note: that the best results are obtained by using the strapping gun designed for these steel straps.
12/28/2006
Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com
Installation Steps – Attaching tags with adhesive:
Step # 1 - Select location for tag and clean area for adhesive with alcohol.
Step # 2 - Attach adhesive to tag base with adhesive or straps.
Step # 3 – (Assuming that you have already entered your assets ) Select asset by entering the serial number
or asset inventory number. Enter or scan tag ID into the Radarfind software, select which tag type, status or
non-status, and hit 
Once a tag is assigned to an asset any searching or display can be done by looking for the asset.
If you need to remove a tag from an asset please un-assign the asset in the following screen by selecting the
correct asset and clicking DETACH.
12/28/2006
Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com
Technical Specifications:
Tag (Model T11-A011)
DC power:
Power consumption:
Communications:
Transmit power:
Antenna:
Communications:
Operating:
Packaging:
Accessories:
Dimensions:
12/28/2006
Internal sealed lithium battery
Average 15uA
One 350 kHz FSK channel at 915 MHz
-10dBm
Unity gain isotropic
FCC Subpart 15.249
5 to 35º C, 5% to 90% RH, non condensing
ABS Plastic (UL Flammability Rating V0)
Adhesive pad, holding base, plastic mounting straps, and steel
mounting straps
Optional holding base (2.6”L x 1.5”W x 0.375”D)
Tag T11-A011 (2.5” L x 1.25” W x 1” D)
Radarfind Corporation— Phone 877 Radarfind—www.radarfind.com

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : 3.1-701
Producer                        : Acrobat Distiller 7.0.5 (Windows)
Create Date                     : 2006:12:28 11:49:10-05:00
Creator Tool                    : Acrobat PDFMaker 7.0.5 for Publisher
Modify Date                     : 2006:12:28 11:49:51-05:00
Metadata Date                   : 2006:12:28 11:49:51-05:00
Format                          : application/pdf
Title                           : Radarfind Status Tag Installation manual
Creator                         : SMF
Document ID                     : uuid:e32cced8-b619-412e-946d-c0a50f875c5b
Instance ID                     : uuid:5ce980e4-7304-4fac-a59c-2624de2a91fc
Page Count                      : 8
Page Layout                     : OneColumn
Author                          : SMF

EXIF Metadata provided by EXIF.tools