Radiance Instruments TMW017G SMOKE GATEWAY User Manual TMW017G Manual r2

Download:
Mirror Download [FCC.gov]
Document ID	3512427
Application ID	Cpcb/qDvDk8EBqvKMXCX3w==
Document Description	TMW017G_Manual_r2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	25.98kB (324811 bits)
Date Submitted	2017-08-15 00:00:00
Date Available	2017-08-18 00:00:00
Creation Date	2017-08-08 16:12:24
Producing Software	Adobe PDF Library 15.0
Document Lastmod	2017-08-15 15:34:58
Document Title	TMW017G_Manual_r2
Document Creator	Adobe InDesign CC 2017 (Macintosh)

This equipment complies with the FCC RF radiation exposure limits set
forth for an uncontrolled environment. This equipment should be installed
and operated with a minimum distance of 20 centimeters between
the radiator and your body.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device complies with Industry Canada Licence-exempt RSSs.
Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
Special Notice
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC ID: 2AI67-TMW017G / IC: 22116-TMW017G
www.thermoworks.com
741 E. Utah Valley Dr.
American Fork, UT 84003
For service or warranty:
1-800-393-6434
1-801-756-7705
techsupport@thermoworks.com
P-15-012-02-b
Smoke Gateway
Operating Instructions
Smoke Gateway connects your Smoke Professional BBQ Thermometer
to the Smoke Gateway mobile app on your smartphone or tablet. Smoke
Gateway pairs to your Smoke base unit, and then connects to your Wi-Fi.
Only one Smoke base unit can connect at a time to a Smoke Gateway.
What’s Included:
Smoke Gateway, lithium rechargeable battery (installed), power adapter, USB
charging cable, and this instruction guide.
Set Up:
1. Download the Smoke Gateway mobile app from Apple App Store
or Google Play.
2. Follow the on-screen instructions in the app to pair your Smoke
Gateway to your Smoke base unit (via Radio Frequency [RF]
wireless), and then connect it to your local Wi-Fi.
To Operate:
Press the power button to turn Smoke Gateway on (double blue flash).
Press and hold the power button for 3 seconds to power Smoke Gateway off
(double red flash).
Smoke Gateway can run for up to 100 hours on battery power. Alternatively,
Smoke Gateway will also run connected to mains power.
(Smoke Gateway ships with partial charge; it is recommended to charge before
use)
To Charge:
When the battery is low, the LED will flash red twice every 2 seconds then turn
off after 1 minute. Connect Smoke Gateway to mains power using the included
power adapter and USB charging cable. When the unit is fully charged the LED
will change from solid red to solid blue. Allow approximately 8 hours to fully
charge. You can check the battery level of Smoke Gateway by going to ‘Settings’
on a single channel.
Transmission Distance:
Smoke Gateway should be located within 300-feet (line of sight) of the Smoke
base unit for best results, and within range of your Wi-Fi network.
Hard Reset:
To perform a hard reset on Smoke Gateway, press the RESET button on the back
of the device. Your connection settings will not be lost.
Firmware Updates:
Smoke Gateway will update itself automatically with the latest firmware
when connected to Wi-Fi.
Operating Instructions
flashes every 5 sec.
Operating3. LED
Instructions
BLUE - functioning normal
2. Hold for 3 sec. to turn off.
(Double red flash)
RED - resync to Smoke base
(Wi-Fi ID: Gateway_xxxxxx)
6. Splashproof, do not submerge.
5. Follow app instructions for setup.
(Wi-Fi ID: Gateway_xxxxxx)
4. Flashes red twice
every do2 not
seconds
6. Splashproof,
submerge.
for 1 min. – Charge battery.
5. Follow app instructions for setup.
RED - normal
resync to Smoke base
BLUE - functioning
PURPLE - Wi-Fi comm. lost
RED - resync to
Smoke
base
4. Flashes
red twice
every 2 seconds
1 min. – Charge
PURPLE - Wi-Fiforcomm.
lostbattery.
BLUE - functioning normal
3. LED flashes every 5 sec.
(Wi-Fi
ID: Gateway_xxxxxx)
3. LED flashes every
5 sec.
blue
flash)
5. (Double
Follow
instructions
2. Hold for 3 sec.
toapp
turn
off. for setup.
2.
for 3do
sec.
turn off.
6. Hold
Splashproof,
nottosubmerge.
(Double red flash)
(Double red flash)
for 1 min.
– Charge
battery.
1. Single
press
to turn
on.
1. Single press PURPLE
to turn- Wi-Fi
on.comm. lost
Operating
4. Flashes
red twiceInstructions
every 2 seconds
(Double blue flash)
PROBE 1
PROBE 2
PROBE 1
PROBE
Smoke
Receiver
USB connection
Smoke Receiver
ON
OFF
ON
OFF
ON
OFF
1. Single press to turn on.
(Double blue flash)
ON
Smoke Receiver
(End)
SET
VOL
OFF
Smoke Gateway
Smoke Gateway
Smoke
Smoke
CAL
(Back)
°C/°F
RESET
RESET
LED Light:
When the unit is turned on and operating normally the LED will flash every
5 seconds. When flashing BLUE, everything is working properly. If flashing
RED every 5 seconds, the connection to your Smoke base unit (RF) is not
working properly. If flashing purple, Wi-Fi is not connected properly. During
setup the LED light will flash per the app instructions.
ON
OFF
RESET
CAL
Hard reset
°C/°F
Smoke Gateway
SET
VOL
ON
OFF
On/Off
SET
SET
Care & Maintenance:
Power Smoke Gateway off when not in use to conserve battery power.
Store at room temperature in dry location.
LED Light

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Create Date                     : 2017:08:08 16:12:24-06:00
Creator                         : Adobe InDesign CC 2017 (Macintosh)
Modify Date                     : 2017:08:15 15:34:58-04:00
Language                        : en-US
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Metadata Date                   : 2017:08:15 15:34:58-04:00
Creator Tool                    : Adobe InDesign CC 2017 (Macintosh)
Instance ID                     : uuid:d7d56dd8-b0fa-49ab-8891-ceeb59f04dfe
Original Document ID            : xmp.did:f1df5104-1937-4848-aa38-d2cc1c5b3705
Document ID                     : xmp.id:08acf85f-7fb3-43f7-ab1b-da8779eb3734
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:4246b476-f509-4020-8f98-85e0238e71de
Derived From Document ID        : xmp.did:762b4354-965f-43db-b71b-a49a80e2aa28
Derived From Original Document ID: xmp.did:f1df5104-1937-4848-aa38-d2cc1c5b3705
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 2017 (Macintosh)
History Changed                 : /
History When                    : 2017:08:08 16:12:24-06:00
Format                          : application/pdf
Producer                        : Adobe PDF Library 15.0
Trapped                         : False
Page Count                      : 2

EXIF Metadata provided by EXIF.tools