Radio Shack 330103T 2.4GHz FHSS Wireless Headphone User Manual 33 1253 33 0385 Operation Manual

Download:
Mirror Download [FCC.gov]
Document ID	739388
Application ID	PH8/SG1DTJa/VJnKP7/Nnw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	2.43kB (30319 bits)
Date Submitted	2006-12-17 00:00:00
Date Available	2006-12-17 00:00:00
Creation Date	2006-11-27 17:34:21
Producing Software	Acrobat Distiller 6.0 (Windows)
Document Lastmod	2006-11-27 17:34:31
Document Title	33-1253 / 33-0385 Operation Manual
Document Creator	Acrobat PDFMaker 6.0 for Word
Document Author:	Eric Yu

33-103 Owner Manual
2.4GHz digital wireless headphone
Introduction
33-103 consists of a 2.4GHz transmitter and a wireless digital headphone. The transmitter has a stereo
RCA jacks that user can connect to most portable music sources. When the transmitter is powered on,
the audio input will be wirelessly transmitted to the headphones.
Operation
1. Connect the transmitter to any music source (e.g. MP3 player, CD player, etc) and then plug the
AC/DC power adapter to power on the transmitter unit. A RED LED will light to indicate that the
transmitter is powered ON.
2. Play the desired music from your audio source. Once the transmitter detects the audio input, it will
start transmission and the LED turns to Green to indicate that the transmission is ON.
3. Switch on the headphones. A Blue LED will light to indicate the power is on.
4. Select the channel switch to the position that same as the transmitter unit.
5. Adjust the volume of the headphone to the desired level.
Note:
1. When there is no audio input for 5 minutes, the transmission will stop automatically.
2. If there is any interference present, change to other channel.
Low Battery indication
Once the headphone is turned ON, the Blue LED should light. When the battery level is detected below
about 3V, the LED will flash then the unit needs to be charged. Charge the battery as soon as possible.
If the unit is not charged when the LED flashes, the headphone stops operation but still consume
power. When the battery level below about 2.8V, the headphone will be shut down and not LED lights
anymore until the battery is replaced or charged.
Battery charging
Plug the AC/DC adapter to power on the transmitter unit. Put the headphone on the transmitter docking.
A blue LED will light to indicate the charging is on.
LED status
Transmitter unit action
Power ON/ no transmission
Transmission start
Power ON/ Charging start
FCC ID: AAO330103T
Blue LED
OFF
OFF
On
Dual color LED
RED LED On
Green LED On
Red LED On
Headphone unit action
Power On
Low battery
Power off/battery
voltage<2.8
Blue LED
On
Flash
OFF
Specification
Operation frequency: 2.4GHz
Operation range: 150 feets
Battery life: about 10 hours
Frequency response (6dB): 20Hz – 20KHz
Audio S/N: >70dB
Audio resolution: 16 bit
Audio Sample rate: 44.1KHz
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may causeharmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult your local RadioShack store or an experienced radio/TV technician for help.
• If you cannot eliminate the interference, the FCC requires you to stop using the headphones.
Caution
•To maintain compliance with the FCC’s RF exposure guidelines place the base unit at least 20
cm from the nearby persons.
Changes or modifications not expressly approved by RadioShack may cause interference and void
the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
RadioShack Corporation
FCC ID: AAO330103T

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 2
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:6fbafb58-060d-4445-b6d0-863c0c8b85b8
Producer                        : Acrobat Distiller 6.0 (Windows)
Company                         :  Notebook
Source Modified                 : D:20061127093411
Headline                        : 
Create Date                     : 2006:11:27 17:34:21+08:00
Creator Tool                    : Acrobat PDFMaker 6.0 for Word
Modify Date                     : 2006:11:27 17:34:31+08:00
Metadata Date                   : 2006:11:27 17:34:31+08:00
Document ID                     : uuid:fe600637-f640-4f47-aea5-c2158a35c3df
Version ID                      : 5
Format                          : application/pdf
Title                           : 33-1253 / 33-0385 Operation Manual
Creator                         : Eric Yu
Subject                         : 
Tagged PDF                      : Yes
Author                          : Eric Yu

EXIF Metadata provided by EXIF.tools