Radio Shack 4303107 900 MHz Door Bell w/AC Line Intercom-Indoor Unit User Manual www RadioShack with In Line CircleR eps

Download:
Mirror Download [FCC.gov]
Document ID	271330
Application ID	0HUGn7Sa/yn3EiGIH3DXLw==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	16.02kB (200232 bits)
Date Submitted	2002-09-18 00:00:00
Date Available	2002-09-18 00:00:00
Creation Date	2001-11-09 08:31:39
Producing Software	Acrobat Distiller 3.02
Document Lastmod	2002-08-26 08:56:21
Document Title	www RadioShack with In-Line CircleR.eps
Document Creator	Adobe Illustrator(TM) 7.0
Document Author:	Jonathan L Haker

43-3101.fm Page 1 Friday, November 9, 2001 8:30 AM
Indoor/Outdoor Modular Intercom System
43-3107
OWNER’S MANUAL — Please read before using this equipment.
Your Indoor/Outdoor Modular Intercom
System operates as a two-tone doorbell
intercom and an indoor intercom. The
doorbell is simple to install without wiring and
you can add additional stations.
PREPARATION
Installing the Doorbell’s Batteries
Your doorbell intercom uses four AA
batteries (not supplied) for power. For the
best performance and longest life, we
recommend RadioShack alkaline batteries.
Caution: Use only fresh batteries of the
required size and recommended type. Do not
mix old and new batteries, different types of
batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
Warning: Dispose of old batteries promptly
and properly. Do not burn or bury them.
Caution: If you do not plan to use the
doorbell for two weeks or longer, remove the
batteries. Batteries can leak chemicals that
can destroy electronic parts.
If the doorbell unit operates under severe
cold weather, use a lithuim type AA battery.
Setting the Channel
The doorbell and indoor intercoms have
three selectable operation channels to
prevent interference from similar products
nearby. Select the same channel for both the
doorbell intercom and the indoor intercom.
On the doorbell intercom, slide CH inside the
battery compartment to 1 (912.45MHz), 2
(913.45MHz), or 3 (914.45MHz).
1. Use a Phillips screwdriver to loosen the
screws in the doorbell intercom’s battery
compartment cover, then lift the cover
off.
On the back of the indoor intercom, set
OUTDOOR CHANNEL to the same channel
number (1, 2 or 3) you chose for the doorbell
intercom.
2. Insert four AA batteries into the
compartment as indicated by the polarity
symbols (+ and –) marked inside.
Note: If the doorbell occasionally sounds
without anyone pressing BELL on the
doorbell, change the channel settings.
3. Replace the cover and tighten the
screws.
Changing the Doorbell’s Tone
Hint: For convenience, set the channel
(see “Setting the Channel”) while you
have the battery cover removed.
Use a small flat-blade
screwdriver to
carefully pull out the
jumper TONE switch
located in the battery
compartment, then
insert the jumper TONE
switch into the other
two pins.
© 2001 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
43-3101.fm Page 2 Friday, November 9, 2001 8:30 AM
3. Thread a screw into each hole until the
screw’s head extends about 1/8 inch
(3.5mm) from the wall.
Setting the Doorbell’s Volume
Slide VOL located inside the battery
compartment to level 1, 2 or 3.
4. Align the keyhole slots on the bottom of
the intercom with the screw heads in the
wall, then slide the intercom down to
secure it and lift and extend the antenna.
Testing the Doorbell
Test the doorbell before permanently
mounting it. With the indoor intercom plugged
into a standard AC outlet, adjust VOLUME on
the indoor intercom to its middle position.
Press BELL on the doorbell intercom. The
doorbell should sound.
Connecting the Indoor Intercom to
AC Power
Locate a standard AC outlet in the area where
you want to hear the chime and use the
intercom. Plug the indoor intercom’s power
cord into the outlet.
Mounting the Doorbell
1. Drill four 3/16 inch diameter holes into the
mounting surface. Insert an anchor into
each hole.
Caution: This product is equipped with a
three-wire grounding-type plug ( a plug having
a third grounding pin). This plug will only fit
into a grounding-type power outlet. This is a
safety feature. If you are unable to insert the
plug into your AC outlet, contact your
electrician to replace your outlet. Do not
defeat the safety purpose of the groundingtype plug.
2. Align the supplied metal mounting
bracket with the drilled holes and drive a
screw (supplied) through the bracket
into each hole. Do not overtighten the
screws.
3. Align the slot on the back of the doorbell
with the hook on the mounting bracket.
Carefully push the doorbell onto the hook
and slide it down to secure it.
Important: Be sure you install the stations at
least 10 feet away from each other. Placing
the stations too close together produces
feedback (a squeal or howl from the
speakers). The stations can transmit up to
300 feet, including between buildings, as long
as they are connected to the same power line
transformer.
4. Once the doorbell is securely on the
bracket, insert the pan-head machine
screw (supplied) through the hole on the
lower edge of the doorbell into the
threaded holes in the bracket.
Mounting the Indoor Intercom
OPERATION
Follow these steps to mount the indoor
intercom on a wall.
Turning the Indoor Intercom On
and Off and Adjusting the Volume
Note: You need two screws (supplied)
with heads that fit into the keyhole slots on the
bottom of the intercom.
Rotate VOLUME counterclockwise until it
clicks. The POWER indicator lights. Then
adjust VOLUME to the desired listening level.
To turn off the indoor intercom, rotate
VOLUME clockwise until it clicks. The POWER
indicator turns off.
1. Mark the mounting screw locations 21/2
inches (64 mm) apart, one above the
other.
2. Drill a starter hole at each mark.
43-3101.fm Page 3 Friday, November 9, 2001 8:30 AM
Using the Doorbell
Calling Another Intercom Station
Your visitor presses BELL on the doorbell to
sound the doorbell.
Be sure the intercom stations you plan to use
are turned on and adjusted to the desired
volume. Press CALL to sound a tone alerting
the person at the other station that you are
about to speak. The CALL indicator lights.
Hold down TALK TO DOOR on the indoor
intercom to reply to the caller. The TALK TO
DOOR indicator lights. When you release
TALK TO DOOR, the caller can reply by
pressing PRESS TO TALK on the doorbell
intercom.
Hold down TALK and speak in a normal voice.
The TALK indicator lights. When you finish
speaking, release TALK and listen for a
response.
Notes:
Notes:
• If there is no voice communication
between the doorbell and the indoor
intercom within about 10 seconds, the
doorbell intercom may be disabled and
should be initialized by pressing BELL
again.
• Only one party can talk at a time. Wait
until the other party finishes before
answering.
• If your voice sounds distorted, you might
be speaking too loudly or too close to the
station’s microphone.
• You can also use other intercoms to reply
to the doorbell as long as they are set on
the same frequency.
WARNING:
To reduce the risk of fire or shock
hazard, do not expose this product to rain or moisture.
• If the channel is occupied by other
intercom users, the door chime cannot be
sent to the intercoms in use. The
conversation between intercoms will not
be sent to the doorbell.
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.
USING MULTIPLE
INTERCOMS
You can set up several indoor intercoms for
station-to-station communication. Simply set
CHANNEL A/B/C on the back of each intercom
to the same frequency as other stations with
which you want to communicate.
This symbol is intended to alert you to
the presence of uninsulated dangerous voltage within the product’s enclosure that might be of sufficient
magnitude to constitute a risk of electric shock. Do not open the product’s
case.
For example, you could set a station installed
in the kitchen to channel A, a station installed
in the family room to channel B, and a station
installed in a bedroom to channel C. Using the
station installed in the kitchen, you can
communicate with the station in the family
room by setting the channel selector to B, or
with the station in the bedroom by setting the
channel selector to C. If you set all stations to
channel A, you can communicate with the
other two stations from any station.
This symbol is intended to inform you
that important operating and maintenance instructions are included in the
literature accompanying this product.
43-3101.fm Page 4 Friday, November 9, 2001 8:30 AM
CARE
Keep the system dry; if it gets wet, wipe it dry immediately. Use and store the system only in normal temperature environments. Handle the
system carefully; do not drop it. Keep the system
away from dust and dirt, and wipe it with a damp
cloth occasionally to keep it looking new.
Modifying or tampering with the system’s internal
components can cause a malfunction and might
invalidate its warranty and void your FCC authorization to operate it. If your system is not performing as it should, take it to your local
RadioShack store for assistance.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio
TV technician for help.
Your system is ETL listed to UL standards and
meets all applicable FCC requirements.
Limited Ninety-Day Warranty
FCC STATEMENT
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
This product is warranted by RadioShack against manufacturing
defects in material and workmanship under normal use for ninety
(90) days from the date of purchase from RadioShack companyowned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO
EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES,
INCLUDING THOSE OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION
TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES
CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO
CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF
THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS
WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME,
DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES,
EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not
apply to you.
In the event of a product defect during the warranty period, take
the product and the RadioShack sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct the defect by
product repair without charge for parts and labor; (b) replace the
product with one of the same or similar design; or (c) refund the
purchase price. All replaced parts and products, and products on
which a refund is made, become the property of RadioShack.
New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced parts and
products are warranted for the remainder of the original warranty
period. You will be charged for repair or replacement of the product made after the expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or
attributable to acts of God, abuse, accident, misuse, improper or
abnormal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs other than those provided
by a RadioShack Authorized Service Facility; (c) consumables
such as fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs of product removal,
installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor,
Fort Worth, TX 76102
12/99

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Create Date                     : 2001:11:09 08:31:39Z
Modify Date                     : 2002:08:26 08:56:21+08:00
Page Count                      : 4
Creation Date                   : 2001:11:09 08:31:39Z
Producer                        : Acrobat Distiller 3.02
Author                          : Jonathan L Haker
Mod Date                        : 2002:08:26 08:56:21+08:00
Metadata Date                   : 2002:08:26 08:56:21+08:00
Creator                         : Jonathan L Haker
Title                           : www RadioShack with In-Line CircleR.eps

EXIF Metadata provided by EXIF.tools