Radio Systems 3003227 Remote Control Transmitter User Manual

Important Safety Information

Explanation of Attention Words and Symbols Used in this Guide

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid

possible injury or death.

WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION, used with the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.

CAUTION, used without the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in harm to your pet.

• Do not short circuit, dispose of in re, or expose to water. When batteries are stored or disposed, they must be protected from shorting. Dispose of used

batteries properly.

• Risk of skin damage. Please read and follow the instructions in this guide. Proper t of the collar is important. A collar worn for too long or made too tight

on the pet’s neck may cause skin damage. Ranging from redness to pressure ulcers; this condition is commonly known as bed sores.

• Avoid leaving the collar on the dog for more than 12 hours per day.

• When possible reposition the collar on the pet’s neck every 1 to 2 hours.

• Check the t to prevent excessive pressure; follow the instructions in this manual.

• Never connect a leash to the electronic collar; it will cause excessive pressure on the contacts.

• When using a separate collar for a leash, don’t put pressure on the electronic collar.

• Wash the dog’s neck area and the contacts of the collar weekly with a damp cloth.

• Examine the contact area daily for signs of a rash or a sore.

• If a rash or sore is found, discontinue use of the collar until the skin has healed.

1/2 Dog

Indicator

1/2 Dog

Action

Up/Down

Dual

How it works

• Tone: beeps to get your dog’s attention or mark a behavior, similar to a clicker

• Vibration: vibrates the receiver collar

• Shock: administers a shock with up to 99 levels of intensity

1. Plug in and fully charge the remote and receiver collar. The battery icon on the remote will cycle while charging and then remain solid when it is fully

charged. The collar’s LED will be solid red when charging and will turn off when the collar is fully charged.

2. To pair the remote and receiver collar, select Dog 1 or Dog 2 on the remote. With the collar turned off, press and hold the on/off button. Continue to hold

the on/off button as the collar light will turn on and then back off after about 5 seconds. Then press the red, action button on the remote.

3. If you would like to test the shock level on yourself, select Dog 1 or Dog 2 on the remote, select shock and press the red action button. Both contact points

must touch skin to emit a shock.

5. The remote has a power-save feature that will put it into standby after 15 minutes without use. Press any button on the remote to reactivate. Note that

pressing any of the correction buttons will simultaneously reactivate the remote and send a correction to the receiver collar.

6. For your dog’s safety, the remote will automatically time-out after 10 seconds of shock. You will have to release and repress the action button to

administer another shock.

7. The remote can be paired with two collars, labeled as Dog 1 and Dog 2. Make sure to choose the correct one when pairing a second collar, and follow the

steps above.

8. The 330-yard range is based on a straight-line distance between the remote and the receiver collar without obstacles. Interferences in the air, obstacles in

the area and other factors could alter the range, so actual distances may vary.