Rapoo Technology 1010 Wireless Mouse User Manual 1010 xinde
Shenzhen Rapoo Technology Co., Ltd Wireless Mouse 1010 xinde
User Manual
1010 RAPOO 雷柏
03037
2.4G Mini Receiver
2.4G
03037
2.4G Mini Receiver
2.4G
Wireless Optical Mouse
user guide
1. Open the cover.
2. Remove the cover and change the battery
correctly,1.5V AA*1 .
1.5V AA*1
3. Close the cover.
4. Push the switch, power on.
將電源開關撥至ON，打開電源
2.4G Mini Receiver
user guide
1. Plug the Mini
Receiver into a USB
port of your computer.
2. Turn on the
Wireless Optical
Mouse.
3. Move the Wireless
Optical Mouse to get
connected with the
Mini Receiver.
USB
Plug the receiver into the usb port. The receiver will match the keyboard automatically.
Frequency Range/: 2402~2479 MHz
Channel No./: 16
Modulation Type /: GFSK
Date Rate/: 1Mbps
RAPOO
M/N：
Rating:
Approval No:
CMIIT ID:
NCC
根據低功率電波輻射性電機管理辦法規定：
第十二條
經形式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變
更原設計之特性及功能。
第十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，并改善至
無干擾時方得繼續使用。
前項合法通信，指依電信規定作業之無線電信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電
波輻射性電機設備之干擾。
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices).
This equipment complies with Part 15 of FCC RF Rules. Operation is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may cause undesired operation of the device.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user
authority to operate the equipment.
Canada Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.