Rapoo Technology M6133BT Bluetooth Laser Mouse User Manual
Shenzhen Rapoo Technology Co., Ltd Bluetooth Laser Mouse Users Manual
Users Manual
Installation
Note:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user authority to operate the
equipment.
Bluetooth Mouse User Guide – V0.2
Step1. Inserting Batteries
1. Remove the battery cover.
2. Insert 2 AAA batteries.
3. Place back the battery cover. As the Mouse has power switch, please make sure the power
switch is on.
Step2. Connecting the Mouse to the Dongle
Before you install the Bluetooth Mouse, please make sure that you computer support Bluetooth
function, and finished the Bluetooth software installation. Software available like Wincomm, IVT or
the Microsoft built-in software.
Press the connect button at the bottom, then the Mouse is ready for the match, please note that the
connect button is only usefull during the match procedure.
Match Procedure
A. Match on Widcomm
1. Double click the Icon again, “My Bluetooth Place” pops up.
2. Click “Bluetooth Setup – Bluetooth Setup Guide”.
3. In the Setup Guide window, click next button, wait until the system found the mouse, select
“Mouse”, click “Next”. Hint for connection.
4. Click “Click here”, now you can use your mouse at ease.
B. Match on Microsoft built-in software
1. Make sure that the Bluetooth Function has been activated. Double click the Bluetooth Icon on
the Task Bar or in the Control Panel, open the “Bluetooth Management” window, click “Add”, tick
off “facility is ready for searching”, click “Next”.
2. Wait till the Mouse is found, select mouse, click “Next”.
3. Select “No Password”, click “Next”, the system will install the new facility automatically.
C. Match on IVT software
1. Make sure that the Bluetooth Function has been activated. Double click the Bluetooth Icon, open
the Management window, select “Search for Bluetooth facilities” or click the Round Ball in the
middle of the window.
2. Click the Bluetooth Mouse founded, click the right button for “Refresh Service”.
3. Select the Bluetooth Mouse again, click the right button for “Connect- Bluetooth Input Service”,
the system will auto install the HID facility. After that you can use you Bluetooth Mouse at ease.
Mouse Function
Speed Control
Press the CPI button and you can toggle the CPI between 800 CPI and 1600 CPI (Laser Version,
Optical is between 500 CPI and 1000 CPI)
Troubleshooting
1. Before you install your Bluetooth Mouse, please make sure you have done the Bluetooth Dongle
installation procedure, and the Bluetooth facility is turned on.
2. If you press the Connect Button inadvertently or some abnormal disconnection occurs during
using, please reconnect the mouse. If unable to rematch, kindly delete the Mouse Icon to erase
the stored info of the mouse in the computer.
3. Make sure there is no change of the Bluetooth facility. If anything changed, please kindly
rematch.
4. Please kindly check the batteries. If they are short of power, replace them with new ones.