Rapoo Technology S100 Bluetooth Multi-Style Headset User Manual
Shenzhen Rapoo Technology Co., Ltd Bluetooth Multi-Style Headset Users Manual
Users Manual
5606-02600-222
It is forbidden to reproduce any part of this quick start guide without
the permission of Rapoo Technology Co., Ltd.
製造商：深圳雷柏科技股份有限公司 地址：深圳市坪山新區錦繡東路22號
公司電話：4008 887 778
S 100
Schnellstartanleitung
Guide de démarrage rapide
Quick Start Guide
Bluetooth Multi-Style Headset Bluetooth Multi-Style-Headset Casque Multi-Style Bluetooth
To turn on, press and hold the power button;
To turn off, press and hold the power button.
Volume up
Built-in microphone
Volume down
Power button / Turn on/off / Volume & Microphone
Turn on/off Pair and connect
Voice call Play/Pause
1. Press and hold the power button until the blue LED blinks
quickly when the headset is off.
2. Activate the Bluetooth feature on your device, and scan and
search for the headset.
The blue LED will blink once every 3s when Bluetooth
is disconnected.
The blue LED will blink rapidly when pairing.
The blue LED will blink once every 5s when Bluetooth
is connected successfully.
The red LED will be on when charging.
The blue LED will be on when fully charged.
Indicator / Charging / Pair and connect
The red LED blinks when the battery is low, please charge the device.
3. Select "Rapoo S100".
4. The blue LED will blink once every 5s when Bluetooth is
connected successfully.
Note: 1. The Bluetooth headset will save connected device
information automatically, you don’ t have to pair it again.
2. Some devices need a password when connecting, please enter
"0000".
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
IC RSS warning
This device complies with Industry Canada licence-exempt RSS standard (s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
IC Radiation Exposure Statement:
This equipment complies with IC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.