Realtek Semiconductor RTL8723BS 802.11b/g/n RTL8723BS Combo module User Manual En PAD 10 ABx
Realtek Semiconductor Corp. 802.11b/g/n RTL8723BS Combo module En PAD 10 ABx
Contents
User manual
WinBook 10” Pad Quick Start Guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation RF Exposure Information (SAR) This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with the EUT transmitting at the specified power level in different channels. The highest SAR value for the device as reported to the FCC is 1.42 W/kg when placed next to the body. CAUTION Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. Package contents If any of the items is missing or damaged, please contact your dealer immediately: • One Tablet • One AC adapter • One USB cable • This guide Tablet layout No. Name No. Name Front facing camera Micro SD card slot Touchscreen Headphone plug Windows button Mini HDMI port USB 3.0 port Micro USB 2.0 port No. Name No. Name Power Button Rear facing camera Volume up/down Speaker Microphone Pogo pin connector Charging your tablet If your tablet is just being unpacked from the box, you need to charge the tablet first. It will take around 4 to 5 hours to be fully charged. 1. Plug the USB head of the cable into the adapter. 2. Plug the micro-USB head of the cable into the micro-USB port on your tablet. 3. Plug the adapter into a wall-socket. Powering ON/OFF your tablet To power on your tablet Press and hold the power button down until the screen turn on. To power off your tablet Press and hold the power button for at least four seconds, and you will see an instruction appears in the middle of the screen, which is as shown below. Slide your finger on the screen downward, and the system will power off itself. Inserting a storage card Your tablet supports micro-SD cards with storage space ranging from 128M to 32G. You can insert the micro SD card and pull it out without powering down the tablet. To do so, follow the steps below. Install your Micro SD Card 1. Hold your tablet with front side up. 2. Insert your micro SD card in the direction as shown. Remove your Micro SD Card 1. Push and release the micro SD card. This will unlock the card. 2. Pull out the micro SD card. Specifications Processor l l l l Intel Bay Trail-T Z3735D Quad core (4C/4T) 1.33 GHz (Burst to 1.83GHz) 2MB L2 Cache Memory l l DDR3L-RS 1333 Default 1 GB Storage l l Single eMMC up to v4.5.1 Default 16GB (Max 64G) Wireless l Wi-Fi 802.11 b/g/n +BT4.0 l l l l l l l 10.1-inch 1280 x 800 LCD Support 5-points multi-touch Front HD camera: 2.0 M Rear HD camera: 2.0 M 1Cell, 1S2P Li-polymer 7600 mAh l l l l l 1 x micro-USB 2.0 port (Type B) 1 x USB 3.0 port (Type A) 1 x Mic/head phone jack combo 1 x mini-HDMI 1.3a 1 x micro-SD card slot (128M-32G) 1 x Digital MIC 1 x Pogo Pin connector (5-pin) Touchscreen Cameras Battery Input/Output l l Speaker & Mic l l Build-in Speaker x 2 Internal Digital MIC x 1 AC-Adapter l l l DC Output: 5V/2A/10 Watt Input Voltage: 100 ~ 240VAC Input Frequency: 47 ~ 63Hz Dimension (mm) l 268.4 (W) x 179 (H) x 10.75 (D) Weight l < 650 g (w/o adapter)
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf Linearized : No XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00 Format : application/pdf Creator : Sissel Title : Microsoft Word - En_PAD_10-AB.docx Create Date : 2014:06:18 01:33:39Z Creator Tool : Word Modify Date : 2014:06:19 17:11:01+08:00 Metadata Date : 2014:06:19 17:11:01+08:00 Keywords : Producer : Mac OS X 10.7.5 Quartz PDFContext Document ID : uuid:a0a3f79f-7cd1-4110-a5af-a2b9148d21ec Instance ID : uuid:d3f3a4f5-b2b8-45ab-8d18-339cf04e8f0e Page Count : 10 PDF Version : 1.4 Author : SisselEXIF Metadata provided by EXIF.tools