Red Point Positioning MODV7 RTLS Module with UWB and BLE User Manual Usermanual

Red Point Positioning Corporation RTLS Module with UWB and BLE Usermanual

Contents

Usermanual

RTLS MODULE User Manual for RTLS Module __________________________________________ Revision History revision date notes 1.0 July 2017 Initial release Overview____________________________________________ The RTLS Module is a full function RTLS subsystem that self-contained in a compact dimension. This module provides high accuracy positioning, UWB communication and Bluetooth communication abilities to user’s system. The figure below shows the block diagram of the RTLS Module. RTLS Module is a single PCB design and consists of a micro-controller, a radio transceiver, two on-board chip antennas, power management circuitry, and other peripherals. RTLS Module
Specification_________________________________________ Maximum Rating The modules should be stored indoor with relative humidity no greater than 80%, and temperature between 0 °C and 40 °C. Exposure to high heat is prohibited. Direct sunlight should also be avoided. Parameter Maximum Rating Temperature (°C) -40 ~ 85 Humidity (%) < 90 Supply Voltage (V) 2.8 ~ 3.6 Recommended Operating Conditions Parameter Min Max Temperature (°C) -40 85 Humidity (%) N/A <90 Power Supply The RTLS Module can be powered by an external DC power supply via half holes on the edge. The power supply should be clean with current rating of 200mA or higher. Typical Voltage and Current Consumption. Parameter Condition Min Typ Max Unit Voltage (V) (for both DW3.3 and 3.3) 2.8 3.3 3.6 V Current (A) on DW3.3 - 144.5 mA Current (A) on 3.3 - 10.85 mA
RF Transceiver The module operates in the unlicensed UWB band. The transmitted signal bandwidth is 500 MHz or greater. The units are calibrated such that the maximum radiated spectrum density is no more than -41 dBm/MHz and is fully compliant to the spectrum mask defined in FCC part 15. It is also compliant with the similar spectrum regulation for regions and countries including US, Canada and EU. Parameter Min Max Frequency Range (MHz) 3244 6999 10dB Bandwidth (MHz) 500 Center Frequency* (MHz) 3494.4 6489.6 Spectrum Density (dBm/MHz) N/A -41 *The center frequency is software configurable. See table below for details. The module is software configurable to operate on 4 UWB channels. The specification of each channel is given as below. Channel Number Fc (MHz) Fmin (MHz) Fmax (MHz) 1 3494.4 3244.8 3744 2 3993.6 3774 4243.2 3 4492.8 4243.2 4742.4 5 6489.6 6240 6739.2 Important Regulatory Information FCC Statements (United States) This device complies with Part 15 of the FCC Rules: Operation is subject to the following conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation Changes and Modifications not expressly approved by Redpoint Positioning Corp. can void your authority to operate this equipment under Federal Communications Commissions rules. Warning: To fulfill FCC Certification requirements, users who integrate RTLS module in their system must comply with the following regulations:
The RTLS Module modular transmitter must be labeled with its own FCC ID number, and, if the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: Contains FCC ID: 2ADX4-MODV7 IMPORTANT: This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation (FCC 15.19). IMPORTANT Antenna Information: To comply with FCC / ISED regulations limiting both maximum RF output power and human exposure to RF radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition must not exceed; Peak UWB Antenna Gain: 2.6dBi Peak BLE Antenna Gain: 2.2dBi Industry Canada (IC) Compliance Statements This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. CAUTION: Any changes or modifications not expressly approved by Redpoint Positioning Corp. could void the user’s authority to operate the equipment. The RTLS Module is labelled with its own IC ID. If the IC ID Certification Number is not visible while installed inside another device, then the device should display the label on it referring the enclosed module. In that case, the final product must be labelled in a visible area with the following: “Contains IC: 12677A-MODV7” Ce module est étiqueté avec son propre ID IC. Si le numéro de certification IC ID n'est pas visible lorsqu'il est installé à l'intérieur d'un autre appareil, l'appareil doit afficher l'étiquette sur le module de référence ci-joint. Dans ce cas, le produit final doit être étiqueté dans un endroit visible par le texte suivant: “Contains IC: 12677A-MODV7”
Interfaces RTLS module provides one UART interface, one SWD programming interface, and 6 general purpose IO to the user, all GPIOs may be configured as analog input as well. Category pin name type description Power PWR_IN power 3.3V GND ground Programming Interface SWDCLK input SWD programming interface SWDIO Input/output SWD programming interface nRESET input Reset input, active low User interface TXD output UART interface RXD input UART interface NFC RF NFC1 NFC input NFC antenna port NFC2 NFC input NFC antenna port Analog / GPIO AIN0 / DIO0 / RSTO0 input/output/analog GPIO / reset output 0 AIN1 / DIO1 / RSTO1 input/output/analog GPIO / reset output 1 AIN2 / DIO2 / INT0 input/output/analog GPIO / Interrupt 0 AIN3 / DIO3 / INT1 input/output/analog GPIO / Interrupt 1 AIN4 / DIO4 input/output/analog GPIO AIN5 / DIO5 input/output/analog GPIO
Mechanical and Packaging The dimension of the module is 32mm x 25 mm. There are 24 castellation hole pin-outs around the module, the pitch is 100mil (2.54mm). Following diagram shows outline of RTLS Module. Order Information Use the following part number when ordering module. Part Number Description 9101-0700 RTLS Module RTLS Module
Contact Us___________________________________________ Redpoint Positioning, Corp. 100 N Washington St Boston, MA 02114 phone: +1 (617) 207-4096 email: sales@redpointpositioning.com web: www.redpointpositioning.com

Navigation menu