Reflying Electronic MWC19 Three in one Charging Stand User Manual 1
Shenzhen Reflying Electronic Co., Ltd. Three in one Charging Stand 1
User Manual
2. Product Introduction
1.P ackage Content 4.L ED Indicator
3.I nstructions of Operation
3.F eatures
-Charging stand for iPhone and Apple watch, Airpod
-Input:DC 9V 3A
-QI wireless output 10W for Samsung, 7.5W for iPhone
-USB A 5V/1A
-Lightning out: 5V/2.1A
-Built-in Apple watch wireless magnetic charge module
Compatible With:
Apple Watch Series 3, Apple Watch Series 2,
Apple Watch Series 1, Apple Watch (1st generation),
iPhone X, iPhone 8 Plus, iPhone 8 , iPhone 7 Plus,
iPhone 7 , iPod touch (6th generation)
Three in one charge station with Apple Watch and
iPhone wireless charging module and iPhone
lightning connector.75% highly charging efficiency.
Well compatible with all Qi standard adaptors like
TI,IDT,PANASONIC ect…
Support most phones with quick charge function in
addition Samsung 10W, iPhone 7.5W quick charge.
Step 2: Put the back of your apple watch onto the
intergraded Magnetic Charge module of watch.
Step 3: Put the back of your phones (Like iPhone X,
Samsung S8 or other items with similar feature) onto
the intergraded Magnetic Charge area of Phones.
Step 4: Built-in one lightning connector ( 5V-2.1A) to
Step 5: There is one USB Port on the back of this station,
5V-1A output. Connecting one lightning or micro USB
Cable to charge for Apple or Android devices.
charge for devices with lightning receptacle, like
iPhone , iPad, iPod Airpods and Apple TV Controller.
MWC19
Step 1: Using the AC adaptor to power for this station.
One side connect to wall outlet,another side connect to
DC port(In the back of this station).
Three in one Charging Station
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be
installed and operated with minimum 20cm distance between the radiator your body: Use
only the supplied antenna.