Resolution RE118 Trident Environmental Sensor User Manual

Resolution Products, Inc. Trident Environmental Sensor

User Manual

Download: Resolution RE118 Trident Environmental Sensor User Manual
Mirror Download [FCC.gov]Resolution RE118 Trident Environmental Sensor User Manual
Document ID3211699
Application IDqtXlWcK97SxCX9M7tzm0IA==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize12.49kB (156157 bits)
Date Submitted2016-11-29 00:00:00
Date Available2016-11-29 00:00:00
Creation Date2016-11-25 11:38:40
Producing SoftwareAdobe PDF Library 15.0
Document Lastmod2016-11-25 11:38:40
Document TitleUser Manual
Document CreatorAdobe InDesign CC 2017 (Windows)

UID
LL
IN
STA
RE118 Interlogix® Compatible Trident™ Environmental Sensor
Trident is an integrated environmental sensor. It detects water
and reports extreme temperature conditions.
Features
•
•
•
•
Titanium probes for unmatched corrosion immunity
IP67 rated waterproof enclosure
GORE® vent equalizes enclosure pressure
5 year warranty
Enroll by placing the panel into wireless enrollment mode and
then sending an enrollment signal from the sensor. The flood
signal is enrolled by default. To Enroll the freeze and heat
zones, remove the sensor cover. Use a wire or a paper clip
to short the desired outer terminal to the center terminal,
shorting one terminal at a time.
DL ID Configuration
• Flood zone is the serial number shown on the device
• Freeze zone is the serial number with last digit
replaced with a 1
• Heat zone is the serial number with last digit replace
with a 2.		
Install by placing the sensor in the location requiring water or air
Wall Clip
temperature detection. If desired, the wall clip can be used to
secure the Trident sensor.
Optional Wall Clip Securing
• Remove the Trident body from wall clip.
• Secure wall clip to a wall
surface
withwith
a #6a screw.
#6 mounting
• Example
screw. securing locations are a wall, baseboard
• or
Example
cupboard.
securing locations: wall, baseboard or
Mounting Screw Hole
Detects water pooled under the sensor and reports extreme air
temperature conditions.
Default Temperature Trip Points
• Heat alarms when over 100.4° F (38° C)
• Heat restores when under 96.8° F (36° C)
• Freeze alarms when under 44.6° F (7° C)
• Freeze restores when over 48.2° F (9° C)
To replace the battery, insert a flat blade screwdriver into the
front slot and twist. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.
Front slot
Verify proper enrollment and operation using your control panel’s installation manual.
Specifications
Physical
Housing Dimensions
2.43 x 2.48 x 1.17 inches (6.2 x 6.3 x 3 cm)
Weight with Battery
1.34 ounces (38 grams)
Mounting Fastener
#6 screw (not provided)
Environmental
Operating Temperature
32 to 120 °F (0 to 49 °C)
Maximum Humidity
85% non-condensing relative humidity
Water Resistance
IP67 rated (waterproof for over 30 minutes at 1 meter depth)
Sensor Specifications
Frequency
319.5 MHz
Replacement Battery
Two Panasonic CR2032
Nominal Battery Life
10 years
Battery Voltage
3.0 VDC (Nominal) 2.3 VDC (Low)
Current Draw
20 mA (Maximum) 0.5 uA (Quiescent)
Transmitted Indications
Cover Tamper, Wall Tamper, Low Battery, Supervision
Certification
RE118
FCC, IC
Specifications subject to change without notice.
WARRANTY
FCC NOTICE
IC NOTICE
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,
including interference that may cause undesired operation.
Resolution Products, Inc. will replace products that are defective in
their first five (5) years.
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
Changes or modifications not expressly approved by the Resolution
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference Products, Inc. could void the user’s authority to operate this
equipment.
that may cause undesired operation of the device.
FCC ID: U5X-RE118
Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
TRADEMARKS
est autorisée aux deux conditions suivantes:
“Interlogix” is a trademark owned by United Technologies Electronic
(1) L’appareil ne doit pas produire de brouillage, et
Controls Inc.
(2) L’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en Resolution Products, Inc. products will function with Interlogix
systems. However, no Resolution product is produced by, endorsed
compromettre le fonctionnement.
by, or is officially associated with Interlogix.
IC: 8310A-RE118
Resolution recommends verifying proper enrollment and operation,
per control panel installation instructions, at installation.
47-0028-01 • RevA • 2016-11-10
Tech Support Line (877) 260-5578
www.ResolutionProducts.com

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Language                        : en-US
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.6-c137 79.159768, 2016/08/11-13:24:42
Create Date                     : 2016:11:25 11:38:40-06:00
Metadata Date                   : 2016:11:25 11:38:40-06:00
Modify Date                     : 2016:11:25 11:38:40-06:00
Creator Tool                    : Adobe InDesign CC 2017 (Windows)
Instance ID                     : uuid:39111a1c-9134-469c-a99d-68646ae1cfdd
Original Document ID            : xmp.did:44e2b0f0-c3c1-164d-b557-efe7684ac6e9
Document ID                     : xmp.id:370843ac-8de9-934f-993c-8d78a7fa6820
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:247a83ab-e538-5b4d-804e-63a50863e34c
Derived From Document ID        : xmp.did:a09e886a-7568-db49-b6ca-dd93bd637c62
Derived From Original Document ID: xmp.did:44e2b0f0-c3c1-164d-b557-efe7684ac6e9
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 2017 (Windows)
History Changed                 : /
History When                    : 2016:11:25 11:38:40-06:00
Format                          : application/pdf
Producer                        : Adobe PDF Library 15.0
Trapped                         : False
Page Count                      : 2
Creator                         : Adobe InDesign CC 2017 (Windows)
EXIF Metadata provided by EXIF.tools
FCC ID Filing: U5X-RE118

Navigation menu