Resolution RE203 Security Panic Transmitter User Manual manual

Resolution Products, Inc. Security Panic Transmitter manual

manual

Resolution
RE203 Wireless Panic Transmitter
User and Installation Instructions
Introduction
The RE203 Wireless Panic Transmitter is a wireless 1-button transmitter for security system use.
Typical use of this device is for sending a panic alarm to the system. The transmitter is shown in
Figure 1.
Figure 1: RE203
Successful activation of the transmitter is indicated by a short, bright LED flash.
The Wireless Panic Transmitter uses a small lithium coin cell battery, designed to provide long battery
life.
Transmitter Programming
Each RE203 Wireless Panic Transmitter is shipped with a unique serial number pre-programmed into
the transmitter. Upon installation, the RE203 must be programmed into the security control panel. The
control panel's documentation should be consulted for full instructions.
Specifications
Dimensions: 1.125 x 1.5 x 0.5”
RF transmission frequency: 345.025MHz
Operating Temperature: 10º to 120ºF (-12º to 49ºC)
Battery Type: CR2032 Lithium Coin Cell
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the Resolution Engineering, Inc could void the
user's authority to operate this equipment.
FCC ID: U5X-RE203
IC Notice
This product meets the applicable Industry Canada technical specifications/Le présent materiel est
conforme aux specifications techniques applicables d’Industrie Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
IC: 8310A-RE203

Navigation menu