Resolution RE318 Trident Environmental Sensor User Manual

Resolution Products, Inc. Trident Environmental Sensor

User Manual

Download: Resolution RE318 Trident Environmental Sensor User Manual
Mirror Download [FCC.gov]Resolution RE318 Trident Environmental Sensor User Manual
Document ID3214508
Application IDrLNyoY+LfyxwPWsElyHbYg==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize15.05kB (188174 bits)
Date Submitted2016-12-01 00:00:00
Date Available2016-12-01 00:00:00
Creation Date2016-11-23 14:41:08
Producing SoftwareAdobe PDF Library 15.0
Document Lastmod2016-11-25 11:42:43
Document TitleUser Manual
Document CreatorAdobe InDesign CC 2017 (Windows)

UID
LL
IN
STA
RE318 DSC® Compatible Trident™ Environmental Sensor
Trident is an integrated environmental sensor. It detects water
and reports extreme temperature conditions.
Features
•
•
•
•
Titanium probes for unmatched corrosion immunity
IP67 rated waterproof enclosure
GORE® vent equalizes enclosure pressure
5 year warranty
Enroll by placing the panel into wireless enrollment mode and
then sending an enrollment signal from the sensor. The flood
zone is enrolled by removing the battery tabs or tamper the
sensor. The freeze and heat zones are enrolled by removing
the sensor cover and shorting the desired terminals.
ESN ID Configuration
• Flood zone is the serial number shown on the device
• Freeze zone is the serial number with last digit
replace with a 1.
• Heat zone is the serial number with last digit replace
with a 2.		
Install by placing the sensor in the location requiring water or air
Wall Clip
temperature detection. If desired, the wall clip can be used to
secure the Trident sensor.
Optional Wall Clip Securing
• Remove the Trident body from wall clip.
• Secure wall clip to a wall
surface
withwith
a #6a screw.
#6 mounting
• Example
screw. securing locations are a wall, baseboard
• or
Example
cupboard.
securing locations: wall, baseboard or
Detects water pooled under the sensor and reports extreme air
temperature conditions.
Mounting Screw Hole
Temperature Trip Points
• Heat alarms when over 100.4° F (38° C)
• Heat restores when under 96.8° F (36° C)
• Freeze alarms when under 44.6° F (7° C)
• Freeze restores when over 48.2° F (9° C)
To replace the battery, insert a flat blade screwdriver into the
front slot and twist. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.
Front slot
Verify proper enrollment and operation using your control panel’s installation manual.
Specifications
Physical
Housing Dimensions
2.43 x 2.48 x 1.17 inches (6.2 x 6.3 x 3 cm)
Weight with Battery
1.34 ounces (38 grams)
Mounting Fastener
#6 screw (not provided)
Environmental
Operating Temperature
32 to 120 °F (0 to 49 °C)
Maximum Humidity
85% non-condensing relative humidity
Water Resistance
IP67 rated (Waterproof for over 30 minutes at 1 meter depth)
Sensor Specifications
Frequency
433.92 MHz
Replacement Battery
Two Panasonic CR2032
Nominal Battery Life
10 years
Battery Voltage
3.0 VDC (Nominal) 2.3 VDC (Low)
Current Draw
20 mA (Maximum) 0.5 uA (Quiescent)
Transmitted Indications
Cover Tamper, Wall Tamper, Low Battery, Supervision
Certification
RE318
FCC, IC
Specifications subject to change without notice.
WARRANTY
FCC NOTICE
IC NOTICE
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,
including interference that may cause undesired operation.
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Changes or modifications not expressly approved by the
Resolution Products, Inc. could void the user’s authority to operate
this equipment.
Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
FCC ID: U5X-RE318
Resolution Products, Inc. will replace products that are defective in
their first five (5) years.
(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
IC: 8310A-RE318
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
TRADEMARKS
DSC is a trademark owned by TYCO Safety Products Canada LTD.
Resolution Products Inc. products will function with DSC systems.
However, no Resolution product is produced by, endorsed by, nor
is officially associated with DSC. Resolution recommends verifying
proper enrollment and operation, per control panel installation
instructions, at instillation.
47-0028-03 • RevA • 2016-11-10
Tech Support Line (877) 260-5578
www.ResolutionProducts.com

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Language                        : en-US
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.6-c015 84.158975, 2016/02/13-02:40:29
Create Date                     : 2016:11:23 14:41:08-06:00
Metadata Date                   : 2016:11:25 11:42:43-06:00
Modify Date                     : 2016:11:25 11:42:43-06:00
Creator Tool                    : Adobe InDesign CC 2017 (Windows)
Instance ID                     : uuid:f3467a79-c2dc-42b9-b745-ec29de23746a
Original Document ID            : xmp.did:44e2b0f0-c3c1-164d-b557-efe7684ac6e9
Document ID                     : xmp.id:e368f62f-4149-354a-b228-42be451282cc
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:a40266ca-7508-a340-8351-6a38aa2784ad
Derived From Document ID        : xmp.did:5bf953ab-b66e-e34b-bfbf-0bb6eb79f3b3
Derived From Original Document ID: xmp.did:44e2b0f0-c3c1-164d-b557-efe7684ac6e9
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 2017 (Windows)
History Changed                 : /
History When                    : 2016:11:23 14:41:08-06:00
Format                          : application/pdf
Producer                        : Adobe PDF Library 15.0
Trapped                         : False
Page Count                      : 2
Creator                         : Adobe InDesign CC 2017 (Windows)
EXIF Metadata provided by EXIF.tools
FCC ID Filing: U5X-RE318

Navigation menu