Rhine Electronics Co 7209T Transmitter of Remote Control User Manual

Rhine Electronics Co Ltd Transmitter of Remote Control

User manual

Download: Rhine Electronics Co 7209T Transmitter of Remote Control User Manual
Mirror Download [FCC.gov]Rhine Electronics Co 7209T Transmitter of Remote Control User Manual
Document ID1025850
Application IDZu7xsTyg9yUbzc0gLbMq3Q==
Document DescriptionUser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize1.94kB (24305 bits)
Date Submitted2008-11-05 00:00:00
Date Available2008-11-05 00:00:00
Creation Date2008-10-20 10:35:56
Producing SoftwareFinePrint pdfFactory v1.31 (Windows 2000 Chinese)
Document Lastmod2008-10-26 12:21:23
Document TitleMicrosoft Word - 7208T英文使用手冊.doc
Document Creatorhttp://www.fineprint.com
Document Author: je

INSTRUCTIONS FOR OPERATION
SETING THE OPERATING CONTROLS
1.This unit operates on two 3 volts battery (not included).
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2. Store the controller away from excess heat or humidity .
3. This remote control unit is required with 16 code combinations. To prevent
possible interference from or to other remote units such as garage door
openers, car alarm or security system . If you find that your fan and light
kit go on and off without using your control , simply change the combination
code in your transmitter and receiver .
4.Operation buttons on the panel of transmitter .
HIGH key – For fan High speed .
MED key – For fan Medium speed .
LOW key – For fan Low speed .
REV key – For fan speed reverse .
OFF key – For fan speed off .
UP LIGHT CONTROL key – For light brightness and ON/OFF control .
DOWN LIGHT CONTROL key – For light brightness and ON/OFF control .
5.Start the fan :
Press the selected speed button to run the fan at the desired .
6.Turn off the fan :
Press the OFF button .
7.Light control :
Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .
One of the important feature of this control is AUTO-RESUME . After power
on , it allows the light return to where it was off .
Page :
2-1
GENERAL INFORMATION :
This REMOTE controller is designed to separately control your
ceiling fan speed and light brightness . The Light
ON/OFF button will control the light brightness ON/OFF .
The red indicator on the transmitter will light when the button is pressed .
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED
CONTROLLER
A. Setting the code on your new transmitter .
1. Remove battery cover .
Press firmly below arrow and slide battery cover off .
2. Slide code switches to your choice of UP and DOWN position .
Factory setting is all UP . Do not use this setting .
Use ball point pen or small screwdriver .
Slide firmly up or down .
B. Setting the code on your new Receiver unit .
1. Slide code switches to the same positions as set on your transmitter .
They must be set to same positions to work .
2. Replace battery cover on transmitter .
3. Make sure the code switches are on the left positions .
NOTICE :
The changes or modifications not expressly approved by the
party responsible for compliance could void user’s authority
to operate the equipment .
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATIONS IS SUBJECT
INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFEERENCE THAT MAY CAUSE UNDESRIED OPERATION.
The term “ IC:” before the radio certification number only signifies that Industry Canada Technical
specifications were met.
Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
age : 2-2

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Create Date                     : 2008:10:20 10:35:56Z
Modify Date                     : 2008:10:26 12:21:23+08:00
Page Count                      : 2
Author                          : je
Producer                        : FinePrint pdfFactory v1.31 (Windows 2000 Chinese)
Creation Date                   : 2008:10:20 10:35:56Z
Mod Date                        : 2008:10:26 12:21:23+08:00
Metadata Date                   : 2008:10:26 12:21:23+08:00
Title                           : Microsoft Word - 7208T英文使用手冊.doc
Creator                         : je
EXIF Metadata provided by EXIF.tools
FCC ID Filing: CHQ7209T

Navigation menu