Rhine Electronics Co 7229T Transmitter User Manual

Rhine Electronics Co Ltd Transmitter Users Manual

User manual

INSTRUCTIONS FOR OPERATIONSETING THE OPERATING CONTROLS1. This unit operates on a 1.5 volts battery *2 (not included). To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use .2. Store the controller away from excess heat or humidity .3. This remote control unit is required with 24bit code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system . 4. Operation buttons on the panel of transmitter . OFF button - FAN and LIGHT OFFFAN SPEED button – fan speed(speed1~3 or 4)LIGHT button - Light ON/OFF or DimmerN/W button – Start up/shut down natural wind modeREV button – Fan reverse Warm weather/Cool weatherTIME button – Start up/shut timer 9108051
CONTROL SWITCH – For light brightness and ON/OFF control . 5. Start the fan Press the FAN speed button .6. Turn off the fan :Press the OFF button .7. Light control :Turn the light on or off by only touching the LIGHT CONTROL button .Keep pressing the button in excess of 0.7 second it becomes a dimmer ,the light varies cyclically in 0.8 second .One of the important feature of this control is AUTO-RESUME . After power on , it allows the light return to where it was off .GENERAL INFORMATION :This REMOTE controller is designed to separately control your ceiling fan speed and light brightness . The Light ON/OFF button will control the light brightness ON/OFF .The LED indicator on the transmitter will light when the Function button is pressed .INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FANSPEED CONTROLLER1. Setting the code on your new transmitter .Within 60 seconds of turning the AC power on, press and hole the FAN ON/OFF button for 5 seconds. The receiver will then lock in the chosen frequency. If your fan has a light it it will blink twice, for fans without lights check operation using the transmitterNOTICE : The changes or modifications not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment .This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause9108052

Navigation menu