Rhine Electronics Co 7233T Transmitter User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3239647
Application ID	RPDUcZMFGj84O6rbm8sfMg==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	11.26kB (140738 bits)
Date Submitted	2016-12-26 00:00:00
Date Available	2016-12-26 00:00:00
Creation Date	2016-11-15 19:15:15
Producing Software	OpenOffice 4.1.1
Document Lastmod	0000-00-00 00:00:00
Document Title	Users Manual
Document Creator	Writer
Document Author:	ETC

INSTRUCTIONS FOR OPERATION
SETING THE OPERATING CONTROLS
1. This unit operates on a 3 volts battery (not included).
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2.
Store the controller away from excess heat or humidity .
3.
This remote control unit is required with 24bit code combinations. To prevent
possible interference from or to other remote units such as garage door
openers, car alarm or security system .
4. Operation buttons on the panel of transmitter .
FAN SPEED button – fan speed(speed 1~6)
( 6 ~1)
REV button – Fan reverse Warm weather/Cool
weather
LIGHT button - Light ON/OFF or Dimmer
FAN OFF button - FAN OFF
CONTROL SWITCH – For light brightness and
ON/OFF control .
910805
5. Start the fan
Press the FAN speed button .
6. Turn off the fan :
Press the OFF button .
7. Light control :
Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .
GENERAL INFORMATION :
This REMOTE controller is designed to separately control your
ceiling fan speed and light brightness . The Light
ON/OFF button will control the light brightness ON/OFF .
The LED indicator on the transmitter will light when the Function button is pressed .
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN
SPEED CONTROLLER
1. Setting the code on your new transmitter .
Within 60 seconds of turning the AC power on, press and hole the FAN ON/OFF
button for 5 seconds. The receiver will then lock in the chosen frequency.
If your fan has a light it it will blink twice, for fans without lights check operation using the
transmitter
NOTICE :
The changes or modifications not expressly approved by the
party responsible for compliance could void user’s authority
to operate the equipment .
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no
change to the antenna or the device is permitted. Any change to the antenna or the device
could result in the device exceeding the RF exposure requirements and void user’s authority to
operate the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may cause
910805

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 2
Language                        : zh-TW
Title                           : 貼於產品本體之FCC標籤圖解範例
Author                          : ETC
Creator                         : Writer
Producer                        : OpenOffice 4.1.1
Create Date                     : 2016:11:15 19:15:15+08:00

EXIF Metadata provided by EXIF.tools