Rhine Electronics Co 8BT7097T Remote Control Transmitter User Manual
Rhine Electronics Co Ltd Remote Control Transmitter
User Manual
INSTRUCTIONS FOR OPERATION Page : 2-1 SETING TI-[E OPERATING CONTROLS 1. This unit operates on a 9 volts battery (not included). To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use . 2. Store the controller away from excess heat or humidity . 3. This remote control unit is requipped with 16 code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system 4 If you find that your fan and light kit go on and ofl" without using your control , simply change the combination code in your transmitter and receiver . 4.0peration buttons on the panel of transmitter . HIGH key — For fan High speed . MED key — For fan Medium speed . DOW key — For fan Low speed . OFF key - For fan speed 05. REV key - For fan spud Reverse . LIGHT CONTROL key ~ For light brightness and ON/OFF control . 5.Start the fan : . Press the selected speed button to run the fan at the desired . 6.Turn off the fan : Press the OFF button . 7.Light control : Turn the light on or off by only touching the LIGHT CONTROL button. Keep pressing the button' in excess of 0.7 second it becomes a dimmer, the light varies cyclically in 0.8 second. One of the important feature of this control is AUTO-RESUME . Afier power on , it allows the light return to where it was of . Page : 2-2 GENERAL INFORMATION : This REMOTE controller is designed to separetly control your ceiling fan speed and light brightness . There are five buttons (HIGHT , MED , LOW , OFF , REV) to control the fan speed and off . The Light Dimmer button will control the light brightness dimer and ON/OFF . The red indicator on the transmitter will light when the button is pressed . INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER A. Setting the code on your new transmitter . lo Remove battery cover . Press firmly below arrow and slide battery cover off . 2. Slide code switches to your choice of UP and DOWN position . Factory setting is all UP . Do not use this setting . Use ball point pen or small screwdriver . Slide firmly up or down . B. Setting the code on your new Receiver unit . 1. Slide code switches to the same positions as set on your transmitter . They must be set to same positions to work . 2. Replace battery cover on transmitter . 3. Make sure the code switches are on the lefi positions . NOTICE : The changes or modifications not expressly appproved by the party responsible for compliance could void user‘s authority to operate the equipment . Model zUC7097T FCC ID : CHQ8BT7097T This device complies with part 15 of the FCC mles ‘ Operation is subject to the following two conditions . (1) This device may not cause harmful interference and (2) This device must accept any interference received , Including interference that may cause undesired operation . MADE IN TAIWAN
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Modify Date : 2001:12:27 15:00:21+08:00 Create Date : 2001:12:27 14:57:26+08:00 Creator : Acrobat 5.0 Scan Plug-in for Windows Page Count : 2 Mod Date : 2001:12:27 15:00:21+08:00 Creation Date : 2001:12:27 14:57:26+08:00 Producer : Acrobat 5.0 Scan Plug-in for Windows Metadata Date : 2001:12:27 15:00:21+08:00EXIF Metadata provided by EXIF.tools