Rhine Electronics Co GTX742 Transmitter User Manual

Rhine Electronics Co Ltd Transmitter Users Manual

User manual

INSTRUCTIONS FOR OPERATIONSETING THE OPERATING CONTROLS1. This unit operates on a 12 volts battery *1 (not included). To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use .2. Store the controller away from excess heat or humidity .3. This remote control unit is required with 20bit code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system . 4. Operation buttons on the panel of transmitter . UP button – Desktop upSTOP button – STOPDOWN button – Desktop DOWN9108051
GENERAL INFORMATION :This REMOTE controller can be remote controlled table goes up or stop or downInstructions for installing and controller actions1. Setting the code on your new transmitter .Within 60 seconds of turning the AC power on, press and hold the STOP button for 5 seconds. The receiver will then lock in the chosen frequency. check operation using the transmitterNOTICE : The changes or modifications not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment .This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause9108052

Navigation menu