Rockrose Technology WDTX21 Remote Control For Residential Irrigation System User Manual Installation R4 HO Comments

Rockrose Technology LLC Remote Control For Residential Irrigation System Installation R4 HO Comments

Users Manual

  INFORMATION TO USER   This device complies with Part 15 of the FCC Rules.  Operation is subject to the following two conditions:  (1) This device may not cause harmful  interference,  and  (2)  This  device  must  accept  any  interference  received,  including  interference  that  may  cause  undesired operation. This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential installation.  This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.  However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. •         Reorient or relocate the receiving antenna •         Increase the separation between the equipment and receiver •         Connect the equipment into an outlet on a circuit different from that to which the receiver is connected •         Consult the dealer or an experienced radio/TV technician for help Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.   Before  you  begin  installation,  take  the  following steps: 1. Replace your timer’s battery so that your sprinkler times are saved. 2. Make sure your timer is set to your high season settings – those settings when your sprinkler times are longest. 3. If your timer has a “Water Budget” or “Seasonal Adjustment” feature make sure it is set to 100%. Detailed Installation Instructions: 1.  After disconnecting the power to the timer, attach one of the BLACK wires from the WaterDex Receiver  to  each  of  the  timer’s  power  terminal’s (typically labeled 24VAC). The BLACK wires can be connected to either terminal in any order. 2.  Remove the wire(s) from the timer’s terminal marked  COMM  or  Common  and  connect  either one of the BLUE wires from the WaterDex Receiver to this terminal.  3.  Using  the  supplied  wire  nut,  connect  the wire(s)  removed  from  the  COMM  or  Common terminal to the second BLUE wire from the WaterDex Receiver. Again, the BLUE wires can be connected in any order. NOTE: The GRAY wire  is an  antenna and not connected to the timer.   4.  Installation is now complete and power may be  reconnected  to  the  timer.  The  LEDs  on  the WaterDex Receiver will briefly flash in an alternating pattern. 5.  To  pair  the  WaterDex  Receiver  to  the Remote Control, press the recessed button at  the bottom of the Receiver. The Receiver’s Green “Link” LED will flash indicating that it is ready to be paired with the WaterDex Remote Control.  6.  Remove the back cover from the WaterDex Remote Control and install two “AA” batteries.  The LED on the Remote Control will flash for 10 seconds while  connecting  to  the  WaterDex  Receiver.  The “Link” LED on the Receiver will remain solidly lit when successfully paired.  7.  The WaterDex Remote Control transmits the watering  setting  whenever the dial  is  moved. The LED will flash for 10 seconds while transmitting. If the LED  continues  blinking  rapidly,  this  indicates  low battery. Log on to www.WaterDex.com and enter your ZIP code  to  get  your  local  setting.  Set  your  Remote Control  to  the  suggested  value  and  start  saving MONEY!

Navigation menu