Rongta Technology AP02 E-POS User Manual Sales Literature

XIAMEN RONGTA TECHNOLOGY CO.,LTD. E-POS Sales Literature

Contents

Sales Literature User Manual

X I A M E N R O N G TA T E C H N O L O G Y C O . , LT D .Website: www.rongtatech.comWorking Temperature:-10ÿ—40ÿWorking Humidity:20%—85%Storing Temperature:-20ÿ—70ÿ Storing Humidity:5%—95% Hardware Name:170910Hardware Version :CSoftware Name:S1709Software Version:1.0.0Project Technical ParameterCPU 1.4GHZ Quad-coreStorage512MB4GB EmmcInternetG S M 855 0 ( 3 1 . 5 ±1.5 d Bm), G S M 1 9 0 0WCDMA Band II(22.5±1.5dBm),WCDMABandV ( ±1.5dBm)BT4.0 dual mode (< 0dBm)2.4GWIFI b/g/n(<1777 dBm)GPS3F-1/E Building,NO.195 Gaoqishe,Gaodian Village,Dianqian Street Office,Huli District.FCC Requirement changes or modifications not expressly approved by the party Responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is Subject to the following two conditions: (1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technician for help.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.The device is designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue when properly worn on the Body and set a SAR limit of 4.0 W/kg averaged over ten gram of tissue when use in handheld. The highest SAR value reported under this standard during product Certification for use when properly worn on the body is 1.534W/kg and use in handheld is 1.959W/kg. For body operation, this device has been tested and meets FCC RF exposure guidelines when used with any accessory that contains no metal and that positions a minimum of 5mm from the body. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.(28.5 1. 5dBm)±177

Navigation menu