Roseman Engineering RM915 Spread Spectrum Transmitter User Manual rm915

Roseman Engineering Ltd. Spread Spectrum Transmitter rm915

Users Manual

Draft
User Manual
RM915
Notes:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
The digital portion of the transceiver has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits a
re designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause har
mful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
Connect the equipment
into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Installation
When the module is attached to Roseman vehicle unit, the antenna should be
installed on the top inner side of the windowpane of the vehicle.
Warning!
The user and the installer should be aware that changes and modifications not
expressly approved by Roseman Engineering Ltd. could void the user’s authority
to operate the equipment.
NOTE: The antenna used for this transmitter must be installed to normally
provide
minimum separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter

Navigation menu