Ruckus SZ™ 100 And VSZ E™ Alarm Event Reference Guide For SmartZone 3.5 Smart Zone (GA) (SZ100/v SZ E) Sz100Vsze Guide20170407
2017-04-07
User Manual: Ruckus SmartZone 3.5 (GA) Alarm and Event Reference Guide (SZ100/vSZ-E)
Open the PDF directly: View PDF 
Page Count: 346 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Contents
- About This Guide
- Revision History
- Alarm and Event Management
- Alarm Types
- Accounting Alarms
- AP Authentication Alarms
- AP Communication Alarms
- AP LBS Alarms
- AP State Change Alarms
- Authentication Alarms
- Authentication server not reachable
- Authentication failed over to secondary
- Authentication fallback to primary
- AD/LDAP connectivity failure
- Bind fails with AD/LDAP
- Bind success with LDAP, but unable to find clear text password for the user
- RADIUS fails to connect to AD NPS server
- RADIUS fails to authenticate with AD NPS server
- Fails to establish TLS tunnel with AD/LDAP
- Control and Data Plane Interface Alarms
- Cluster Alarms
- New node failed to join
- Node removal failed
- Node out of service
- Cluster in maintenance state
- Cluster backup failed
- Cluster restore failed
- Cluster upgrade failed
- Cluster application stopped
- Node bond interface down
- Node physical interface down
- Cluster node rebooted
- Cluster node shut down
- Disk usage exceed threshold
- Cluster out of service
- Cluster upload AP firmware failed
- Cluster add AP firmware failed
- Unsync NTP time
- Cluster upload KSP file failed
- Configuration backup failed
- Configuration restore failed
- AP Certificate Expired
- Configuration Alarms
- Data Plane Alarms
- Data plane configuration update failed
- Data plane disconnected
- Data plane physical interface down
- Data plane process restarted
- Data plane license is not enough
- Data plane upgrade failed
- Data plane of data center side fails to connect to the CALEA server
- Data Plane fails to connects to the other data plane
- Data Plane DHCP IP Pool usage rate is 100 percent
- IPMI Alarms
- Licensing Interface Alarms
- SCI Alarms
- System Alarms
- Threshold Alarms
- Tunnel Alarms - Access Point
- Events Types
- Accounting Events
- AP Communication Events
- AP discovery succeeded
- AP managed
- AP rejected
- AP firmware updated
- AP firmware update failed
- Updating AP firmware
- Updating AP configuration
- AP configuration updated
- AP configuration update failed
- AP pre-provision model mismatched
- AP swap model mismatched
- AP WLAN oversubscribed
- AP illegal to change country code
- AP configuration get failed
- Rogue AP
- SSID-spoofing rogue AP
- Mac-spoofing rogue AP
- Same-network rogue AP
- Ad-hoc network device
- Rogue AP disappeared
- AP LBS Events
- AP Mesh Events
- EMAP downlink connected to MAP
- EMAP downlink disconnected from MAP
- EMAP uplink connected to MAP
- EMAP uplink disconnected from MAP
- MAP disconnected
- MAP downlink connected
- MAP downlink connected to EMAP
- MAP downlink disconnected from EMAP
- RAP downlink connected to MAP
- MAP uplink connected to EMAP
- MAP uplink disconnected from EMAP
- MAP uplink connected to RAP
- MAP uplink connected to MAP
- Mesh state updated to MAP
- Mesh state updated to MAP no channel
- Mesh state updated to RAP
- Mesh state update to RAP no channel
- MAP downlink connected to MAP
- MAP downlink disconnected from MAP
- RAP downlink disconnected from MAP
- AP State Change Events
- AP rebooted by user
- AP rebooted by system
- AP disconnected
- AP IP address updated
- AP reset to factory default
- AP channel updated
- AP country code updated
- AP channel updated because dynamic frequency selection (DFS) detected a radar
- AP change control plane
- AP connected
- AP deleted
- AP heartbeat lost
- AP tagged as critical
- AP cable modem interface down
- AP brownout
- AP cable modem power-cycled by user
- AP smart monitor turn off WLAN
- AP client load balancing limit reached
- AP client load balancing limit recovered
- AP WLAN state changed
- AP capacity reached
- AP capacity recovered
- AP cable modem interface up
- AP cable modem soft-rebooted by user
- AP cable modem set to factory default by user
- AP health high latency flag
- AP health low capacity flag
- AP health high connection failure flag
- AP health high client count flag
- AP health high latency clear
- AP health low capacity clear
- AP health high connection failure clear
- AP health high client count clear
- Primary DHCP AP is down
- Primary DHCP AP is up
- Secondary DHCP AP is down
- Secondary DHCP AP is up
- Primary or secondary DHCP AP detects 90% of the configured total IPs
- Both primary and secondary DHCP server APs are down
- AP NAT gateway IP failover detected for particular VLAN pool
- AP NAT gateway IP fall back detected for particular VLAN pool
- NAT VLAN capacity affected detected by NAT gateway AP at zone due to three (3) consecutive NAT gateway AP IPs are down for particular VLAN pool
- NAT VLAN capacity restored detected by NAT gateway AP due to (at least) one out of the three (3) consecutive NAT gateway AP IP were down is now up
- AP NAT failure detected by SZ due to three (3) consecutive NAT gateway APs are down
- AP health high airtime utilization flag
- AP health high airtime utilization clear
- AP Authentication Events
- Radius server reachable
- Radius server unreachable
- LDAP server reachable
- LDAP server unreachable
- AD server reachable
- AD server unreachable
- Wechat ESP authentication server reachable
- WeChat ESP authentication server unreachable
- WeChat ESP authentication server resolvable
- WeChat ESP authentication server unresolvable
- WeChat ESP DNAT server reachable
- WeChat ESP DNAT server unreachable
- WeChat ESP DNAT server resolvable
- WeChat ESP DNAT server unresolvable
- AP USB Events
- Authentication Events
- Authentication server not reachable
- Authentication failed over to secondary
- Authentication fallback to primary
- AD/LDAP connected successfully
- AD/LDAP connectivity failure
- Bind fails with AD/LDAP
- Bind success with LDAP, but unable to find clear text password for the user
- RADIUS fails to connect to AD NPS server
- RADIUS fails to authenticate with AD NPS server
- Successfully established the TLS tunnel with AD/LDAP
- Fails to establish TLS tunnel with AD/LDAP
- Authorization Events
- Control and Data Plane Interface Events
- Client Events
- Client authentication failed
- Client joined
- Client failed to join
- Client disconnected
- Client connection timed out
- Client authorization successfully
- Client authorization failed
- Client session expired
- Client roaming
- Client logged out
- Client roaming disconnected
- Client blocked
- Client grace period
- Onboarding registration succeeded
- Onboarding registration failed
- Remediation succeeded
- Remediation failed
- Force DHCP disconnected
- WDS device joined
- WDS device left
- Client is blocked because of barring UE rule
- Client is unblocked because of barring UE rule
- Start CALEA mirroring client
- Stop CALEA mirroring client
- Cluster Events
- Cluster created successfully
- New node joined successfully
- New node failed to join
- Node removal completed
- Node removal failed
- Node out of service
- Cluster in maintenance state
- Cluster back in service
- Cluster backup completed
- Cluster backup failed
- Cluster restore completed
- Cluster restore failed
- Cluster node upgrade completed
- Entire cluster upgraded successfully
- Cluster upgrade failed
- Cluster application stopped
- Cluster application started
- Cluster backup started
- Cluster upgrade started
- Cluster leader changed
- Node bond interface down
- Node bond interface up
- Node IP address changed
- Node physical interface down
- Node physical interface up
- Cluster node rebooted
- NTP time synchronized
- Cluster node shutdown
- Cluster upload started
- Cluster upload completed
- Cluster upload failed
- SSH tunnel switched
- Cluster remove node started
- Node back in service
- Disk usage exceed threshold
- Cluster out of service
- Initiated moving APs in node to a new cluster
- Cluster upload vSZ-D firmware started
- Cluster upload vSZ-D firmware completed
- Cluster upload vSZ-D firmware failed
- Cluster upload AP firmware started
- Cluster upload AP firmware completed
- Cluster upload AP firmware failed
- Cluster add AP firmware started
- Cluster add AP firmware completed
- Cluster add AP firmware failed
- Cluster name is changed
- Unsync NTP time
- Cluster upload KSP file started
- Cluster upload KSP file completed
- Cluster upload KSP file failed
- Configuration backup started
- Configuration backup succeeded
- Configuration backup failed
- Configuration restore succeeded
- Configuration restore failed
- AP Certificate Expired
- AP Certificate Updated
- Configuration restore started
- Upgrade SSTable failed
- Reindex Elastic Search finished
- Initiated APs contact APR
- Node IPv6 address added
- Node IPv6 address deleted
- Configuration Events
- Configuration updated
- Configuration update failed
- Configuration receive failed
- Incorrect flat file configuration
- Zone configuration preparation failed
- AP configuration generation failed
- End-of-life AP model detected
- VLAN configuration mismatch on non-DHCP/NAT WLAN
- VLAN configuration mismatch on a DHCP/NAT WLAN
- Data Plane Events
- Data plane discovered
- Data plane discovery failed
- Data plane configuration updated
- Data plane configuration update failed
- Data plane rebooted
- Data plane heartbeat lost
- Data plane IP address updated
- Data plane updated to a new control plane
- Data plane status update failed
- Data plane statistics update failed
- Data plane connected
- Data plane disconnected
- Data plane physical interface down
- Data plane physical interface up
- Data plane packet pool is under low water mark
- Data plane packet pool is under critical low water mark
- Data plane packet pool is above high water mark
- Data plane core dead
- Data plane process restarted
- Data plane discovery succeeded
- Data plane managed
- Data plane deleted
- Data plane license is not enough
- Data plane upgrade started
- Data plane upgrading
- Data plane upgrade succeeded
- Data plane upgrade failed
- Data plane of data center side successfully connects to the CALEA server
- Data plane of data center side fails to connect to the CALEA server
- Data plane successfully connects to the other data plane
- Data plane fails to connects to the other data plane
- Data plane disconnects to the other data plane
- Start CALEA mirroring client
- Stop CALEA mirroring client
- Data plane DHCP IP pool usage rate is 100 percent
- Data plane DHCP IP pool usage rate is 80 percent
- IPMI Events
- Licensing Interface Events
- SCI Events
- Session Events
- System Events
- No LS responses
- LS authentication failure
- {produce.short.name} connected to LS
- {produce.short.name} failed to connect to LS
- {produce.short.name} received passive request
- {produce.short.name} sent controller information report
- {produce.short.name} received management request
- {produce.short.name} sent AP info by venue report
- {produce.short.name} sent query venues report
- {produce.short.name} sent associated client report
- {produce.short.name} forwarded calibration request to AP
- {produce.short.name} forwarded footfall request to AP
- {produce.short.name} received unrecognized request
- Syslog server reachable
- Syslog server unreachable
- Syslog server switched
- Generate AP config for plane load rebalance succeeded
- Generate AP config for plane load rebalance failed
- FTP transfer
- FTP transfer error
- File upload
- Email sent successfully
- Email sent failed
- SMS sent successfully
- SMS sent failed
- Process restart
- Service unavailable
- Keepalive failure
- Resource unavailable
- Data plane of data center side successfully connects to the CALEA server
- Data plane of data center side fails to connect to the CALEA server
- Data Plane of data center side disconnects to CALEA server
- Data plane successfully connects to the other data plane
- Data plane fails to connects to the other data plane
- Data plane disconnects to the other data plane
- Start CALEA mirroring client in data plane
- Stop CALEA mirroring client in data plane
- Data plane DHCP IP pool usage rate is 100 percent
- Data plane DHCP IP pool usage rate is 80 percent
- All data planes in the zone affinity profile are disconnected
- CALEA UE Matched
- ZD AP migrating
- ZD AP migrated
- ZD AP rejected
- ZD AP migration failed
- Database error
- Database error
- Threshold Events
- CPU threshold exceeded
- Memory threshold exceeded
- Disk usage threshold exceeded
- CPU threshold back to normal
- Memory threshold back to normal
- Disk threshold back to normal
- License threshold exceeded
- Rate limit threshold surpassed
- Rate limit threshold restored
- Rate limit for TOR surpassed
- The number of users exceed its limit
- The number of devices exceeded its limit
- Tunnel Events - Access Point (AP)
- Data plane accepted a tunnel request
- Data plane rejected a tunnel request
- Data plane terminated a tunnel
- AP created a tunnel
- AP tunnel disconnected
- AP SoftGRE tunnel fails over primary to secondary
- AP SoftGRE tunnel fails over secondary to primary
- AP SoftGRE gateway reachable
- AP SoftGRE gateway not reachable
- Data plane set up a tunnel
- AP secure gateway association success
- AP is disconnected from secure gateway
- AP secure gateway association failure
- Tunnel Events - Data Plane
- Index