Ruoey Lung Enterprise RC-RF11D Remote Controller User Manual
Ruoey Lung Enterprise Corp. Remote Controller
User manual
Ruoey Lung Enterprise Corp.
No.17, Lu-Kung South 2 Road, Chang-Pin Industrial Park, Lu-Kang, Changhua, Taiwan
RC-RF11D-433
Remote Controller Operation Guide
IMPORTANT:
Read advisory information in the owner’s
manual carefully before using this product.
The potential for electrical shock exists if
electrical components are not installed or
operated properly.
Notice : The changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment.
IMPORTANT NOTE:
To comply with the FCC RF exposure compliance requirements,
no change to the antenna or the device is permitted. Any change
to the antenna or the device could result in the device exceeding
the RF exposure requirements and void user’s authority to operate
the device.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FOOT UP BUTTON
Press and hold to raise the foot section.
Release to stop.
FOOT DOWN BUTTON
Press and hold to lower the foot section.
Release to stop.
FLAT BUTTON
Press and hold for 2 sec to the “FLAT”
preset profile.
HEAD UP BUTTON
Press and hold to raise the head
section. Release to stop.
HEAD DOWN BUTTON
Press and hold to lower the head
section. Release to stop.
LIGHT BAR BUTTON
Press to turn on and off the light bar
at the bed.LED BUTTON
Press to turn on and off the flash light on
the remote controller simultaneously.
MASSAGE BUTTON
Press to turn on and off the
massage motor at the bed.ZERO-G BUTTON
Press to lift the bed to the “ZERO-G”
preset profile
ANTI-SNORE BUTTON
Press to lift the bed to the
“ANTU-SNORE” preset profileLOUNGE BUTTON
Press to lift the bed to the “LOUNGE”
preset profile