SIRIUS Sxabb2 Quickstartguide User Manual Quick Start Guide

Sxabb2 Quickstartguide SXABB2_QuickStartGuide

2016-03-11

User Manual: SIRIUS Sxabb2 Quickstartguide

Open the PDF directly: View PDF PDF.
Page Count: 6

23
What’s in the Box?
Indoor/Outdoor
Home Antenna
Radio Dock Adapters
XM/SXM1 (Pre-installed)
XMp3
SIRIUS
SXM2
Home Power Adapter Power Cord
SiriusXM BB2 Portable Speaker Dock
power
volume
aux in
Remote Control
select
mute
band/
fav
display
menu
memo/
info
Radio Connector Module A
(Pre-installed)
Radio Connector Module B
Portable Speaker Dock Controls and Connections
Radio Dock Adapter
Provides alignment and
support for your Radio.
(Interchangeable for
different model Radios.)
Radio Dock Connector
Connector for your Radio.
(Interchangeable for different
model Radios.)
Front View
power
volume
aux in
Aux In Button
Pressing and holding until the Aux In
light is on switches audio output to
Aux In input. Pressing and holding
again switches to satellite radio.
Aux In Light
When on, Portable
Speaker Dock is set
to Aux In input.
Power On/Low Battery Light
The light is steady blue when
the Portable Speaker Dock is
powered on; the light blinks
when the batteries are nearly
discharged.
Power Button
Pressing and holding until the
Power On light is on turns the
power On. Pressing and holding
again turns the power Off.
Top View
volume
power aux in
Volume/Mute Control
Sliding a finger in a circular motion
on the volume control increases or
decreases the volume level. Pressing
twice mutes the audio and a circle of
blue lights will flash while muted.
Volume Level
Lights
Lights indicate
volume level.
Bottom View
Battery Compartment
Requires 8 C size alkaline
batteries (sold separately).
Radio Connector Module Lock
Locks and unlocks the
Radio Connector Module.
Side View
Headphones
Connection for
headphones.
Aux In
Connection for
audio from an
external device.
aux in
Rear View
Antenna Cable Storage
Storage area for the
Indoor/Outdoor Home
Antenna cable.
Antenna Connection
Connection for the
Indoor/Outdoor Home
Antenna.
Antenna Storage
Storage area for the
Indoor/Outdoor Home Antenna.
14V DC Power Connection
Connection for the
Home Power Adapter.
14V DCantenna
45
STEP 1: Identify the Radio Dock Adapter and Radio Connector Module Combination for your Radio
There are four Radio Dock Adapters included with your Portable Speaker Dock, which are designed to align
your particular Radio with the Portable Speaker Dock’s connector, and to provide support for your Radio while
it is in the dock. Please note that Radio Dock Adapter XM/SXM1 is pre-installed in the Portable Speaker Dock.
There are also two Radio Connector Modules included with your Portable Speaker Dock, which provide the
correct connector for your particular Radio. Please note that Radio Connector Module A is pre-installed in
the Portable Speaker Dock.
Both the Radio Dock Adapters and the Radio Connector Modules have a sticker affixed on the bottom which
identifies them. Turn them over to identify them.
The four combinations of the Radio Dock Adapters and Radio Connector Modules are shown with the
Radios each combination supports. Find the correct combination for your Radio, and note the adapter and
module you will use.
Radio Dock Adapter XM/SXM1
(Pre-Installed)
Radio Connector Module A
(Pre-installed)
Top View
Top View
Bottom View
+=
Onyx
Edge
XpressRCi & XpressRC
XpressR
Xpress
XpressEZ
XM/SXM1
234567890
direct
jump
FM
menu
1
124
3567890
d
i
s
p
l
a
y
s
e
a
r
c
h
m
e
n
u
m
e
m
.
j
u
m
p
p
r
e
.
d
i
r
.
6
jump
fmmenu
7 8 9 0
#
1 2 3 4 5
SXM1
XM
Combination 1
Everything is
pre-installed. Skip
ahead to step 3.
Combination 2
Follow steps 2A,
2B, and 2C.
Radio Dock Adapter SXM2
Radio Connector Module B
Top View
Top View
Bottom View
+=
Lynx
SXM2 SXM2
Combination 3
Follow steps 2A
and 2C. Skip step 2B.
Combination 4
Follow steps 2A
and 2C. Skip step 2B.
Radio Dock Adapter XMp3i
Radio Connector Module A
(Pre-installed)
Top View
Top View
Bottom View
+=
XMp3
XMp3i
XMP3
XMp3
SIRIUS
SIRIUS
jump
menu sel
Radio Dock Adapter SIRIUS
Radio Connector Module A
(Pre-installed)
Top View
Top View
Bottom View
+=
Sportster 5
Stratus, & Stratus 4, 5, 6
Starmate 3, 4, 5
Starmate 8
234567890direct
jump
FM
menu
1
67
STEP 2: Install the Radio Connector Module and Radio Dock Adapter
In this step, you will install the Radio Connector Module, if necessary, and Radio Dock Adapter, according to the
combination for your Radio that you determined from the previous step.
•Combination 1: Skip this step and go to step 3. The adapter and module are already installed in the
Portable Speaker Dock.
•Combination 2: You will remove the pre-installed adapter, remove the pre-installed module, install Radio
Connector Module B, and install Radio Dock Adapter SXM2.
•Combination 3 & 4: You will remove the pre-installed adapter, and install the Radio Dock Adapter for
your Radio. Follow steps 2A and 2C, and skip step 2B.
STEP 2A: Removal of the Radio Dock Adapter
The Radio Dock Adapters are constructed
from precision molded plastic. During
removal, extra care must be taken to
not bend, force, or otherwise stress the
adapter.
Remove the Radio Dock Adapter from the
Portable Speaker Dock by placing a coin,
or your fingernail, into the slot at the back
of the adapter, and pulling it up.
STEP 2B: Removal and Installation of
the Radio Connector Module
This step applies only to Combination 2. For all other combinations, skip ahead to step 2C.
a. Turn the Portable Speaker Dock upside down, and locate
the Radio Connector Module Lock.
b. While grasping the Portable Speaker Dock as shown, place
a small coin into the center slot on the lock and turn the
lock counterclockwise to unlock the Radio Connector
Module.
c. Turn the Portable Speaker Dock upright. Place a finger
in each of the finger recesses in the Radio Connector
Module, grasp, and gently pull the module straight up and
out of the Portable Speaker Dock.
power
volume
aux in
Coin
Radio Connector
Module Lock
Radio Connector Module Top View
Finger Recess Finger Recess
d. Insert the Radio Connector
Module B into the dock as shown.
e. Keeping your hand on the module to prevent it from
falling out, turn the dock upside down again.
f. Place the coin into the center slot on the lock again,
and turn the lock clockwise to lock the Radio Connector
Module into the dock. Turn the dock upright again.
STEP 2C: Installation of the Radio Dock Adapter
The Radio Dock Adapters are constructed from precision
molded plastic. During installation, extra care must be taken to
not bend, force, or otherwise stress the adapter.
Place the Radio Dock Adapter for your Radio into the dock. Take care to align the tabs on the underside of the
adapter with the corresponding receptacles on the Portable Speaker Dock, so as not to bend or break these
tabs. Gently press the adapter into the dock until it is seated.
volume
power aux in
Coin
Radio Connector
Module Lock
volume
power aux in
89
The Portable Speaker Dock can operate on either batteries or by using the Home Power Adapter if you are near an outlet.
To use your Portable Speaker Dock on-the-go:
1. Open the battery compartment on the bottom
of the Portable Speaker Dock. Insert 8 C-cell
alkaline batteries in the battery compartment.
2. Replace the battery cover.
TIP! When the battery life is getting low the
power light will blink and your Portable
Speaker Dock may not play.
TIP! It is not recommended to keep batteries
in the Portable Speaker Dock for an extended
length of time. Remove the batteries when not
in use.
To use your Portable Speaker Dock with the Home
Power Adapter:
1. Plug the Home Power Adapter into the
connector labeled 14V DC at the rear of the
Portable Speaker Dock.
2. Plug the other end of the Home Power Adapter
into a standard wall outlet.
STEP 3: Install the Batteries or Home Power Adapter
14V DCantenna
STEP 4: Install the Indoor/Outdoor Home Antenna
1. Plug the antenna cable into the antenna
connector at the left rear.
2. Wrap the antenna cable into the storage
area.
3. Place the antenna into the storage area
at the rear of the Portable Speaker Dock.
Align the mounting holes on the bottom
of the antenna with the 4 mounting
brackets on the rear of the Portable
Speaker Dock. Push the antenna over
the mounting brackets and then slide
the antenna down slightly to secure it in
place.
4. Open the antenna clamshell so that the
top of the antenna is facing the sky. TIP! If you are using the Portable Speaker Dock indoors,
consult the User Manual beginning on page 30 for
instructions for indoor antenna placement.
STEP 6: Adjust the Audio Level
If your Radio has an Audio Level or Line Out Level adjustment feature in the Settings menu when it’s
docked in the Portable Speaker Dock, you should set this level to the maximum volume that does not
cause distorted sound. This will maximize the audio quality. Refer to the User Guide which accompanied
your Radio for instructions on how to set the level.
Some Radios do not have this adjustment available when docked in the Portable Speaker Dock. These
Radios set their level automatically to optimize the sound quality. No adjustment is necessary.
The installation is complete. Sit back and enjoy your favorite programming on SiriusXM Radio!
STEP 5:
Insert Radio and Turn On the Portable Speaker Dock
1. Be sure the Portable Speaker Dock is powered
off.
2. Align the Radio with the Radio Dock Adapter.
3. Once aligned, gently press the Radio down so
that it slides down the Radio Dock Adapter
and onto the connector, until it is fully seated
in the Portable Speaker Dock.
4. Press and hold the Power button on the top of
the Portable Speaker Dock until the Power On
light is on.
5. If your Radio did not power on, press the
Power button on your Radio.
power
volume
aux in
2345678 90
direct
jump
FM
menu
1
power
Sirius XM Radio Inc.
1221 Avenue of the Americas
New York, NY 10020
1.866.635.2349
© 2012 Sirius XM Radio Inc. Sirius, XM and all related marks and logos are trademarks of Sirius XM Radio Inc.
SXABB2 Portable Speaker Dock QSG 120104a
siriusxm.com

Navigation menu