SMK FC010 Remote Controller User Manual

SMK Corporation Remote Controller User Manual

User manual

2To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.Batteries or batteries installed apparatus shall not be exposed to excessive heat such as sunshine, fire or the like.CAUTIONThe use of optical instruments with this product will increase eye hazard. As the laser beam used in this INTERNET TV BOX is harmful to eyes, do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only.This label is located on the laser protective housing inside the enclosure.This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.These graphical symbols are located on the AC adaptor.NOTEThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:–Reorient or relocate the receiving antenna.–Increase the separation between the equipment and receiver.–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.–Consult the dealer or an experienced radio/TV technician for help.Precautions•To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus.•The set is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the set itself has been turned off.•Install this unit so that the AC power cord can be unplugged from the wall socket immediately in the event of trouble.•The nameplate is located on the bottom of the unit.Installing•Do not install this equipment in a confined space, such as a bookshelf or similar unit.FCC WARNINGYou are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.The shielded Interface cable (LAN cable) must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment should be installed and operated with at least 20 cm and more between the radiator and person's body (excluding extremities: hands, wrists, feet and ankles).IC Radiation Exposure Statement:This equipment complies with IC radiation exposure limits set forth for uncontrolled equipment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated with at least 20 cm and more between the radiator and person's body (excluding extremities: hands, wrists, feet and ankles).When using the unit, use indoors.Contains FCC ID : AK8NSZGT1Contains IC : 4250A-DWMW034This class B digital apparatus complies with Canadian ICES-003.Owner's RecordThe model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product.Model No.______________Serial No.______________For Customers in the USAIf this product is not working properly, please call 1-866-909-7669.For Customers in CanadaIf this product is not working properly, please call 1-877-602-2008 for Peace of Mind Warranty Replacement service.For other product related questions please contact our Customer Information Service Center at 1-877-899-7669 or write to us at: Customer Information Service 115 Gordon Baker Road, Toronto, Ontario, M2H 3R6WARNINGOperation is subject to the following two conditions;(1) this device may not cause interference, and(2) this device must accept any interference received,including interference that may cause undesired operation of the device.Note：Description inside red frames is no related to this equipment RXT1000-0801E.
Preparing for use Inserting the batteries Remove the cover from the remote controller rear and insert the 2 Size AA Manganese batteries. Set the batteries in the correct position. Specifications Power source 2 Size AA Manganese batteries Operating temperature -10℃～ 50℃ Storage temperature -20℃～55℃

Navigation menu