ST Engineering Telematics Wireless DMMR1 DMRR Reader User Manual
Telematics Wireless Ltd. DMRR Reader Users Manual
Users Manual
DRAFT
Page 1 of 5
User Manual
DMMR
Rev 1
Note:
The digital portion of the transceiver has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
DRAFT
Page 2 of 5
Installation
Here we shall add the Installation Instructions which shall include the following
statements:
1. The user and the installer should be aware that changes and
modifications not expressly approved by Telematics Wireless could
void the user’s authority to operate the equipment.
2. The antenna used for this transmitter must be installed to normally
provide minimum separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other
antenna or transmitter.
3. The transmitter duty cycle shall be equal or less than 20%.
4. The DMMR unit will be fully assembled (including antenna and cover)
at the factory/manufacturer (see pictures below)
DRAFT
Page 3 of 5
DRAFT
Page 4 of 5
DRAFT
Page 5 of 5