ST Engineering Telematics Wireless EMMR1 EMMR Reader User Manual 16373 rev2

Telematics Wireless Ltd. EMMR Reader User Manual 16373 rev2

Users Manual Revision 2

DRAFT User Manual EMMR Rev 2.Note: The digital portion of the transceiver has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
DRAFT Installation Here we shall add the Installation Instructions which shall include the following statements: 1. The user and the installer should be aware that changes and modifications not expressly approved by Telematics Wireless could void the user’s authority to operate the equipment. 2. The antenna used for this transmitter must be installed to normally provide minimum separation distance of at least 20 cm from all person and must not be co-located or operating in conjunction with any other antenna or transmitter. 3. The transmitter duty cycle shall be equal or less than 5%. The EMMR unit will be fully assembled (including antenna and cover) at the factory/manufacturer (see picture below).
DRAFT

Navigation menu