ST Engineering Telematics Wireless LCRSA Low Cost Repeater (Water Meter) User Manual Manual
Telematics Wireless Ltd. Low Cost Repeater (Water Meter) Manual
Manual
MM REV 6/14/2007
…………………………………………………………………………………………………………………………
Master Meter, Inc.
-
---
101 Regency Parkway, Mansfield, TX 76063 www.mastermeter.com
Toll Free: 800-765-6518 -
---
Main Line: 817-842-8000 -
--- FAX: 8178428100 info@mastermeter.com
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONSINSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
LOW COST REPETER
LOW COST REPETERLOW COST REPETER
LOW COST REPETER
-
-
-
-
SOLAR
SOLAR SOLAR
SOLAR
Download manual from Master Meter Web site. http://www.mastermeter.com/en/downloads.html
http://www.mastermeter.com/en/downloads.htmlhttp://www.mastermeter.com/en/downloads.html
http://www.mastermeter.com/en/downloads.html
M8
178428100
FCC ID NTALCRSA
NTALCRSANTALCRSA
NTALCRSA
The user and the installer should be aware that changes and modifications to the equipment not expressly approved by Master Meter could void warranty and the
user’s authority to operate the equipment. Professionally trained personnel should install the equipment.
NOTE: - The antenna used for this transceiver must be installed to normally provide minimum separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with any other antenna or transmitter.
- Transmission duty cycle is limited by its design not to exceed 1.2%
For optimum performance
• Unit should be installed upright (parallel to the stamp) and not on an angle, and high as possible from ground.
• Unit should be located at open space or in close box with windows, not in close metal box.
• The unit solar cell should be located with direction to the sun track.
• Unit should be located close as possible to the meter, to be located. UNIT SIGN
FIELD PROGRAMABLE PARAMETERS
FIELD PROGRAMABLE PARAMETERSFIELD PROGRAMABLE PARAMETERS
FIELD PROGRAMABLE PARAMETERS
DEFAULT PARAMETERS
DEFAULT PARAMETERSDEFAULT PARAMETERS
DEFAULT PARAMETERS
USER CODE
USER CODEUSER CODE
USER CODE
5 digit USER CODE
USER CODEUSER CODE
USER CODE
CLEAR
TRANSMISSION INTERVAL
TRANSMISSION INTERVALTRANSMISSION INTERVAL
TRANSMISSION INTERVAL
PROGRAMMABLE TRANSMISSION INTERVAL
TRANSMISSION INTERVALTRANSMISSION INTERVAL
TRANSMISSION INTERVAL
0
TRANSMISSION
TRANSMISSION TRANSMISSION
TRANSMISSION
ON\OFF TRANSMISSION
TRANSMISSIONTRANSMISSION
TRANSMISSION
OFF
LIST
LISTLIST
LIST
PROGRAMMABLE LIST
LISTLIST
LIST
ON
RECEIVE CYCLE
RECEIVE CYCLERECEIVE CYCLE
RECEIVE CYCLE
FIX RECEIVE CYCLE
RECEIVE CYCLERECEIVE CYCLE
RECEIVE CYCLE
14400 SEC
RECEIVE TIME
RECEIVE TIMERECEIVE TIME
RECEIVE TIME
FIX RECEIVE TIME
RECEIVE TIMERECEIVE TIME
RECEIVE TIME
90
RECEIVE TYPE
RECEIVE TYPERECEIVE TYPE
RECEIVE TYPE
FIX RECEIVE TYPE
RECEIVE TYPERECEIVE TYPE
RECEIVE TYPE
ETMW - WB
ATTENTION:
ATTENTION:ATTENTION:
ATTENTION:
The digital portion of the transceiver has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1.) Reorient or relocate the receiving antenna.
2.) Increase the separation between the equipment and receiver.
3.) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4.) Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
o
p
eration.