ST Engineering Telematics Wireless XMETER50 Water Meter User Manual Revised

Users Manual Revised

Draft

User Manual

ETMW-LCD

Note:

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference that may cause

undesired operation.

The digital portion of the transceiver has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Draft

Installation

Here we shall add the installation Instruction which shall include the following

statements:

The user and the installer should be aware that changes and modifications not

expressly approved by Telematics Wireless could void the user’s authority to operate

the equipment.

NOTE: The antenna used for this transmitter must be installed to normally provide

minimum separation distance of at least 20 cm from all persons and must not be

co-located or operating in conjunction with any other antenna or transmitter.

The ETMW-LCD transmission duty cycle is limited by its design not to exceed

0.10%.