STEELMATE T022 TPMS sensor User Manual
STEELMATE CO., LTD. TPMS sensor
User manual
Important notice ' This unit is only for vehicles with 12V DC and its tire pressure is within 3.5 Bar/50 Psi ' This unit should be installed by a professional technician according to the installation manual ' TPMS (tire pressure monitoring system) is designed to help the driver to monitor the tire irregularities. lt is the driver's responsibility to react promptly to alerts. Abnormal tire pressure should be corrected ASAP. ' This is a wireless RF product, therefore, the signal may be affected by the poor environment, RF interference, low sensor battery or a damaged sensor. I We do not guarantee or assume liability for the loss of the TPMS sensors. FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’ 5 authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving an- tenna. ' Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Technical specification Sensor installation Sensor: Operating frequency: Battery voltage: Operating temperature: Pressure range: Air pressure unit 433.92MHZ 3V -20°C~+60°C/ 4”F~140°F 0~3.5 Bar/0~50Psi 1 Bar = 14.5 Psi = 100K Pa = 1.02 Kgi‘lcm2 Sensor battery replacement 2% Unscrew the valve cap insert the dustproof cover into Screw in the nut Screw on the sensor .1 the valve stem Unscrew the nut Unscrew the sensor Take out the washer Unscrew the sensor cover by using the sensor tool Replace the battery Follow the "Sensor Installation" steps above Tighten up the nut to the sensor by using the spanner Check air leakage by spraying soapy water STEELMATE CO. LTD. N: "'4 t‘eptl‘g Street * llu New. 0‘ /'-:tng-’.lt.a‘ cm, Limrgnang v R 515w , w w steel-mate com " Steclmate Co Ltd All rights reserved The trademark patent and copyright are owned by Steelmate Co , Ltd The nght to change the drawn and specmcatmns reserved
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes XMP Toolkit : 3.1-701 Modify Date : 2014:04:28 16:57:33+08:00 Create Date : 2014:04:28 16:57:28+08:00 Metadata Date : 2014:04:28 16:57:33+08:00 Creator Tool : Adobe Acrobat 7.0 Format : application/pdf Document ID : uuid:afda0389-b0e7-497c-8462-782956ac4fda Instance ID : uuid:4175acb4-4726-4374-8278-6eca9c316cf5 Producer : Adobe Acrobat 7.0 Image Conversion Plug-in Page Count : 1 Creator : Adobe Acrobat 7.0EXIF Metadata provided by EXIF.tools