Safety Technology 34701 Indoor Motion Detector, 433.92MHz User Manual
Safety Technology International, Inc. Indoor Motion Detector, 433.92MHz
User Manual
Warranty Information: Safety Technology International, Inc. warrants to the original consumer/purchaser what this product shall be free of defects in material and workmanship under normal use and circumstances for a period of one (1) year from the original date of purchase. Wireless Indoor PIR Motion Detector Model STI-34701 Important Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference that may be received, including interference that may cause undesired operation. Changes or modifications not expressly approved by STI could void the user’s authority to operate this equipment. This product meets the applicable industry Canada Technical specifications. Le Présent matériel est conforme aux spécifications techniques applicables d’Industrie Canada. Model: 34701 FCC ID: TXL34701 Program sensor before installation IC: 6335A-34701 Technical Support: Contact STI at 800-888-4784 ext. 202 Additional Wireless Alert Series Products: STI-34099 STI-34104 STI-V34104 STI-34108 STI-34188 STI-34101 STI-34151 STI-34201 STI-34301 STI-34401 STI-34501 STI-34601 STI-34701 STI-34751 Single Channel Slave Receiver 4-Channel Receiver 4-Channel Voice Receiver 8-Channel Receiver 8-Zone Relay Board Solar Powered Driveway Monitor Sensor Battery Powered Driveway Monitor Sensor Wireless Mailbox Alert Sensor Wireless Garage Sentry Sensor Wireless Universal Alert Sensor Wireless Pool Alert Sensor Wireless Doorbell Button Indoor Wireless PIR Outdoor Wireless PIR STI-6200WIR STI-6200WIR4 STI-6400WIR STI-6400WIR4 STI-6517A STI-6517B STI-30104 STI-30105 STI-34105 STI-34106 STI-34109 Wireless Fire Extinguisher Theft Stopper Wireless Fire Extinguisher Theft Stopper w/Receiver Wireless Exit Stopper Door Alarm Wireless Exit Stopper Door Alarm with Receiver Stopper Station Shield with Sound Stopper Station Shield with Sound and Transmitter Lamp Controller Extended Antenna Voltamax 12VDC (500mA) Power Supply Keyfob Repeater Features: · · · · · · · APYROFLEX™ IR sensor and Highbar™ signal processing for superior performance. 44 ft. range and 90 degree field of view (45 degrees to each side). Mountable on flat-wall or 45 degree corner. Cover tamper. Strong, reliable RF signal. 6-8 year battery life of CR123A battery. Low Battery indication. Safety Technology International, Inc. 2306 Airport Rd • Waterford, MI 48327 Phone: 248-673-9898 • Fax: 248-673-1246 info@sti-usa.com • www.sti-usa.com Safety Technology International (Europe) Ltd. Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999 Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only) E-mail: info@sti-europe.com • Web: www.sti-europe.com Printed in USA Safety Technology International, Inc. “We Protect The Things That Protect You.” Inst. 34701 JAN2013 Programming Instructions: Specifications: 1. Remove cover by releasing snap closure located at the bottom center. · Mounting Hardware: #6 screw 2. Put receiver in program mode (refer to receiver instructions for programming). · Mounting Height: 7.5ft (ideal height) 3. Remove Mylar tab from battery. Unit should immediately program into receiver, if not · Replacement battery: CR123A 1500mAH · Temperature range: 0°F to 120°F · Housing dimensions: 3.7” X 2.37” X 1.65” press the tamper switch. 4. Motion sensitivity: · Normal sensitivity: jumper on BOTH PINS Specifications subject to change without notice. · High sensitivity: remove jumper Side View 7.5 ft. Mounting Instructions: 1. Release holding tab and remove PCB (see internal view for tab location). 2. Remove screw knockouts for mounting. 3. Replace PCB. Make sure bug / insulation foam is installed. LOCK DOWN SHORT RANGE 10 ft 30 ft 20 ft MIDDLE RANGE 40 ft LONG RANGE 4. Mount at 7.5ft (ideal height) with provided screws and optional anchors. 5. Replace cover. Unit immediately goes into 3 minute walk test. To reset walk test, remove Top View 44 ft cover and reattach. Walk Test LED: 44 ft 1. LED lights for 3 minutes when motion sensed (only during walk test). 2. Wireless transmissions are sent for each detection; so walk test can be used for receiver test as well. 3. Motion stops (locks out) sensing for 20 seconds after LED flashes. 44 ft 4. When complete, replace cover fixing screw. BATTERY Operation: 1. Motion stops (locks out) transmitting wireless sensor alarms for 3 minutes after MYLAR TAB sending an alarm transmission. This is to conserve battery life. 2. Walk Test LED does not activate in normal operating mode, only works during walk test. SENSITIVITY JUMPER 3. Tamper: when cover is opened. BUG FOAM 4. Supervisory: every hour. PCB HOLDING TAB MOTION SENSOR TAMPER AND WALK TEST SWITCH WALK TEST LED -2- -3-
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : Adobe XMP Core 5.0-c060 61.134777, 2010/02/12-17:32:00 Create Date : 2013:01:14 08:59:30-05:00 Metadata Date : 2013:01:14 08:59:31-05:00 Modify Date : 2013:01:14 08:59:31-05:00 Creator Tool : Adobe InDesign CS5 (7.0.4) Page Image Page Number : 1, 2 Page Image Format : JPEG, JPEG Page Image Width : 256, 256 Page Image Height : 256, 256 Page Image : (Binary data 9590 bytes, use -b option to extract), (Binary data 9012 bytes, use -b option to extract) Instance ID : uuid:849f5f34-b1c2-244f-ad08-5eeb9708d76a Document ID : xmp.did:09801174072068118083AA79C595C5DD Original Document ID : xmp.did:09801174072068118083AA79C595C5DD Rendition Class : proof:pdf History Action : created, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved History Instance ID : xmp.iid:09801174072068118083AA79C595C5DD, xmp.iid:1F7F4A7F092068118083AA79C595C5DD, xmp.iid:207F4A7F092068118083AA79C595C5DD, xmp.iid:A2129B92092068118083AA79C595C5DD, xmp.iid:A9129B92092068118083AA79C595C5DD, xmp.iid:11DBB81C0A2068118083AA79C595C5DD, xmp.iid:67FA0C3B0A2068118083AA79C595C5DD, xmp.iid:E4E76C530D2068118083AA79C595C5DD, xmp.iid:BFED6185132068118083AA79C595C5DD, xmp.iid:4DF19F8F132468118083AA79C595C5DD, xmp.iid:4EF19F8F132468118083AA79C595C5DD, xmp.iid:5CDBAF11222468118083AA79C595C5DD, xmp.iid:2148FA2CB62468118083AA79C595C5DD, xmp.iid:30C48E5CCA24681188C6B1491C18469F, xmp.iid:7C4CFC77872268118A6DAC86C33896F6, xmp.iid:552571D0AD2468118A6DAC86C33896F6, xmp.iid:3A71CF3DAE2468118A6DAC86C33896F6, xmp.iid:61751AB1B12468118A6DAC86C33896F6 History When : 2012:12:21 09:58:50-05:00, 2012:12:21 10:08:08-05:00, 2012:12:21 10:08:08-05:00, 2012:12:21 10:08:41-05:00, 2012:12:21 10:11:08-05:00, 2012:12:21 10:12:33-05:00, 2012:12:21 10:13:23-05:00, 2012:12:21 10:37:14-05:00, 2012:12:26 13:25:43-05:00, 2012:12:26 13:30:34-05:00, 2012:12:26 13:42:52-05:00, 2012:12:27 08:53:33-05:00, 2012:12:27 08:55:02-05:00, 2013:01:03 11:23:29-05:00, 2013:01:14 08:24:20-05:00, 2013:01:14 08:31:33-05:00, 2013:01:14 08:34:37-05:00, 2013:01:14 08:59:19-05:00 History Software Agent : Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0, Adobe InDesign 7.0 History Changed : /;/metadata, /metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata, /;/metadata Doc Change Count : 210 Format : application/pdf Producer : Adobe PDF Library 9.9 Trapped : False Page Count : 2 Creator : Adobe InDesign CS5 (7.0.4)EXIF Metadata provided by EXIF.tools