Samsung Electro Mechanics SWL-2100P PCI Card Spread Spectrum Transceiver User Manual 2000486 2100P PCI Report

Samsung Electro Mechanics PCI Card Spread Spectrum Transceiver 2000486 2100P PCI Report

Contents

Antenna and User Install Manual

Download: Samsung Electro Mechanics SWL-2100P PCI Card Spread Spectrum Transceiver User Manual 2000486 2100P PCI Report
Mirror Download [FCC.gov]Samsung Electro Mechanics SWL-2100P PCI Card Spread Spectrum Transceiver User Manual 2000486 2100P PCI Report
Document ID140452
Application IDpi0gAUqINzSF00Z7CSOUeA==
Document DescriptionAntenna and User Install Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize6.64kB (82994 bits)
Date Submitted2001-03-15 00:00:00
Date Available2001-03-15 00:00:00
Creation Date2001-02-16 15:48:30
Producing SoftwareAcrobat PDFWriter 4.05 for Windows
Document Lastmod2001-02-16 15:48:59
Document Title2000486_2100P-PCI_Report
Document Creator2000486_2100P-PCI_Report_REV-1.doc - Microsoft Word

360 Herndon Parkway
Suite 1400
Herndon, VA 20170
http://www.rheintech.com
21 ANTENNA INSTRUCTION MANUAL
Certification Report For: Samsung
Document Number: 2000486
Page 39
INSTALLATION MANUAL
Introduction
This manual does not substitute your wireless LAN card’s user’s guide. This installation guide
must be read for more detailed information about your wireless LAN
card’s use, care and maintenance, including important safety information.
The Samsung Wireless LAN Card has two antenna connectors for
attaching external antennas for coverage area extension. Use only the
supplied antenna. Unauthorized antennas, modifications, or attachments could damage the
wireless LAN card and may violate regulations governing radio devices.
FCC WARNING
The SWL-2000E complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions;
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
RF SAFETY WARNING
While installing and operating this transmitter and antenna combination the radio frequency
exposure limit of 1mW/cm 2 may be exceeded at distances close to the antennas installed.
Therefore, the user must maintain a minimum distance of 20 cm from the antenna. Note: The
SWL-2000E has been tested and found to comply with the limits for a Class B digital device and a
low power transmitter, according to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to resolve the problem
by one or more of the following measures; Reorient or relocate the receiving antenna. Increase
the separation between the equipment and the receiver. Connect the equipment to an output on
a circuit different from that to which the receiver is connected. Consult the dealer or an
experienced radio/TV technician for help.
INSTALLATION OF THE EXTERNAL ANTENNA
The user is responsible for ensuring that the public is not
exposed to radio frequency energy levels in excess of the FCC
guidelines. Humans cannot be within 20 cm (8 inches) of the front of the antennas. If such a
situation occurs, the user is responsible for placing the
appropriate caution signs to warn the public.
Notebook PC Adapter Card (SWL-2000E)
•
•
You can install the card whether the power of the Notebook is on or off.
Insert the SWL-2000E adapter card into the PCMCIA slot.
(A pleasant “cheep” sound indicates the regular operation. A low monotonous tone indicates
a failure in recognition.). Always maintain a 20cm space between your self, any other person and
the antenna.
Warning: The antenna should be mounted so that the main beam is not
pointing towards areas of heavy human traffic.
If you see red Power LED illuminating and green Rx LED is blinking, you are now ready to
proceed to software setup.
STUB ANTENNA

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Modify Date                     : 2001:02:16 15:48:59-05:00
Create Date                     : 2001:02:16 15:48:30-05:00
Title                           : 2000486_2100P-PCI_Report
Creator                         : 2000486_2100P-PCI_Report_REV-1.doc - Microsoft Word
Producer                        : Acrobat PDFWriter 4.05 for Windows
Page Count                      : 4
EXIF Metadata provided by EXIF.tools
FCC ID Filing: E2XSWL-2100P

Navigation menu