Samsung Electronics Co SWL-B70F WiFi Full Module User Manual

Samsung Electronics Co Ltd WiFi Full Module

Contents

User Manual

i. We recommend to keep 20cm distance when installing this module. ii. This module should not be installed and operating simultaneously with other radio without additional evaluation or FCC filing. iii. The host system should have proper label showing that it "Contains FCC ID : A3LSWL-B70F"WARNINGModular installation manual
Connecting networkChecking Wi-Fi module installation1 Open the filter cover and check the Wi-Fi Module (①) attached on the panel front. The connection status between the Wi-Fi module and the wireless router can be checked by the Wi-Fi module described next page. The Display Wi-Fi LED is ON when the Wi-Fi module is connected to AP & Internet. To replace the Wi-Fi module(Assembling or disassembling), follow the procedure below.• When changing the Wi-Fi module, you should check the MAC attached on the module or bottom part of the indoor unit and modify the device information at ‘Registering service’.Disassembling the Wi-Fi module1 . Remove the cover of the sub panel.2 . Disconnect the wire of the Wi-Fi module.3 . Release the hook on the top of the Wi-Fi module and push it up to disassemble it.NOTE
PREPARATION01Assembling the Wi-Fi module1 . Push the Wi-Fi module down into a slot and fix the hook on the top.2 . Connect the wire of the Wi-Fi module.3 . Close the cover of the sub panel.Checking the connection status on the panel-display Wi-Fi display description1) Wi-Fi Indicator LED off : Not connected with AP Not connected with internet2) Wi-Fi Indicator LED blinking : Connected with APNot connected with internet3) Wi-Fi Indicator LED on : Connected with APConnected with internet
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment.

Navigation menu