Samsung Bn68 02879E X0 Users Manual
BN68-02879E-X0 to the manual a464d853-aad5-4df4-9562-3d94ca5d1ee2
2015-01-23
: Samsung Samsung-Bn68-02879E-X0-Users-Manual-283246 samsung-bn68-02879e-x0-users-manual-283246 samsung pdf
Open the PDF directly: View PDF .
Page Count: 2
To register this product please visit
www.samsung.com/register.
Quick Setup Guide
BN68-02879E-X0
Wall Mount Kit Specications (VESA)
Install your wall mount on a solid wall perpendicular to the oor. When attaching
to other building materials, please contact your nearest dealer. If installed on a
ceiling or slanted wall, it may fall and result in severe personal injury.
➣Standard dimensions for wall mount kits are shown in the table below.
➣When purchasing our wall mount kit, a detailed installation manual and all
parts necessary for assembly are provided.
➣Do not use screws that do not comply with the VESA standard screw
specications.
➣Do not use screws that are longer than the standard dimension or do not
comply with the VESA standard screw specications. Screws that are too
long may cause damage to the inside of the TV set.
➣For wall mounts that do not comply with the VESA standard screw
specications, the length of the screws may differ depending on the wall
mount specications.
➣Do not fasten the screws too strongly; this may damage the product or
cause the product to fall, leading to personal injury. Samsung is not liable
for these kinds of accidents.
➣Samsung is not liable for product damage or personal injury when a non-
VESA or non-specied wall mount is used or the consumer fails to follow
the product installation instructions.
➣Our 57” and 63” models do not comply with VESA Specications. Therefore,
you should use our dedicated wall mount kit for this model.
➣Do not mount the TV at more than a 15 degree tilt.
➣Always use two people to mount the TV to a wall.
Product
Family inches VESA Spec.
(A * B)
Standard
Screw Quantity
LED TV
[Ultra-Slim]
19 ~ 22 75 X 75
M4
4
23 ~ 29
200 X 100
M8
32~37 200 X 200
40~55
400 X 400
56~65
600 X 400
Do not install your Wall Mount Kit while your TV is turned on.
It may result in personal injury due to electric shock.
Viewing the Connection Panel
Installing the LED TV Stand
See separate guide for installing the stand.
s
s
s
s
s
(A)
(B)
5EA (M4 X L12)
5EA (M4 X L8)
Stand (1EA) Guide Stand (1EA) Screws (10EA)
Follow the steps below to connect the TV to the stand.
sss
s
s
1
s
s
ss
s
2
1. Connect the Guide Stand
to the Stand using four
screws (M4 X L12) as
shown.
2. With your TV upright,
connect the TV to the
Stand as shown.
3. Fasten two screws (M4
X L8) at position
1
, and
then fasten three screws
(M4 X L8) at position
2
.
✎
NOTE
x
Make sure to distinguish between the front and back of the Stand and Guide
Stand when assembling them.
x
Make sure that at least two persons lift and move the LED TV.
x
Stand the product up and fasten the screws. If you fasten the screws with the
LED TV placed down, it may lean to one side.
ss
s
s
s
Top view
Rear
Guide Stand
Screws (M4 X L12)
Stand
Installing the Wall Mount Kit
Wall mount items (sold
separately) allow you to mount
the TV on a wall. For detailed
information on installing the
wall mount, see the instructions
provided with the Wall Mount
items. Contact a technician for
assistance when installing the
wall mounted bracket. Samsung Electronics is not responsible for any damage
to the product or injury to yourself or others if you select to install the TV on your
own.
➣Remove the stand and cover the bottom hole with the cover.
Blanking Bracket
List of Parts
1
Remote Control & Batteries (AAA x 2)
2
Power Cord
3
Cleaning Cloth
4
Blanking Bracket
5
Data Cable (BN39-00865B, BN39-01011B)
6
Stand & Screw (M4xL16)
7
Warranty Card / Safety Guide (Not available in some locations)
1
5 6 7
2 3 4
(M4xL8)
EU Hotel (4000)
1
2
3
4
5
467890!@
1
2
$
%
4
5
46780!@
1
2
$
#
%
4
5
46770 8!@
9
Power Input
Mideast Africa Hotel (4000)
1
2
3
4
5
467890!@
1
2
$
%
4
5
46780!@
1
2
$
#
%
4
5
46770 8!@
9
Power Input
Aus, NZ, Singapore Hotel (4000)
1
2
3
4
5
467890!@
1
2
$
%
4
5
46780!@
1
2
$
#
%
4
5
46770 8!@
9
Power Input
1 RJP
2 USB (HDD) / CLONING
3 COMMON INTERFACE
4 HDMI IN 1(DVI), 2
5 PC / DVI AUDIO IN
6 PC IN
7 COMPONENT IN
8 AV IN
9 EXT(RGB)
0 ANT IN
! DATA
-Used to support data communication between the TV and the SBB.
@ Power input
# AV OUT
-AUDIO OUT
-VIDEO OUT
(DTV signal is unsupportable. This output is only for Analogue video signal.)
$ Headphones jack
% HP-ID
1
Holder-Wire Stand
2
Cable Tie
3
Holder-Wire (3EA)
4
Holder-Ring (4EA)
5
Power Cord Clamp
6
Component Adapter
7
AV Adapter
(Aus, Singapore, NZ only)
8
Audio Adapter
(Aus, Singapore, NZ only)
9
AV Adapter
0
SCART Adapter
(EU, Mideast Africa only)
12345
67 8 9 0
[QSG]BN68-02879E-Hotel.indd 1 2010-04-13 오전 10:04:33
Aus, NZ, Singapore Hotel (4000)
Mideast Africa Hotel (4000)
EU Hotel (4000)
Specications
Items Specication Comment
TV System ATSC / NTSC3.58
Audio out
Speaker out 26inch : 5W x 2
32inch : 10W x 2
Variable Audio 4W X 1, 8 ohm SPK’ RCA Jack output
OTL Sound output
Audio out 500mVrms Phone Jack, Monitor
out
DC out 12V out Max 1.5A Change output
voltage
Input
Component Y, Pb, Pr, Audio-L/R
PC D-sub, Audio-L/R
A/V Audio Video Jack
EXT Scart Jack
(EU, Mideast Africa Only)
HDMI Compatible with the HDMI
Specications DVI is Supported
Antenna 75 ohm Unbalanced, Din Jack VHF/UHF/CATV
Data
DATA RJ-12
Ex-Link RS232 Jack Pack Only,
TeleAdapt RJP Only
Operating temperature 50°F ~ 104°F(10°C ~ 40°C)
Operating Humidity 10% ~ 80% non-condensing
Storage Temperature -4°F ~ 113°F(-20°C ~ 45°C )
Storage Humidity 5% ~ 95% non-condensing
➣Design and specications are subject to change without prior notice.
➣For the power supply and Power Consumption, refer to the label attached to the
product.
Hotel Plug & Play
Hotel Plug & Play is a function that automatically performs the Hotel mode selection, Country Setup, Clock Setup and Picture mode Setup once.
- Hotel Plug & Play is available only one time when power is rst turned ON.
- After setting up rst TV and Clone TV to USB
- Next TV only needs to exit Hotel Plug & Play, connect USB, then Clone USB to TV.
♦UI Scenario
Mixed Channel Map
Connecting the TV with SBB
1. Connect the [DATA] jack of the TV to the [ETH MODEM] jack of the STB (SBB)
with the Data cable.
➣Use data communication.
List of Vendors for Compatible Data Cables Supplied with the TV
♦Refer to the code label on the data cables.
Conrm the code on
the Code Label
ETH MODEM
ETH MODEM
ETH MODEM
TV Rear Panel
ETH MODEM
ETH MODEM
ETH MODEM
TV Rear Panel
Data Cable Data Cable
Hotel Server
STB(Set Top Box)
or SBB (Set Back
Box)
ETH MODEM
ETH MODEM
ETH MODEM
TV Rear Panel
Data Cable
Hotel Server
STB(Set Top Box)
or SBB(Set Back
Box)
Hotel Server
STB(Set Top Box) or
SBB (Set Back Box)
Standalone Only mode is set
TV will enter the RF mode.
Interactive
Hotel Option Menu Press Power OFF to exit.
If Standalone Plug & Play
is selected
Press Power OFF
to exit.
If Standalone Only is selected
If Interactive is selected
After Searching
the channels.
<Depending on Region, this step may not exist.>
Standalone
Hotel Option Menu
Hotel Plug & Play
Easy Set Up
Interactive Standalone Plug & Play Standalone Only
Hotel Plug & Play
Select the OSD Language
.
Menu Language : English r
Enter
Hotel Plug & Play
Set the Clock Mode.
Clock Mode : Auto r
Skip
D
Previous
A
Exit
Hotel Plug & Play
Dynamic
Standard
Previous
A
Exit
U Move
U
Hotel Plug & Play
Select Country.
Country : United Kingdom
r
Enter
Previous
A
Hotel Plug & Play
Antenna Source : Air r
Channel Source : Digital & Analogue
U Move
Search
Exit
Skip
D
Previous
A
Mixed Channel Map is a function to mix Air and Cable channels.
[ If there are no Cable channels, you can use this item as channel sorting. ]
- Mixed channel Map, Channel Editor and Channel Auto Store are newly placed
in Hotel Option Menu.
- Mixed channel Map should be ON in order to mix Air and Cable channels.
- Use Channel Editor to sort the channels as user-desired channel numbers.
<Depending on model and region, some menu items may not exist>
Simple Steps for channel mixing under Stand-alone Mode
Step Broad Outline
1Turn on ‘Mixed Channel Map’ in Hotel Option Menu
2Operate ‘Channel Auto Store’ in Hotel Option Menu
(Antenna Source : Air + Cable)
3Enter ‘Channel Editor’ in Hotel Option Menu
4Compile a table related to the nal channel lists you want to have
5 Rearrange channels with TOOLS Button based on the table you compiled
6 Press EXIT or RETURN Button to exit.
<For better comprehension, please refer to the following details>
Contact SAMSUNG WORLDWIDE
If you have any questions or comments relating to Samsung products, please contact
the SAMSUNG customer care center.
Country Customer Care Centre
AUSTRIA 800-112233
FINLAND 0771-400002
FRANCE 0825-022062
GERMANY 01805-471101
HUNGARY 0640-985985
ITALIA 800-194194
NETHERLANDS 015-2197000
POLAND 0-801-B2BSAM (222726)
PORTUGAL 808-B2BSAM
SPAIN 0902024-010
UNITED KINGDOM +44 (0) 845 8414141
SOUTH AFRICA 0860-SAMSUNG(726-7864)
U.A.E 800-SAMSUNG (726-7864)
8000-4726
AUSTRALIA 1300 362 603
NEW ZEALAND 0800 SAMSUNG (726-786)
SINGAPORE 1800-SAMSUNG (726-7864)
Hotel Mode ON RJP Priority AV 1
Logo Download
...
SI Vendor OFF RJP Priority PC 2
Logo Display Time
...
Power On Channel 1RJP Priority HDMI 3
Power On Option Last Option
Channel Type ATV RJP AV Option AV1 Auto Source OFF
Power On Volume 10 RJP HDMI Option
HDMI1/DVI
Energy Saving
Off
Min Volume 0Sub AMP Volume 6
Clone : TV to USB
Max Volume 100 Sub AMP Mode
2
Clone : USB to TV
Panel Button Lock
Unlock Local Time Manual Pan Euro MHEG OFF
Power On Source TV Time Format 12 Hour
Cloning Data Reset
OFF
Picture Menu Lock
OFF PMOLED Test
Failure
Welcome Message
Channel Editor
PMOLED Mormal Dim.
3
Edit Welcome Message
Music Mode AV
OFF
PMOLED Standby Dim.
2
DC Power Out
5V
Music Mode PC
OFF
Audio Loop In
OFF
Mixed Channel Map
ON
Music Mode Comp
OFF
Menu Display
ON
Channel Auto Store
Music Mode Backlight
OFF
Hotel Logo
OFF
Dynamic SI
OFF
[QSG]BN68-02879E-Hotel.indd 2 2010-04-13 오전 10:04:35