Sargent A6427H 8893 Exit Device Inactive Trim Installation Instructions

User Manual: Sargent 8893 Exit Device Inactive Trim Installation Instructions Instruction Sheets

Open the PDF directly: View PDF .
Page Count: 1

INSTALLATION INSTRUCTIONS

8893 Exit Device Inactive Trim

FOR ASSISTANCE CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com

BEFORE STARTING

• Door should be fitted and hung

• Mullion should be installed if used

• Available stock lengths

Length E – 32" Door. No cut-off required.

Can be cut to fit doors down to 24" wide*

Length F – 36" Door. No cut-off required.

Can be cut to fit doors down to 30" wide*

Length G – 48" Door. No cut-off required.

Can be cut to fit doors down to 36" wide*

*Flush doors only

A6427H

9/12

Copyright © 2009, 2012 Sargent Manufacturing Company,

an ASSA ABLOY Group company. All rights reserved.

Reproduction in whole or in part without the express written

permission of Sargent Manufacturing Company is prohibited.

1

U.S. Patent No. 268003

Canadian Patent No. RD 1981

For 19-8893,

Touch Pad is Omitted

Mounting

Plate

End Cap

8893 Illustration

Edge of Door

Hinge side

of Door

Use (2) Round Head Screws (Do Not Tighten)

3"

41" From

Finished Floor

ATTACH MOUNTING PLATE TO DOOR

2IF CUTTING IS REQUIRED, DETERMINE CUT-OFF LENGTH X

BY SUBTRACTING 1-3/4" FROM LENGTH Y. MARK CUT-OFF POINT

ON BACK END OF RAIL ASSEMBLY.

For doors with stile, cut-off must leave 1/2" min. overlap with rail.

Cut-off length

X

Y3-7/16" Ref.

3

CUT-OFF AND DE BURR

LEVEL RAIL AND ATTACH SECOND MOUNTING PLATE

Level

Tighten all screws BOTH MOUNTING PLATES

TIGHT AGAINST INSERT

4ATTACH END CAPS TO MOUNTING

PLATES WITH COVER SCREWS

THRU-BOLTING APPLICATION

Use (2) round head

screws and grommet

nuts per mtg. plate

Slide rail under

mounting plate

1-3/4"