Savant Systems CRU0200 Savant Blaster User Manual PHX 21702104 01 PPR 2A ART 1B indd

Savant Systems LLC Savant Blaster PHX 21702104 01 PPR 2A ART 1B indd

Contents

User Manual (statement)

IMPORTANT PRODUCT INFORMATION
CONTENTS
IMPORTANT SAFETY INFORMATION 2
FCC INTERFERENCE STATEMENT 4
INDUSTRY CANADA STATEMENT 6
NEW PRODUCT LIMITED WARRANTY 9
CUSTOMER SUPPORT Back Cover
2IMPORTANT SAFETY INFORMATION
!
Warning
Risk of Electric Shock. Install in accordance with all regional, national, and
local electrical codes.
Risk of Serious Injury, Death, or Property Damage or Loss. Install and use
properly
as described in this and other product documents
to avoid danger
of injury, death, or property damage or loss.
Risk of Serious Injury, Death, or Property Damage or Loss. If you are unsure about
any part of these instructions, consult Customer Service or a qualified dealer.
Risk of Overheating. To reduce the risk of overheating and possible damage
to other equipment, install and use properly as described in this and other
product documents.
For the Savant Lamp Control: Prior to changing a light bulb or performing any
other maintenance to the light fixture, turn o the lamp controller via the Savant
App or unplug the lamp itself from the Savant Lamp Control.
Caution
This product generates heat during normal operation.
Charging your device: Please use only the Savant power adaptor and USB
charging cable packed with and intended for use with your Savant product. Other
power adaptors and accessories may damage your device. Do not use a power
adaptor and cable intended for other models of Savant products. Do not use
a power adaptor or cable that has frayed or otherwise been damaged.
3
Your Savant product is an electronic/electrical device. Follow the same basic
safety procedures and cautions you would follow with any electrical device.
Your Savant device, USB cables, and adaptors are not waterproof. To avoid risk
of electric shock, overheating, melting, burns or other injury or damage, keep
the device and all accessories away from water and other liquids. Do not use the
cable if either end of the cable gets wet or is exposed to liquid spray or excessive
moisture. Do not expose your Savant device, cables, and power adaptor to food
or any liquids, or to wet or damp conditions.
Use or modification of this product in a manner not expressly approved by
Savant voids your warranty. Further, Savant is not liable for any damage incurred
with the misuse of this product. See “Limited Warranty.
Cleaning
To clean the outside of your Savant product, please use a dry, soft, lint-free
or micro-fiber cloth to wipe any dust o from the surface of your device. Do
not use any spray or liquid cleaners, or any aerosol sprays, solvents, chemicals,
or abrasives, which may damage the device.
For the Savant Remote only: To clean the touchscreen of your Savant Remote,
first power o the remote and then use a dry, soft, lint-free or micro-fiber cloth
to wipe clean the display. Avoid using any spray or liquid cleaners on the screen.
4
This device complies with Part 15 of the Federal Communication Commission
Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
FCC INTERFERENCE STATEMENT
5
FCC Caution
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter. Operations in the 5.15-5.25GH band are restricted
to indoor usage only.
Radiation Exposure Statement
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government.
The exposure standard for wireless device employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.
*Tests for SAR are conducted using standard operating positions accepted by the
FCC with the device transmitting at its highest certified power level in all tested
frequency bands.
6
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage, et
2. L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
This device complies with RSS-310 of Industry Canada. Operation is subject
to the condition that this device does not cause harmful interference.
Cet appareil est conforme à la norme RSS-310 d’Industrie Canada. L’opération est
soumise à la condition que cet appareil ne provoque aucune interférence nuisible.
INDUSTRY CANADA STATEMENT
7
Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
Déclaration d’exposition aux radiations
Cet équipement est conforme aux limites d’exposition aux rayonnements IC
établies pour un environnementnon contrôlé. Cet équipement doit être installé
et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement
et votre corps.
This device and its antenna(s) must not be co-located or operating in conjunction
with any other antenna or transmitter, except tested built-in radios. The County
Code Selection feature is disabled for products marketed in the US/Canada.
Cet appareil et son antenne ne doivent pas être situés ou fonctionner en
conjonction avec une autre antenne ou un autre émetteur, exception faites des
radios intégrées qui ont été testées. La fonction de sélection de l’indicatif du pays
est désactivée pour les produits commercialisés aux États-Unis et au Canada.
Caution
1. The device for operation in the band 5150-5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel mobile
satellite systems;
2. The maximum antenna gain permitted for devices in the bands 5250-5350 MHz
and 5470-5725 MHz shall comply with the e.i.r.p. limit; and
8
3. The maximum antenna gain permitted for devices in the band 5725-5825 MHz
shall comply with the e.i.r.p. limits specified for point-to-point and non point-to
-point operation as appropriate.
4. Users should also be advised that high-power radars are allocated as primary
users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and
that these radars could cause interference and/or damage to LE-LAN devices.
Avertissement
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des
instructions précises sur les restrictions susmentionnées, notamment:
1. Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les
mêmes canaux;
2. Le gain maximal d’antenne permis pour les dispositifs utilisant les bandes
5250-5350 MHz et 5470-5725 MHz doit se conformer à la limite de p.i.r.e.;
3. Le gain maximal d’antenne permis (pour les dispositifs utilisant la bande
5725-5825 MHz) doit se conformer à la limite de p.i.r.e. spécifiée pour
l’exploitation point à point et non point à point, selon le cas.
4. De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars
de haute puissance sont désignés utilisateurs principaux (c.-à-d., qu’ils ont la
priorité) pour les bandes 5250-5350 MHz et 5650-5850 MHz et que ces radars
pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
9NEW PRODUCT LIMITED WARRANTY
THE FOLLOWING WARRANTY TERMS WERE IN EFFECT AS OF THE DATE
YOUR DEVICE WAS MANUFACTURED, AND ARE PROVIDED FOR YOUR
REFERENCE ONLY. THE ACTUAL TERMS OF YOUR WARRANTY ARE THE
FULL TERMS THAT WERE IN EFFECT AS OF THE DATE OF YOUR PURCHASE,
WHICH MAY BE DIFFERENT THAN THE TERMS SET FORTH HEREIN.
TO FIND THE EXACT, FULL TERMS OF YOUR WARRANTY, PLEASE GO TO
SAVANT.COM/WARRANTY AND REVIEW THE TERMS APPLICABLE AS OF
THE DATE OF YOUR PURCHASE.
Savant Systems, LLC (“Savant”), Two-Year Limited Warranty Summary
Savant warrants the included hardware product and accessories against
defects in materials and workmanship for two (2) years from the date of
original retail purchase. Savant does not warrant (i) against normal wear and
tear, (ii) against damage caused by accident or abuse, (iii) consumable or
expendable items (such as light bulbs, fuses, etc.), (iv) items that have had the
serial number removed or altered in any manner. This warranty does not cover
the installation, removal, or reinstallation of any product or accessory. To obtain
service call Savant at 1-855-5SAVANT (1-855-572-8268), or visit the Savant
website at www.savant.com/support. Call charges and international shipping
charges may apply depending on location. The limited warranty described
herein is subject to the full terms, and detailed information on obtaining service,
available at www.savant.com/warranty and www.savant.com/support. If you
submit a valid claim through this warranty, Savant will either repair, replace,
or refund your product at its own discretion. Warranty benefits are in addition
to rights provided under local consumer laws. You may be required to furnish
proof of purchase details when making a claim under this warranty.
Customer Service
Should you have any technical questions, require troubleshooting
assistance, or need warranty-related help, please call Customer Service,
toll-free, at 1-855-5SAVANT (1-855-572-8268).
Part # HDH6B002010
Savant Systems, LLC. 45 Perseverance Way, Hyannis, MA 02601
© 2015 Savant Systems, LLC. All rights reserved. Savant, Savant App, and the Savant logo are
trademarks of Savant Systems, LLC. Android, Google, Google Play, and other Google marks are
trademarks of Google Inc. Wi-Fi is a registered trademark of Wi-Fi Alliance®. All other brand
names, product names, and trademarks are the property of their respective owners. Product
images are simulated and for instructional purposes only. They may dier from the actual
products and are subject to change without notice. Savant Systems, LLC reserves the right to
change product specifications without notice. Printed in China. Version # 1.0.A
FOR MORE INFORMATION, TUTORIAL VIDEOS,
AND FAQ’S, VISIT SAVANT.COM/SUPPORT
OR CALL US TOLL-FREE AT 1-855-5 S AVA N T
Follow us:

Navigation menu