Savant Systems SSR2000 WIRELESS REMOTE User Manual new SSR 2000 Quick Reference Guide

Savant Systems LLC WIRELESS REMOTE new SSR 2000 Quick Reference Guide

USERS MANUAL

Savant Select Remote (SSR-2000) Quick Reference Guide 009-xxxx-00 SSR-2000-00 Copyright © 2011 Savant Systems LLC, SAVANT® and RacePoint Blueprint™ are trademarks of Savant Systems LLC. All brand names, product names and trademarks are the property of their respective owners. Savant Systems LLC reserves the right to change product specifications without notice. 75 Perseverance Way, Hyannis, MA 02601 Phone 508.683.2500 Fax 508.683.2600 SavantSystems.com Savant Confidential and Proprietary The Savant Select Remote (SSR-2000) Quick Reference Guide provides the information necessary to setup and operate the Savant Select Remote. Box Contents (1) Savant Select Remote (SSR-2000-xx) (1) Lithium-Ion Battery Pack (070-0016-xx) (1) USB Type A to Mini Custom B for remote (24”) (064-0235-xx) (1) 5V DC 2.5 AMP Universal Wall Unit (025-0098-xx) (1) SSR Remote Base (068-0179-xx) (1) Quick Reference Guide (this document) Specifications Savant Select (SSR-2000) Environmental Operating Temperature 32º to 95º F (0º to 35º C) Non-operating Temperature 32º to 113º F (0º to 45º C) Operating Humidity 5% to 95% Non-condensing Physical Dimensions (L x. W x D) 9 x 2.6 x 0.65 inches (228.6 x 66 x 16.5 mm) Weight 6 oz (170 g) with Battery Pack Enclosure High-impact molded ABS plastic Power Power 3.7V/1150mAh, 4.25 Watt-hours Integrated Motion Detector for power management Battery Lithium-Ion battery pack Battery Charge Time 3-4 hours (nominal) Communication Wireless -WiFi 802.11 b/g/n (802.11 n 2.4 GHz only) or -RF Transceiver, Frequency (Spectrum) - ISM Band (2.4 GHz to 2.483 GHz)* Display and Backlights Touch Screen Display Multi-Touch® high resolution Retina display: 960 x 640 pixels 3.5-inch (diagonal) multi-touch display Backlights White LED for all navigation buttons Battery Charging Status Orange/Green/Red LED USB Connector and Cable Connector Mini-USB Cable Mini-USB Sync Cable Regulatory Safety and Emissions CSA NRTL/C and FCC Part 15 Class B/C-Tick** RoHS Compliant Charging Base (SSB-2000) Power Input Power 5V DC, 2.5 A Adaptor with one meter cord Physical Dimensions (L x. W x D) 9 x 2.6 x 0.55 inches (228.6 x 66 x 14 mm) Weight 3 oz (85 g) *RF communications requires an RFG-2000, sold separately iPod touch Area Front 1 Camera Front facing camera 2 Category Dock Provides quick access to subsets of system functions, such as watch, listen, environment and settings. 3 Navigation Bar Allows quick navigation between rooms, services and subsystems. Also provides simple navigation back to the active service. 4 Touch Screen Display Indicates the controls and content for the active service, or the service being currently controlled 5 Home button Press to return to home screen Remote Area VOL + Press for volume up VOL - Press for volume down MUTE Press to mute sound Up, Down, Left, Right Navigation Press up, down, left, and right to navigate selected service screen OK button Press to select CH + Press to channel up CH - Press to channel down 6 LAST Press to return to last channel MENU Press to view menu GUIDE Press to view guide Backlights White LED for all navigation buttons TrueCommand launch Power Off Press to launch True Command II App on display. Press and hold to power off remote DVR Press to enable the DVR EXIT Press to exit page INFO Press to view information 7 PG +/PG- Press to page up/page down 8 Numerical Keypad Use to directly tune channels 9 Status LED Status LED indicates the following: Green indicates the remote is fully charged and docked. Orange indicates remote is charging. Red indicates the remote is not docked and battery is low and needs charging. Off indicates the remote is not docked and charged. Flashing Red indicates that one of the remote buttons was pressed, but ignored because the iPod touch® was in the sleep mode or not in the TrueControl II app mode. (See ** below for details.) Rear 1 Power On/Off button Press and release to power on iPod touch when powered off Press and hold to power off iPod touch 2 Volume Up/Down buttons Press buttons for volume up/down for the iPod touch® 3 Battery Rechargeable Battery 4 Charging ports Plug into Charging Base (SSB-1000) 5 Connector Mini-USB 6 Camera/mic Rear Facing camera and microphone Setup Battery Installation To install the battery, refer to the figure below. 1. Locate the battery cover (1) on the rear of the remote. 2. Push the latch (2) down and pull the cover out to remove. 3. Install the battery (3). Ensure the battery contacts (4) are positioned as shown. Ensure the battery pull-tab (5) is accessible in the event you must remove the battery. 4. Position the two tabs (6) on the cover into the lower section and press cover in until latch clicks to secure the cover.
Savant Select Remote (SSR-2000) Quick Reference Guide 009-xxxx-00 SSR-2000-00 Copyright © 2011 Savant Systems LLC, SAVANT® and RacePoint Blueprint™ are trademarks of Savant Systems LLC. All brand names, product names and trademarks are the property of their respective owners. Savant Systems LLC reserves the right to change product specifications without notice. 75 Perseverance Way, Hyannis, MA 02601 Phone 508.683.2500 Fax 508.683.2600 SavantSystems.com Savant Confidential and Proprietary Battery Removal and Replacement To remove and replace the battery, refer to the figure below. 1. Locate the battery cover (1) on the rear of the remote. 2. Push the latch (2) down and pull the cover out to remove. 3. Using a small Phillips screwdriver, remove the two screws (3) on each side of the battery that secure both sections. 4. Place your thumb on the iPod touch while holding the top section (4) so that they remain together; pull the bottom section (5) to separate the two sections. 5. Install the battery (7). Ensure the following: • Battery contacts (8) are positioned as shown. • Battery pull-tab (6) is accessible in the event you must remove the battery. 6. Push the top section (4) together with the bottom section (5). Ensure the antenna is not pinched and that the iPod connector seats properly. 7. Replace the two (3) screws on each side of the battery to secure the sections. 8. Position the two tabs (10) on the cover into the lower section and press cover in until latch clicks to secure cover. Charging Base Power Adaptor Installation To install 5V DC, 2.5 AMP adaptor with 1 meter power cord (2, 3 and 4), do the following: 1. At the rear of the Charging Base (1), select the path you want to use to install the power cord. 2. Note: Savant recommends installing the 5V DC jack (2) first and then routing the power cord (3). 3. If you choose to route the power cord (3) in the channel as shown below, press the power cord between the retainers in the channel. 4. After routing the power cord, select and snap in the “power clip” for the specific region into the power adaptor and plug the adaptor (4) into a 100-240 50/60 Hz surge protected outlet. Charging the Battery To charge the lithium-ion battery, do the following: 1. Plug the Charging Base (SSB-1000) into a 100-240 50/60 Hz surge protected outlet using the supplied 100-240V AC, 50/60 Hz V DC to 5V DC, 2.5 A Adaptor with one 1 meter power cord. 2. Place the Savant Select onto the charging base as shown. 3. Refer to the Front table; item 9 Status LED for battery status and charging information. Registration, Sync and Charge 1. Connect the SSR-1000 to the USB port in your Mac using the included cable. 2. Follow the on screen instructions in iTunes® to set up the iPod touch®. There are many screens. 3. When the following image appears on the iPod, the registration is complete. 4. Select Start Using iPod touch. For the entire sequence of screens, see Reset All Settings on the iPod Purchase and Download Savant TrueControl II To purchase and download the TrueControl II App, using the Savant Select (iPod touch®) tap the Apple® App StoreSM icon. Follow the on screen directions to purchase and download the App. Important: Connecting the Mobile Device Server and the Savant Select to the same LAN ensures that Bonjour® discovery allows all components to communicate. Wi-Fi Network Connection You must connect the Savant Select to the Wi-Fi network on your system and load a mobile instance in order for the remote buttons to function. Optional Wireless RF Gateway (RFG-2000) The RFG-2000 wireless gateway is an option for two-way wireless communication in addition to WiFi.
Savant Select Remote (SSR-2000) Quick Reference Guide 009-xxxx-00 SSR-2000-00 Copyright © 2011 Savant Systems LLC, SAVANT® and RacePoint Blueprint™ are trademarks of Savant Systems LLC. All brand names, product names and trademarks are the property of their respective owners. Savant Systems LLC reserves the right to change product specifications without notice. 75 Perseverance Way, Hyannis, MA 02601 Phone 508.683.2500 Fax 508.683.2600 SavantSystems.com Savant Confidential and Proprietary **This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications of this product, not approved by manufacturer will void the user’s authority to operate the equipment. “This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.” Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Additional Documentation For more documentation, go to SavantSystems.com and navigate as follows: >Dealer Login > Knowledge Base > Products • Refer to Savant Select - Remove and Replace Battery • Refer to Savant Select - Remove and Replace iPod touch® • Refer to RacePoint Blueprint™ Programming

Navigation menu