Schlage Residential 07062 B.unlocked BE365 Keypad Deadbolt Door Preparation Instructions For With No Holes B

User Manual: Schlage Residential BE365 - Keypad Deadbolt Door Preparation Instructions For Door With No Holes Installation Manuals

Open the PDF directly: View PDF PDF.
Page Count: 2

Mark Lock Centerline on Door Face and Door Edge
2
38” from finished floor
Mark and Drill Hole in Door Face with 2¹⁄₈” Hole Saw
3
1
1³⁄₈” - 1³⁄₄”
Measure Door Width
If the door is thinner than 1³⁄₈” or thicker than 1³⁄₄”, then the
lock will not fit properly on the door.
Door Edge
Door Face
Tape
Measure
Tape
Measure
Mark and Drill Hole in Door Edge
4
BE365 Door Preparation Instructions For Door With No Holes
1” Drill Bit
2³⁄₈” or 2³⁄₄”
a
Tape
Measure
d
b
¹⁄₂” Door
Width
Tape
Measure
ba
dc
Tools Needed
Pencil
Drill Bits Needed:
¹⁄₈”, ⁷⁄₈”, 1”
2¹⁄₈” Hole Saw
Chisel
Tape
Measure
Tape Measure
2¹⁄₈” Hole Saw
c
Measure and Mark Door Jamb for Strike
a. Measure 38” from finished floor and mark on door jamb.
b. Mark center for strike hole exactly opposite latch hole.
6
Tape
Measure
5 7
FOR
OR
¹⁄₈” Drill Bit
If Necessary, Mortise for Latch
a. Insert latch into door edge hole.
b. Use pencil to trace latch and mark holes.
c. Remove latch and drill two ¹⁄₈” pilot holes.
d. Use chisel to create latch mortise.
Mark and Drill Holes for Strike
a. Drill two (2) 1” holes, 1¹⁄₄” deep, as shown. Chisel out excess
material.
b. Line up strike box and strike with hole in door jamb.
c. Use pencil to trace strike and mark holes.
d. Drill five (5) ¹⁄₈” pilot holes and use chisel to create strike
mortise.
1” Drill Bit
a
¹⁄₄"
¹⁄₄"
c
ba
dc
38” From
Floor
Tape
Measure
Door Jamb
38” from Floor
Latch Hole
ab
¹⁄₈” Drill Bit
d
b
© Allegion 2014
Printed in U.S.A.
BE365 DP no holes Rev. 11/14-online

Navigation menu