Schumacher Ps 120A Users Manual 341 503

PS-120A f3e8c5a8-11e9-441a-87eb-979a216dbffb

: Schumacher Schumacher-Ps-120A-Users-Manual-388331 schumacher-ps-120a-users-manual-388331 schumacher pdf

Open the PDF directly: View PDF .
Page Count: 2

Schumacher Electric Corporation Model PS-120A

OWNER’S MANUAL

MityMite® Jump Starter & DC Power Source

THIS PRODUCT HAS A SEALED LEAD-ACID BATTERY INSIDE THAT SHOULD BE KEPT AT FULL CHARGE FOR LONGER LIFE.

RECHARGE WHEN FIRST RECEIVED (EVEN IF GREEN ‘FULL POWER’ LIGHT GLOWS), AFTER EACH USE AND EVERY 3 MONTHS.

IMPORTANT SAFETY INSTRUCTIONS

Save these instructions

OPERATING INSTRUCTIONS

Warning: Failure to follow instructions may cause

damage or an explosion. Read entire instruction

manual before use.

1. Turn ignition off before making cable connections.

2. Use in a well-ventilated area.

3. Clamp the red clamp to the positive terminal of the battery.

(For a negative grounded system.)

4. Clamp the black clamp to an unpainted and unmoving part of

the chassis or engine block.

5. Keep clear of fan blades, belts, pulleys and other parts that

may cause injury.

6. You can now crank the engine. If the engine does not start,

wait at least 3 minutes before attempting to start vehicle again.

(This permits the battery to cool down.)

7. After the engine starts, first disconnect the black clamp and

then the red clamp in that order. Store the clamps on the ears

located on the sides of the case.

8. Recharge the MityMite as soon as possible after use.

9. Never allow clamps to touch together or to contact the same

piece of metal to prevent sparking.

LED INDICATORS

To check the internal battery’s status, press the red button on the

front of MityMite.

The led lights will indicate as follows:

1. A red light indicates a 50% or less charge and you should

immediately recharge MityMite.

2. A yellow light indicates a 50 to 75% charge. MityMite may be

used but should be recharged as soon as possible.

3. A green light indicates the internal battery is fully charged

CHARGING of internal battery with built-in charger.

After removing the PS-120A from the carton, charge it overnight

before using even if the green Full Power light glows.

1. To charge, plug extension cord into charger plug on the side

of the MityMite.

2. Plug the extension cord into 120V AC source. (Electrical outlet.)

3. The red light will glow while charging.

4. The green light will glow when the battery has reached full

charge. The charger will automatically drop into a float mode

and maintain the battery at full charge.

MULTI-PURPOSE POWER SUPPLY

The PS-120A is a power source for all 12 volt DC accessories that

are equipped with a cigarette lighter adapter plug. The DC socket

has a 15 amp automatic overload protection circuit breaker. Reset

the breaker by pushing the breaker button located on the back of

MityMite.

Do not permit the battery in the PS-120A to freeze. Never attempt

to recharge a frozen battery.

HANDLING WARNING

WARNING: Handling the cord on this product or cords associated

with this product, will expose you to lead, a chemical known to the

State of California to cause cancer and birth defects or other

reproductive harm.

Wash hands after handling.

12 VOLT DC POWER SOURCE CHART

Appliance Type Estimated Wattage Estimated Time

Cell Phones 4 Watts 20 Hours

Fluorescent Lights 4 Watts 20 Hours

Radios 9 Watts 14 Hours

Depth Finders 9 Watts 14 Hours

Fans 9 Watts 14 Hours

Camcorders, VCRs 15 Watts 8 Hours

Electrical Tools 24 Watts 5 Hours

Electrical Coolers 48 Watts 2 Hours

Car Vacuum,

Air Compressors 80 Watts 1 Hour

When the PS-120A is used with an inverter, it can operate

appliances normally powered by 120V AC or 220V AC. (You must

purchase the inverter separately. It is not included.)

110 / 220 VOLT AC POWER SOURCE CHART

Appliance Type Estimated Wattage Estimated Time

Spot Lights, Sump Pumps 100 Watts 1 Hour

VCRs 100 Watts 1 Hour

Faxes, TVs 125 Watts .75 Hour

Small Power Tools 125 Watts .75 Hour

Note: Estimated time is conservatively reported. Actual time may

vary. Times are based on MityMite having a full charge. Requires

the use of an inverter that is not included. Designed for up to a 150

watt inverter.

00-99-000256/0604

LIMITED WARRANTY

Schumacher Electric Corporation warrants your unit to be free from defects in material and workmanship, excepting abuse or misuse,

for a period of one year from the date of sale to the original user or consumer purchaser. If your unit fails or malfunctions within the first

30 days of the warranty, we will replace it with a new unit. If your unit malfunctions or fails within the 12 month warranty period because

of a defect in material or workmanship, we will repair without charge.

The internal battery, excluding units with swollen batteries or melted battery terminals, carries a 90-day warranty from the date of

purchase. Proof of purchase required. All battery replacements will be at the sole discretion of the manufacturer or his designated

agents.

This warranty is in lieu of all other express warranties. The duration of any implied warranty, including but not limited to any implied

warranty of merchantability or fitness for a particular purpose, made in respect to your unit is limited to the period of the express warranty

set forth above.

For warranty service, return your product, with proof of purchase, to the factory or a designated agent: Schumacher Electric Corporation

Warranty Service Department, 1025 E. Thompson Street, PO Box 280, Hoopeston, IL 60942. Phone 1-800-621-5485, Customer

Service hours: 7 AM to 4 PM CST.

You will be responsible for all insurance and freight or other transportation charges to the factory or point of repair. We will return your unit

freight prepaid if repair is covered under warranty. Your unit should be properly packed to avoid damage in transit, since we will not be

responsible for any such damage.

In no event shall Schumacher Electric Corporation be liable for consequential or incidental damages. Some states do not allow limitations

on the length of the implied warranty or the exclusion or limitation of incidental or consequential damages, so the above limitations or

exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state

to state.

Send Warranty Product Repairs to: Schumacher Electric Corporation,

1025 East Thompson, Hoopeston, IL 60942-0280.

Call Customer Service if you have questions: 1-800-621-5485.

801 Business Center Drive, Mount Prospect, IL 60056-2179

ELECTRIC CORPORATION

CONTAINS SEALED NON-SPILLABLE LEAD-ACID BATTERY. MUST

BE DISPOSED OF PROPERLY.

WARNING: Possible explosion hazard. Contact with battery acid may

cause severe burns and blindness. Keep out of reach of children.

STORAGE

MityMite can be stored in any position. The clamps are live and will produce arcing or sparking if they come in contact with each other.

To prevent accidental arcing, always keep the clamps on the side ears when not using it to jump start a vehicle.

All batteries are affected by temperature. The ideal storage temperature is at 70 degrees. Performance varies based on battery temperature

conditions.