Scientific Toys 2782-27SH 27 MHz WIRELESS R/C TOY- TX User Manual OI 0001 ai

Scientific Toys Ltd 27 MHz WIRELESS R/C TOY- TX OI 0001 ai

users manual

Download: Scientific Toys 2782-27SH 27 MHz WIRELESS R/C TOY- TX User Manual OI 0001 ai
Mirror Download [FCC.gov]Scientific Toys 2782-27SH 27 MHz WIRELESS R/C TOY- TX User Manual OI 0001 ai
Document ID605922
Application IDmYTIbWrHJaQrpJ3CLZt7QQ==
Document Descriptionusers manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize15.41kB (192658 bits)
Date Submitted2005-11-25 00:00:00
Date Available2005-11-23 00:00:00
Creation Date2005-11-17 13:56:42
Producing SoftwareAcrobat Distiller 6.0.1 for Macintosh
Document Lastmod2005-11-17 13:56:42
Document TitleOI 0001.ai
Document CreatorAdobe Graphics Manager
Document Author: PRC User

OPERATING INSTRUCTIONS
BATTERY INSTALLATION:
THE RECHARGEABLE NI-CD BATTERY PACK
AND CHARGER MUST BE OPERATED BY
ADUIT ONLY.
THE RECHARGEABLE NI-CD BATTERY PACK IS
NOT CHARGED. PLEASE CHARGE IT FOR
8 HOURS PRIOR TO USE.
1. Plug the wall pack battery charger into wall
outlet.
2. Connect the cables leading from the battery
pack and charger together by snapping the
jack and the socket tightly. (See Diagram 1)
3. To disconnect cables, press down on the clip
and pull apart. (See Diagram 1)
4. You should charge the battery pack for 8
hours the first two times. Then subsequent
charges will only require minimum 4 hours.
5. After charging for 4 hours, the battery pack
will be warm. This condition is normal for fully
charged batteries. If the speed of the car
slows down suddenly, it is time to recharge.
6. After use, the battery pack will be hot! Wait at
least 20 minutes until it cools before recharging.
7. Recharging a warm or hot battery pack will
greatly shorten battery life.
BATTERY PACK CARE / CAUTIONS:
© 2005 SCIENTIFIC TOYS, LTD.
CHAI WAN, HONG KONG.
PRINTED IN CHINA
O.I.NO.0001
1. If battery pack and/or connectors are wet,
thoroughly dry before charging.
2. Unplug the battery pack if it is not going to be
used for several days.
3. Do not mix old and new batteries.
4. Do not mix alkaline, standard (carbon-zinc),
or rechargeable (nickel-cadmium) batteries.
5. Do not charge battery pack that is hot, wet
or shows leakages or corrosion.
6. Do not expose to fire, as explosion may result.
7. Do not disassemble the battery pack.
PRESS HERE
WHEN OPENING
B. Replace the battery cover.
DRIVING FORWARD:
TURNS TO THE
CLOCKWISE
DIRECTION
ON/OFF SWITCH
BATTERY LID
D. Pull the trigger of the transmitter back
(towards you). (See Diagram 7)
DRIVING IN REVERSE:
E. Push the trigger of the transmitter forward
(away from you). (See Diagram 8)
LID
STOPPER
BATTERY
CHARGER
9.6V Ni-Cd
BATTERY PACK
9.6V Ni-Cd
BATTERY PACK
CABLE
(DIAGRAM 3)
(DIAGRAM 1)
ANTENNA
TUBE
(DIAGRAM 2)
HOW TO INSTALL BATTERY IN
VEHICLE:
9-VOLT
BATTERY
A. Make sure the ON/OFF switch is in the
“OFF” position. (See Diagram 2)
B. Turn the lid stopper in a clockwise direction
to open battery lid. (See Diagram 3)
C. Lift the battery lid to open and place the
battery pack inside properly. (See Diagram 3)
D. Plug the jack of the battery pack into the
socket of the battery compartment.
(See Diagram 3)
E. Replace the battery cover.
HOW TO INSTALL BATTERY IN
TRANSMITTER:
A. Unscrew the battery cover at the bottom of
the transmitter and place a 9-volt battery inside
following the engraved signs (See Diagram 4).
TRIGGER
(DIAGRAM 5)
BOTTOM OF
TRANSMITTER
(DIAGRAM 6)
BATTERY COVER
(DIAGRAM 4)
FORWARD
VEHICLE OPERATION:
A. Pass the cable through the antenna tube
provided and plug into the vehicle tightly.
(See Diagram 5)
B. Screw the antenna onto the top of the
transmitter and extend to full length.
(See Diagram 6)
C. Push the ON/OFF switch to the “ON”
position. (See Diagram 2)
PULL THE
TRIGGER
PUSH THE
TRIGGER
(DIAGRAM 7)
REVERSE
(DIAGRAM 8)
#95447(MW DODGE SRT-10)
Size: 12.75"x 4.75"
65-0001-100-0100
FRONT WHEELS STEERING
ADJUSTMENT:
F. If the vehicle does not run straight forward,
adjust the lever for satisfactory alignment on
the underside of the vehicle. (See Diagram 9)
G. If the vehicle runs toward left, turn "Steering
Alignment Lever" towards "R."
H. If the vehicle runs toward right, turn "Steering
Alignment Lever" towards "L."
STEERING OPERATION:
I. To make left or right-hand turns while driving
forward, turn the steering wheel to left or right
while pulling the trigger of the transmitter back
(towards you). (See Diagram 10)
J. To make left or right-hand turns while driving in
reverse, turn the steering wheel to left or right
while pushing the trigger of the transmitter
forward (away from you). (See Diagram 11)
STOP OPERATION:
K. Release the trigger to stop.
(See Diagram 12).
CHANGING BANDS FOR MULTI-PLAYER
CONTROL SYSTEM
Collect multiple Multi-Player Control System
vehicles to run up to 6 cars at the same time.
1. Assign a different band to each car. The 6
available bands are Band 1, Band 2, and
Band 3 for 27MHz (See diagram 13); Band
4, Band 5, and Band 6 for 49 MHz
(See diagram 14).
2. Adjust the transmitter to match the band
selected for the car. For example, if Band
2 is selected for the car, slide the band
switch of the transmitter to Band 2.
3. Select a different band for each pair of car
and transmitter and go racing.
(See diagram 15)
TIPS FOR THE MULTI-PLAYER CONTROL
SYSTEM
1. When operating multiple cars, only one
pair of car and transmitter shall be using
the same band. Interference may occur if i)
more than one car is set to the same band;
or ii) more than one transmitter is set to the
same band.
2. If a car does not respond, check the
transmitter and the car to ensure that both
are set to the same band.
3. The Multi-Player Control System allows
multiple cars within the collection to be
raced at the same time. Use of other radio
control products that are not part of this
Multi-Player Control System may cause
interference and loss of control to the cars.
• Do not bend the antenna.
• Electrical, CB interference, mobile phones,
air conditioning, elevators and steel girders
in buildings will affect the operation of
your vehicle.
• Do not leave the vehicle or transmitter near
sources of heat or in direct sunlight for
long periods of time.
• Remove the batteries from the vehicle and
transmitter when they are not in use.
STEERING
ALIGNMENT
LEVER
(DIAGRAM 9)
STOP
STEERING
WHEEL
INPUT: 120VAC-60Hz-5.5W ONLY
OUTPUT: 12VDC, 0.2A
(DIAGRAM 12)
(DIAGRAM 11)
27 MHz:
STEERING
WHEEL
(DIAGRAM 10)
49 MHz:
1 2 3
4 5 6
(DIAGRAM 13)
(DIAGRAM 14)
49 MHz:
27 MHz:
BAND 1
BAND 2
BAND 3
BAND 4
BAND 5
BAND 6
BAND 1
BAND 2
BAND 3
BAND 4
BAND 5
BAND 6
PERFORMANCE TIPS
• Do not drive car on grass, sand or carpet.
• Do not drive car through water.
• Be sure to rest your vehicle for at least
30 minutes after every 15 minutes
of operation.
• Make sure ON/OFF switch on your vehicle
is in the “OFF” position when it is not in use.
CAUTION:ELECTRIC TOY
Not recommended for children under 6 years of age. As
with all electric products, precautions should be observed
during handling and use to prevent electric shock.
(DIAGRAM 15)
FCC NOTE : THE ANTENNA PROVIDED IS AN
UNIQUE ANTENNA. BY INSTALLATION OF UNAUTHORIZED
ANTENNA TO THIS EQUIPMENT. SUCH UNAUTHORIZED
INSTALLATION COULD VOID THE USER’S AUTHORITY
TO
OPERATE THE EQUIPMENT.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY
RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
ATTENTION PARENTS:
IT IS RECOMMENDED THAT THIS TOY AND ALL
ACCESSORIES BE PERIODICALLY EXAMINED FOR
POTENTIAL HAZARDS AND THAT ANY POTENTIALLY
HAZARDOUS PARTS BE REPAIRED OR REPLACED.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Page Count                      : 1
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:f01495a3-572e-11da-8e28-000393d3a792
Producer                        : Acrobat Distiller 6.0.1 for Macintosh
Modify Date                     : 2005:11:17 13:56:42+08:00
Creator Tool                    : Adobe Graphics Manager
Create Date                     : 2005:11:17 13:56:42+08:00
Document ID                     : uuid:f014661e-572e-11da-8e28-000393d3a792
Format                          : application/pdf
Creator                         : PRC User
Title                           : OI 0001.ai
Author                          : PRC User
EXIF Metadata provided by EXIF.tools
FCC ID Filing: BY32782-27SH

Navigation menu