Scientific Toys 3564-27PP 26.96-27.28 MHz WIRELESS REMOTE CONTROL TOY-TX User Manual OI 5459 ai

Download:
Mirror Download [FCC.gov]
Document ID	1953140
Application ID	qfO8pCWWl0DGPdMKBlvw1g==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	23.68kB (296003 bits)
Date Submitted	2013-04-29 00:00:00
Date Available	2013-04-29 00:00:00
Creation Date	2013-04-02 17:49:53
Producing Software	Acrobat Distiller 6.0.1 for Macintosh
Document Lastmod	2013-04-02 17:49:53
Document Title	OI 5459.ai
Document Creator	Adobe Illustrator(R) 11
Document Author:	HO Wong

CAUTION- ELECTRIC TOY
HOW TO INSTALL BATTERY IN VEHICLE
1. Make sure the “ON/OFF” switch at the underside of the vehicle is at the “OFF” position. (See Diagram #2)
2. Unscrew to open battery cover. (See Diagram #2)
3. Place the 9.6V battery pack inside securely and replace the battery cover. (See Diagram #3)
4. Replace the battery cover and tighten the screw to secure the battery cover.
NOT RECOMMENDED FOR CHILDREN UNDER 6 YEARS
OF AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS
SHOULD BE OBSERVED DURING HANDLING AND USE TO PREVENT
ELECTRIC SHOCK. INPUT: 120VAC, 60HZ 10W ONLY. OUTPUT:
12VDC, 0.2A
OFF
ON
ON/OFF
switch
OPERATING INSTRUCTIONS:
BATTERY PACK CARE / CAUTIONS:
1. If battery pack and/or connectors are wet, thoroughly dry before charging.
2. Unplug the battery pack if it is not going to be used for several days.
3. Do not charge battery pack that is hot, wet or shows signs of leakage or corrosion.
4. Do not expose to fire, as explosion may result.
5. Do not disassemble the battery pack.
6. The toy must only be used with the recommended charger.
7. The charger is not a toy.
8. Rechargeable battery pack is only to be charged by adult.
9.6V RECHARGEABLE
BATTERY PACK
(DIAGRAM 2)
(DIAGRAM 3)
HOW TO INSTALL BATTERY IN TRANSMITTER
1. Remove battery cover and install 9V batteries by matching + and – poles as indicated in the battery
compartment. (See Diagram #4)
2. Replace the battery cover.
Note: Remove all batteries after you have finished using your vehicle.
WALL OUTLET
BATTERY INSTALLATION:
THE RECHARGEABLE BATTERY PACK IS NOT CHARGED.
1. Plug the battery charger into a wall outlet.
2. Click the battery pack into the charger. Make certain the battery pack
is securely inserted into the charger.
3. To disconnect, push the button of the charger (See Diagram 1)
and simultaneously slide battery pack out.
4. The battery pack should be charged for 8 hours the first two times.
Then subsequent charges will only require 4 hours.
5. After charging, the battery will be warm. This condition is normal for
fully charged batteries.
6. If the speed of the vehicle slows down suddenly, it is time to recharge.
7. After each use, the battery pack will be hot! Allow the battery pack to
cool for at least 20 minutes before recharging. Recharging a warm or
hot battery pack will greatly shorten the useful life of the battery.
8. The toy must be used with the recommended transformer.
9. The transformer is not a toy.
9.6
UNSCREW
TO OPEN
BATTERY
CHARGER
PRESS BUTTON
ON SIDE OF
CHARGER TO
RELEASE
BATTERY PACK
9.6V
RECHARGEABLE
BATTERY PACK
(DIAGRAM 4)
(DIAGRAM 1)
FCC NOTE:
THE ANTENNA PROVIDED IS A UNIQUE ANTENNA. BY INSTALLATION OF UNAUTHORIZED ANTENNA TO THIS EQUIPMENT.
SUCH UNAUTHORIZED INSTALLATION COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
© 2013 SCIENTIFIC TOYS LTD. 1108, TOWER B,
14 SCIENCE MUSEUM ROAD, TSIMSHATSUI, HONG KONG.
PRINTED IN CHINA
O.I. NO.5459
ATTENTION PARENTS:
IT IS RECOMMENDED THAT THIS TOY AND ALL ACCESSORIES BE PERIODICALLY EXAMINED FOR POTENTIAL HAZARDS AND
THAT ANY POTENTIALLY HAZARDOUS PARTS BE REPAIRED OR REPLACED.
SIZE: 297MM X 242MM PN#65-5459-000-0100
HOW TO PLAY
360 DEGREE SPINS
7. Push the Left Driving Control Stick forward while pulling the Right Driving Control Stick backward at the same time.
(See Diagram #11)
8. Push the Right Driving Control Stick forward while pulling the Left Driving Control Stick backward at the same time.
(See Diagram #12)
1. Build up antenna by passing the cable through the antenna tube provided and plug into the
vehicle tightly. Otherwise, the vehicle will not work. (See Diagram #5)
2. Push the ON/OFF switch to the “ON” position of the vehicle. (See Diagram #6)
RIGHT
ANTENNA
TUBE
FORWARD
LEFT
BACKWARD
BACKWARD
FORWARD
CABLE
OFF
ON
ON/OFF
switch
DRIVING CONTROL
STICK
(DIAGRAM 5)
DRIVING CONTROL
STICK
(DIAGRAM 11)
(DIAGRAM 6)
(DIAGRAM 12)
STOP OPERATION
9. Release both Driving Control Sticks, the vehicle will Stop. (See Diagram #13)
FORWARD RUNNING
3. Push both the Driving Control Sticks forward for forward running. (See Diagram #7)
STOP
REVERSE RUNNING
4. Pull both the Driving Control Sticks backward for reverse running. (See Diagram #8)
FORWARD
FORWARD
FORWARD
BACKWARD
BACKWARD
(DIAGRAM 13)
DRIVING CONTROL
STICK
REVERSE
DRIVING CONTROL
STICK
(DIAGRAM 7)
(DIAGRAM 8)
STEERING OPERATION
5. Push only the Left Driving Control Stick forward to turn Right. (See Diagram #9)
6. Push only the Right Driving Control Stick forward to turn Left. (See Diagram #10)
RIGHT
FORWARD
LEFT
FORWARD
DRIVING CONTROL
STICK
(DIAGRAM 9)
DRIVING CONTROL
STICK
(DIAGRAM 10)
PERFORMANCE TIPS FOR VEHICLE
• Do not drive car through water.
• Be sure to rest your vehicle for at least 30 minutes after every 15 minutes of operation.
• Make sure OFF/ON switch on your vehicle is in the “OFF” position when it is not in use.
• Do not bend the antenna.
• Electrical, CB interference, mobile phones, air conditioning, elevators and steel girders in buildings will affect the operation
of your vehicle.
• Do not leave the vehicle or transmitter near sources of heat or in direct sunlight for long periods of time.
• Remove the batteries from the vehicle and transmitter when they are not in use.
• Do not drive car into people or animals.
• Do not attempt to sit or ride on product. Serious injury can result.
BATTERY CAUTIONS
1. For maximum performance, use alkaline batteries
2. Do not mix old and new batteries
3. Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries
4. Do not recharge non-rechargeable battery
5. Ensure batteries are inserted with the correct polarity
6. Remove batteries when toy is not in use
7. Remove exhausted batteries from toy and dispose of in accordance wit the makers recommendation
8. Rechargeable batteries should only be charged under adult supervision
9. Remove rechargeable batteries from toy before charging
10. The supply terminals are not to be short-circuited
11. The antenna wires are not to be inserted into socket outlet.
12. Rechargeable battery pack is only to be charged by adult.
NOT SUITABLE FOR CHILDREN UNDER 3 YEARS OF AGE, DUE TO SMALL PARTS.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Page Count                      : 1
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:ad59ae7f-9b7a-11e2-940e-0011247ec63c
Producer                        : Acrobat Distiller 6.0.1 for Macintosh
Create Date                     : 2013:04:02 17:49:53+08:00
Modify Date                     : 2013:04:02 17:49:53+08:00
Creator Tool                    : Adobe Illustrator(R) 11
Document ID                     : uuid:ad5998c5-9b7a-11e2-940e-0011247ec63c
Format                          : application/pdf
Creator                         : HO Wong
Title                           : OI 5459.ai
Author                          : HO Wong

EXIF Metadata provided by EXIF.tools