Scientific Toys 5013-49TP 49.82-49.90 MHz WIRELESS REMOTE CONTROL TOY-TX User Manual OI 5474 WCC 1 10 CHALLENGER ai

Download:
Mirror Download [FCC.gov]
Document ID	1993891
Application ID	odoF0UsLogiF5YH1khfZjQ==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	115.22kB (1440252 bits)
Date Submitted	2013-06-18 00:00:00
Date Available	2013-06-18 00:00:00
Creation Date	2013-04-29 15:54:22
Producing Software	Acrobat Distiller 6.0.1 for Macintosh
Document Lastmod	2013-04-29 15:54:22
Document Title	OI 5474(WCC 1_10 CHALLENGER).ai
Document Creator	Adobe Illustrator(R) 11
Document Author:	HO Wong

O.I. NO. 5474 #5F60AC7
DODGE
CAUTION ELECTRIC TOY
Nc cccmmcId II cIIII IBIcIIIII
agciIszI aIIcIecIIIcpIcIucIsImcaItIcIs
IIIIIII Iic IIIIseIIctId IIIg handling and Item
IIIcIcIIcIchI'csI ocIt
CAUTION SUPERVISION
REUUIRED—ELECTRICTOY—
UNPLUG WHEN NOT IN USE.
INPUT 120VIIC,6UHZ, 10W
OUTPUT 12V DC, 0.35A
ATTENTION PARENTS:
IT IS RECOMMENDED THATTHISTOV AND
ALL ACCESSORIES BE PERIODICALLY
EXAMINED FOR POTENTIAL HAZARDS AND
THAT ANY POTENTIALLV HAZARDOUS PARTS
BE REPAIRED OR REPLACED.
OPERATING INSTRUCTIONS:
DATTERV PACK CARE / CAUTIONS:
I ll battery pack and/or connectors are wet,
thoroughly dry betore charging.
2. Unplug the battery pack it it is not going to be
used tor several days
3. Do not charge battery pack that is hot, wet or
shows signs ot leakage or corrosion
4. Do not expose to tire, as explosion may result.
5. Do not disassemble the battery pack.
DATTERV INSTALLATION:
THE RECHARGEABLE Nl-MH EATTERV
PACK Is NOT CHARGED. PLEASE CHARGE
IT FOR 2 HOURS PRIOR To USE.
1. Plug the wall pack battery charger into wall
outlet. (See Diagram t)
2. Clickthe Danew pack into the charger Make
certain the battery pack is secure in charger.
3. To disconnect, push the button at the charger
(See Diagram 1) and simultaneously slide
battehy pack out.
4. Allow about 2 hours Iullschavge. The green
LED indicatorwIl be llashing continuously
when charging is in process.
5. The charging is complete when the green LED
indicator stops flashing and stays on. Then
unplug the charger and pull apart the battery
connectors.
s. Atter charging lorabout2 hours, the battery
wIII be warm. This condition is normal torlulIy
charged batteries.
7 II the speed ol the car slows down suddenly,
it istime to recharge.
a. Atter use, the battery pack WIII be IictI Wait
at least 20 minules until II OOOIS beIoTe
recharging. Recharging a warm or hot battery
pack wIII greatly shorten the battery Iile.
BATTERV
CHARGER
WALL OUTLET
PRESS BUTTON
0N SIDE OF
CHARGER TO
RELEASE
9 6V NIsMH
BATTERY BATTERV PACK
PACK
(DIAGRAM t)
UNSCREW To OPEN
THE BATTERY COVER
onioii
switch
ON/OFF
(DIAGRAM 2)
VEHICLE:
A. Turn over the vehicle and push the ON/OFF
to "OFF" position. (See Diagram 2)
B. Open the battery cover. (See Diagram 3)
c Insertthe 9 av NIsMH battery pack into battery
compartment (See Diagram 3)
D Replace the battery cover
BATTERY
COVER
9 5V Ni-MH
BATTERY PACK (DIAGRAM 3)
TRANSMITTER:
A. Unscrew the battery cover at the bottom at the
transmitter and place 2 x “AA batteries inside
tollowing the engraved signs (See Diagram 4).
B. Replace the battery cover.
e 6-) 2x’AA'
@ e BATTERIES
Q'W
a )9
3 9°
/\.‘ UNscREWTD
oPENTHE
BATTERY cot/ER
(DIAGRAM A)
VEHICLE OPERATION:
A Push the ON/OFF switch to the “ON"
position ol the vehicle. (See Diagram 2)
FORWARD RUNNING
(TURBO POWER BOOST)
E Pull the trigger backward Ior Iorward
running. (See Diagram 5)
C Pull the trigger to halt way lot normal
speed. (See Diagram 5)
D Pull the trigger to tuII extension Icr turbo
speed. (See Diagram 7) Release the
trigger haII way to resume normal speed.
FORWARD
PULL THE
TRIGGER
(DIAGRAM 5)
(DIAGRAM 7)
DRIVING IN REVERSE:
E. Push the trigger ol the transmitter Iorward
(away Irom you). (See Diagram 3)
PUSH THE I
TRIGGER
(DIAGRAM I) REV’ERSE
FRONT WHEELS STEERING
ADJUSTMENT:
F It the vehicle does not run straight torward,
ad)ust the lever Ior satistactory alignment on
the understde ol the vehicle
(See Diagram 9)
G II the vehicle runs toward Ielt, turn Steering
Alignment Lever towards "R"
H II the vehicle runs toward right, turn Steering
Alignment Lever towards "L“
(ega‘t
STEERING
ALIGNMENT
I g j LEVER
(DIAGRAM 9)
STEERING OPERATION:
I To make lelt or rightshand turns while driving
Ionuavd, turn the steering wheel to lelt or right
while pulIing the trigger ot the transmitter back
(towards you) (See Diagram to)
J To make lelt or rightshand turns while driving in
reverse turn the steering wheel to lelt or right
while pushing the trigger ot the transmitter
lorward (away Irom you) (See Diagram tt)
STEERING
WHEEL
(DIAGRAM to)
STEERING
WHEEL
(DIAGRAM tt)
STOP OPERATION:
K. Release the trigger to stop. (See Diagram t2)
STOP
PERFORMANCE TIPS FOR VEHICLE
- Do not drive car on grass, sand or carpet
- Do not drive car through water.
- Be sure to rest your vehicle tor at least so minutes atter
every I5 minutes ot operation
- Make sure ON/OFF switch on your vehicle is in the ‘OFF‘
position when it is not in use
- Do not bend the antenna.
- Electrical, CB interterence, mODIIe phones, air conditioning,
elevators and steel girders in buildings WIII attect the
operation ot your vehicle
- Do not leave the vehicle thmnsmmev near sources ot
heat or In direct sunlight tor long periods DI time
- Remove the battenes trom the vehicle and transmitter
when they are not in Use
CAUTION-ELECTRIC Tow
wot recommended Ior children under is years oi nae.
A: with xlI oiactnc products. Dncimlnns shDuId is.
observed dunng handling and usero prevent
eieetnc shocic
:AuTlciM SUPERVISION REQUIREDVELECTRIC
Tov-UNPLUG WHEN NOT IN usE.
input: am! An. saHL tow
OUTPUT. tzy pc. «.st
This deince complies vinth Part I5 or he FCC Rules
Operation is sup)ect to the tclIowng two conditions
(I) this device may not cause harmrul interterence, and
(2) his device must accept any intenerenoe received,
including intenerence that may cause undesired Dpemtlorl
Wamlng changes or modncattons to this unit not etpressly
approved by the party responsible tor compliance oouId void
the users authority to operate the equlpmem
NOTE The aqulpmem has been tested andtound to comply
with the lime tor a Class B digital dewoe. pursuant to
Pan I5 ol the FCC Rules These limits are designed to
pdee reasortapie protection against hanntui intenerenoe
in a residential installaton This equipment generates, uses
and can radiate radio heouency energy and. it not INSIleed
and used in aDwIdaerE with the instructions, may cause
hanntul intenerenoe to radio ccmmuhieatiors
However, there is no guarantee that inrenerence thI not occur
in a partcular installation. II this equipment does uuse harmrul
intenerence to radio or television reception, which can be
detenntned cytumihg the equipment on and oh, the user is
encouraged to try to concctthe intenerence by one or more
oi the roIIowing measures.
- Reonent or relocate the receiving antenna
. increase the separation between the equlpmem
and receiver
- Connect the equipment into an otittet on a orcuit ditterent
trom that to which the receiver is oohneded
. consuitdte dealerorah expenertoed radio/Tytechniean
tor help
IMPORTANT
It you experience any problems or issues with this item do
not take it back to the store where you purchased PIease
email sewlce®sclemlhc corn hk and we will be happy to
assist you in resolving any issues you may have We
thank you tor your purchase
CUNFIIRMS T0 TIIE SAFETY
REDUIREMENTS 0F ASTM F953.
CAUTION:
Remove aII lags, TWISHIES and
mash: Ioups before gtytngtny
Ip cIIIId
INPUT 120VAC,BDHZ, TOW
DUTPUT‘ 12V D 35A
tmtrnt in plus my
[Ll nnt mi um and hey. [ml
was Is A MARK 0F IEST UIIE ARUUE DE
ESUNAMARCA IG occhEcttcASUss ARVOF
(UNEFILIALEDE IIA UBSIDIARIADEITOVS‘R'US, III
DTEGEUFFR
IIADEIII (.HINAIFABRIGUEE EII CHINEI‘FABRICADO EN
CHII‘IAI
DISTRIBUTED III THE UNITED STATES EVIDISTRIDUE'E
AUXETATS- Ultlp PAR DISTAIBUIDD EII LOS ESTADDS
UNIDOSPCIRI
TU\>‘R‘US~ I
IMPORTED at (WIPDPtTE PAR
Tots R us ICAIIADAI LTD ILTEEI.
2 LANGSTAFFRDAD.COIICORD,0 L4,
DISTRIBUTED IN AUSTRALIA BI IDIo‘TRIBUEE EII
AUSTRALIE PAR
DISTRIBLIIDD EII AUSTRALIA POR‘I Toys R us
(AUSTRALIA IAUoTRA EII PW LTD.i,LTEEI REGENTS
PARK Ilsw 2w
www.toysitrs.oarn

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Page Count                      : 1
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:061f6d88-b0a2-11e2-b392-0011247ec63c
Producer                        : Acrobat Distiller 6.0.1 for Macintosh
Modify Date                     : 2013:04:29 15:54:22+08:00
Creator Tool                    : Adobe Illustrator(R) 11
Create Date                     : 2013:04:29 15:54:22+08:00
Document ID                     : uuid:061f59cc-b0a2-11e2-b392-0011247ec63c
Format                          : application/pdf
Creator                         : HO Wong
Title                           : OI 5474(WCC 1_10 CHALLENGER).ai
Author                          : HO Wong

EXIF Metadata provided by EXIF.tools