Seal Shield STM042WR Wireless Dongle User Manual STM042

user manual

STM042 USER MANUAL

1. Plug the base charger USB cable to the computer USB port, the LED red.

2. The nano receiver plug USB port on the base.

3. Power on switch bottom of mouse, the bottom LED red.

4. Press the mouse bottom opposite code switch “Connect”, comunication with receiver is OK.

5. If mouse power is deplenished, please take the mouse into the base, keep touch the pin of the

charger base, then the mouse is begin charging .

Warring: User Don’t look the mouse bottom LED directly.

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause

undesired operation

NOTE: This equipment has been tested and found to comply with the limits for a C lass B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause ha rmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.