Secure Wireless 915SRN DEVICE CONTROLLER User Manual 234731X5 indd

Secure Wireless, Inc DEVICE CONTROLLER 234731X5 indd

User Manual

Product DescriptionThe AT&T model number SW-ATT-SRN is a proprietary 915MHz wireless siren that is capable of annunciating alarms and keypad chirps. The DLC sends messages to the SW-ATT-SRN via a proprietary 915MHz radio protocol to command the SW-ATT-SRN to generate tones and pre-programmed alarm sequences through its annunciator, including a temporal 3 - alarm (three short beeps then silence repeating) when a smoke alarm is activated and a temporal 4 alarm (four short beeps then silence repeating) when the CO alarm is activated. In addition the siren beeps during an intrusion alarm.Installing/Replacing BatteriesThe siren has two (2) non-rechargeable 3V CR123A batteries that provide twenty-four (24) hour battery backup. The batteries can be replaced by opening the battery compartment located on the rear of the unit.Installing the SirenFollow these steps to install the Siren: 1. Turn the Siren to its underside and remove the Phillips Head screw at the bottom to open battery compartment cover. 2. Remove the battery compartment cover.3. Insert two (2) non-rechargeable CR123A batteries.4. NOTE: Ensure that polarity of the batteries is correct during installation5. Replace the battery compartment cover and the Phillips head screw.6. Plug the unit into the lower socket of an AC outlet and install a retaining screw into the plastic tab located at the top of the unit to secure the unit to the AC outlet.The LED shows the system status, as follows: Solid Green—unit is AC powered and backup battery is good. Blinking Green—unit is not AC powered and is operating on backup batteries. Solid Red—unit is AC powered and the backup battery needs to be replaced. Off—unit is not AC powered and backup battery has failed.Discovering and Registering the SirenFollow these steps to discover and register the siren:1. Place the DLC into Discovery Mode in DLD.2. Plug in the siren and once it has powered make it discoverable by pressing the small white learn button located on the side of the unit.3. Confi rm that the siren has been discovered in DLD.4. Label the siren in DLD.This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.• Reorient or relocate the receiving antenna• Increase the separation between the equipment and receiver• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected• Consult the dealer or an experienced radio/TV technician for help.Any changes or modifi cations not expressly approved by the party responsible for compliance could void the user’sauthority to operate the equipment.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. Ľexploitation est autorisée aux deux conditions suivantes: (1) ľappareil ne doit pas produire de brouillage, et (2) ľutilisateur de ľappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible ďen compromettre le fonctionnement.FCC Compliance StatementThis device complies with FCC Rules and Regulations as Part 15 devices as well as Industry Canada license exempt RSS Rules and Regulations. Operation is subject to the following two (2) conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.WARNING!WARNING!The polarity of the battery must be observed. Improper handling The polarity of the battery must be observed. Improper handling of lithium batteries may result in heat generation, explosion or fi re of lithium batteries may result in heat generation, explosion or fi re which may lead to personal injuries. Replace only with the same which may lead to personal injuries. Replace only with the same as recommended by the manufacturer. Use of another battery may as recommended by the manufacturer. Use of another battery may present a risk of fi represent a risk of fi reor corrosion.or corrosion.CAUTION!Batteries should not be recharged, disassembled, in heatabove 100° C (212°F) or disposed of in fi re.Disposal of used batteries must be made in accordance with the waste recovery and recycling regulations in your area.Notice to users in California—This Perchlorate warning applies only to Manganese Dioxide Lithium cells sold ordistributed only in California, USA. Percolate Material Special handling may apply.See www.dtsc.ca.gov.hazardouswaste/perchlorate.Copyright © 2013 Linear LLC. 234731X5LISTEDSW-ATT-SRN RTL 41806 Installation Instructions

Navigation menu