Secure Wireless EV-F433 Wireless Remote Control Transmitter User Manual 6658 SW Evol Manual
Secure Wireless, Inc Wireless Remote Control Transmitter 6658 SW Evol Manual
USer Manual
WARRANTY
Secure Wireless offers a Lifetime Warranty on this
product. Secure Wireless agrees to repair or replace this
product at no cost to the user.
For return authorization please contact:
Secure Wireless
1185 Park Center Drive, Suite A/B
Vista, CA 92083
866-966-9473
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
4 Button Wireless Transmitter
For use with Part #s: EV-F319/EV- F345/EV-F433
USER MANUAL
Button 1 Button 2
6658-SW-Evol Manual 10/2/02 9:10 PM Page 1
Caution: Any changes or modifications not expressly
approved by Secure Wireless could void user's authority
to operate the equipment.
I . Programming the Remote
into the Alarm System
Refer to the programming guide that came with your
alarm system for programming a wireless device
(KEYFOB) into the security system.
II. Changing Panic Operation
to Delay Mode or Instant Mode
Note: To use this feature you must have programmed
button 4 into the alarm panel as “PANIC”.
SETTING PANIC BUTTON INTO
INSTANCE TRANSMISSION MODE
1. Press all 4 button at the same time until the
LED begins to flash. (This will take
approximately 3 seconds before LED flashes.)
2. Release all 4 buttons
3. Press Button 1 (TOP LEFT BUTTON)
4. LED should stop flashing
SETTING PANIC BUTTON FOR
DELAY TRANSMISSION MODE
(You must hold down panic for 3 seconds
before transmission is sent)
1. Press all 4 button at the same time until the LED
begins to flash. (This will take approximately
3 seconds before LED flashes.)
2. Release all 4 buttons
3. Press Button 2 (TOP RIGHT BUTTON)
4. LED should stop flashing
6658-SW-Evol Manual 10/2/02 9:10 PM Page 2