Secure Wireless EV-F433W 4 Buttons Recessed Door/Window Sensor operates in User Manual SW Manual
Secure Wireless, Inc 4 Buttons Recessed Door/Window Sensor operates in SW Manual
User manual
Rev. A ZoneControl EV-F433W, Wireless Wallfob Congratulations, you have purchased a ZoneControl compatible, model EV-F433W wallfob. The EV-F433W is designed as an upgraded remote which can be easily mounted inside your home for easy control of your landscape lighting. Installation is as easy as learning the remote to your Zonecontrol and mounting it in a convenentely located spot in your house. WallFob Installation Included in the Box STEP 1 Remove the product from the box and stand within close proximity to the Zonecontrol. 10 ft. or less is recommended. STEP12 Using the small magnet supplied with the ZoneControl Swipe Reed #1 (see diagram) STEP 3 Receiver should beep slowly. Press any button on the ZoneCTRL-WallTX until you hear a loud beep. STEP 4 Unit is now programmed for manual activation of your ZoneControl system. STEP 5 Determine the desired convenient location to mount the WallFob. STEP 6 Utilize the included 3M doublesided to mount the Wallfob in the desired location. Picture of Zonecontrol Unit with Reed callouts Misc. Notes ZoneCTRL-WallTX has tactile feedback. When any button on the Wallfob is pressed a "click" can be felt. The tactile feedback coupled with the visual LED gives absolute confirmation that the signal was sent. Long-life Lithium Batteries are included in the Wallfob. The CR2025 long-life batteries should last 7-10 years under normal conditions. The LED will blink rapidly when a button is pressed if running low. Simply remove the cover and replace the battery. FCC Compliance Statement: Limited Manufacturers Warranty Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. ABT (Advanced Bridging Technologies) offers a limited 1 year warranty from date of purchase that this product is free from defects in material, workmanship, and conforms to This equipment has been tested and found to comply with the limits for a Class B digital its specifications. This warranty does not apply to damage caused by: (a) accident, abuse, device, pursuant to part 15 of the FCC Rules. These limits are designed to provide misuse, misapplication, ordinary wear, improper maintenance, failure to follow reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and instructions or products not manufactured by or for ABT. used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: — Reorient or relocate the receiving antenna. — Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help If there is a defect in materials, workmanship, or a problem with the product during the warranty period, ABT will at its sole discretion replace the product. The maximum liability for ABT under all circumstances for any warranty issue shall be limited to a replacement of the defective product. It is recommended that the customer check their equipment on a regular basis for proper functionality. Please contact ABT at 888-869-4737 for all communications regarding this warranty. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Page Count : 1 Producer : GPL Ghostscript 8.15 Create Date : 2008:02:27 11:26:52 Modify Date : 2008:02:27 11:26:52 Title : SW_Manual.xls Creator : PScript5.dll Version 5.2.2 Author : jstoneEXIF Metadata provided by EXIF.tools